Vecow SE-1000 Series, SE-1014, SE-1004 User Manual

SE-1000

PCI Express x1/4-channel Gigabit LAN, IEEE 802.3at Compliant

Intel® I210 PoE+/LAN Bypass Expansion Card

USER

USER

Manual

Manual

1.0.0 Edition 20180907

Record of Revision

Version Date Page Description Remark

0.1 08/31/2018 All Preliminary Release

1.0 09/19/2018 All O󰀩cial Release

©Vecow SE-1000 User Manual

i

Disclaimer

This manual is released by Vecow Co., Ltd. for reference purpose only. All
product o󰀨erings and specications are subject to change without prior notice.
It does not represent commitment of Vecow Co., Ltd. Vecow shall not be liable
for direct, indirect, special, incidental, or consequential damages arising out of
the use of the product or documentation or any infringements upon the rights of
third parties, which may result from such use.

Declaration of Conformity

FCC

CE

This equipment has been tested and found to comply with the limits for a Class
A digital device, pursuant to part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference when the
equipment is operated in a commercial environment. This equipment generates,
uses, and can radiate radio frequency energy, and if it is not installed and used
in accordance with the instruction manual, it may cause harmful interference to
radio communications. Operation of this equipment in a residential area is likely
to cause harmful interference in which case the user will be required to correct
the interference at his own expense.

The products described in this manual complies with all applicable European
Union (CE) directives if it has a CE marking. For computer systems to
remain CE compliant, only CE-compliant parts may be used. Maintaining CE
compliance also requires proper cable and cabling techniques.

Copyright and Trademarks

This document contains proprietary information protected by copyright. No part
of this publication may be reproduced in any form or by any means, electric,
photocopying, recording or otherwise, without prior written authorization
by Vecow Co., Ltd. The rights of all the brand names, product names, and
trademarks belong to their respective owners.

©Vecow SE-1000 User Manual

ii

Part Number Description

SE-1004 Intel® I210 4-Channel PCI Express LAN Switch Card with PoE

SE-1014 Intel® I210 4-Channel PCI Express LAN Switch Card with advanced

LAN Bypass

+

©Vecow SE-1000 User Manual

iii

Table of Contents

CHAPTER 1 GENERAL INTRODUCTION 1

1.1 Overview 1

1.2 Features 1

1.3 Product Specication 2

1.3.1 Specications of Vecow SE-1004 2

1.3.2 Specications of Vecow SE-1014 3

1.4 Mechanical Dimension 4

1.4.1 SE-1004 4

1.4.2 SE-1014 4

CHAPTER 2 GETTING TO KNOW YOUR SE-1000 5

2.1 Packing List 5

2.2 SE-1004 I/O and Indication 6

2.3 SE-1014 I/O and Indication 10

CHAPTER 3 GETTING START 13

3.1 Installing SE-1000 13

APPENDIX A : PoE Guide (SE-1004) 15

©Vecow SE-1000 User Manual

iv

1

GENERAL INTRODUCTION

1.1 Overview

SE-1000 is a series 4-channel Gigabit Ethernet (GigE) PCIe expansion card
supporting 4-port Gigabit IEEE 802.3at PoE+, or dual LAN Bypass mode.
Powered by Intel® Ethernet Controller I210, 4-port Gigabit LAN Switch/IEEE

802.3at PoE+, hardware LAN bypass mode, IEEE 802.3az Energy Efficient
Ethernet (EEE) and DMA Coalescing (DMAC) Power Management functions, up
to 1000Mbps data rate each port with teaming functions, link aggregation (LAG),

9.7K Jumbo Frame, IEEE 1588 Precision Time Protocol (PTP), IEEE 802.3AS,
Industrial-grade -40°C to 85°C Operating Temperature and easy maintenance,
Vecow SE-1000 series expansion card is your flexible solution for Intelligent
Surveillance, In-Vehicle Management, ITS (Intelligent Transportation System),
Industrial Ethernet, Mobile DVR/NVR or any industrial-grade networking
applications.

1.2 Features

• Intel® Ethernet Controller I210 supports full-featured LAN functions, up to
1000Mbps data rate

• All-in-one, fully-integrated single-chip GigE switching solution with lower
power consumption

• Industrial-grade, -40°C to 85°C Operating Temperature

• PCI Express x1 Interface

• IEEE 802.3at Power over Ethernet (PoE+) compliant

• Supports hardware LAN Bypass mode

• IEEE 1588 Precision Time Protocal (PTP) & IEEE 802.1AS Precision Time
Synchronization compliant

• IEEE 802.3az Energy Efficient Ethernet (EEE) compliant

• IEEE 802.1Qav traffic shaper compliant

• Up to 9728 bytes Jumbo Frame

• Link Aggregation (LAG)

©Vecow SE-1000 User Manual

GENERAL INTRODUCTION

1

1.3 Product Specication

1.3.1 Specications of Vecow SE-1004

Ethernet

Interface PCI Express x1

Chipset 1 Intel® Ethernet Controller I210

Data Rate 10/100/1000 Mbps

Jumbo Frame Up to 9728 byte

Link Aggregation (LAG) Present

Connector 8-pin RJ45

PoE Standard IEEE 802.3at compliant

Power Requirements

Output • 4 RJ45 PoE Port

• Up to 25.5W Power Output at 48V DC per port

Power Connector 1 4-pin ATX 12V Power Connector

Environment

Operating Temperature -40°C to 85°C (-40°F to 185°F)

Storage Temperature -40°C to 85°C (-40°F to 185°F)

EMC CE, FCC

Mechanical

Dimension 168mm x 121mm x 21mm (6.6" x 4.8" x 0.8")

©Vecow SE-1000 User Manual

GENERAL INTRODUCTION

2