Vector 167662 R0700A User Manual

Model No. 831.488540

User's Manual

Setup

1. Firmly press the thumb tab and pivot the

upright up until it locks in a nearly verti-
cal position.

Hand

2. Insert the handles into the stem until the

lock pins are visible in the holes in the
stern.

3. Open the quick-release lever. Depress the
lock pin on the stem and slide the stem

up until the lock pin is visible in one of

the three holes in the upright. When the
stem is at the desired height, close the
quick-release lever so that it is snug

against the upright. If the quick-release is

not snug, see ADJUSTING THE
QUICK-_SE on the back of this

user's manual.

Before using the scooter, make sure that
the scooter is set up as described and that

all parts are securely tightened.

The decal shown at the right has been -
placed on the scooter. If the decal is miss-

ing, or if it is not legible, please call our
Customer Service Department toll-free at

1-800-999-3756, Monday through Friday,
6 a.m. until 6 p.m. Mountain Time, to

order a free replacement decal. Apply the
replacement decal to the location shown.

To prevent
serious Injury:

•Read, understand

and follow all war-

nlngs and Instruc-

tions on the unit
and in the manual,

•Always wear pro-
tecllve equipment
Including helmet,
kneapads, wrlst

guards, and elbow
pads.

•Keep away from
cars, streets or
areas that enter

vehicle traffic
mutes.

•Never ride when
towed behind bi-

cycles, motorcy-
cles, or vehicles

•Do not ride at
night or In poor

visibility

Right Side

Storage

1. Openthequick-release lever. Depress the

lock pin on the stem and slide the stem

down into the upright. Close the quick-
release lever.

2 Depress the lock pins and remove the

handles from the stem. Press the handles
into the storage clip on the upright.

3 Pull the thumb tab and pivot the upright

down until it locks in the horizontal posi-
tion.

Hand Brake, Carry Strap, and Cable not shown.