Vecima Networks LMS3000 Users Guide

Warnings and Advisories

General Advisory

Operator and maintenance personnel must be familiar with the related safety requirements
before they attempt to install or operate the LMS3000 equipment.

It is the responsibility of the operator to ensure that the public is not exposed to excessive
Radio Frequency (RF) levels. The applicable regulations can be obtained from local
authorities.

Do not operate the LMS3000 CCU or EUM without connecting a 50-ohm termination to the
antenna port. This termination can be a 50-ohm antenna or a 50-ohm resistive load capable of
absorbing the full RF output power of the transceiver.

WARNING!

The CAP must be professionally installed. Antennas and
associated transmission cable must be installed by qualified
personnel. WaveRider assumes no liability for failure to adher e
to this recommendation or to recognized general safety
precautions.

WARNING!

To comply with FCC RF exposure limits, the outdoor antennas for the
LMS3000 CCU or EUM must be fix-mounted on outdoor permanent structures to
provide a separation distance of 2 metres or more from all
persons to satisfy RF exposure requirements. The distance is
measured from the front of the antenna and the human body. It
is recommended that the antenna be inst alled in a location with
minimal pathway disruption by nearby personnel.

WARNING!

There is a DC signal of 5-7.5V (current limited to 50 mA) on the
Antenna Output of the CCU3000 and the EUM3000. Antennas or
RF test equipment must be able to accept this DC signal or have
a device to block the DC signal. Otherwise, damage can be done
to the antenna, test equipment, and/or the CCU/EUM3000.

APCD-LM014-A 19