V Com DS755 User Manual



User sManual

Myvision Bluetooth speaker

Thanks:

Dear user,
Thank you for purchasing our Myvision products.

These operational guidelines for the user. to ensure you a quick and
convenient to use, read this instructions carefully before use.

Note:

* When charging, Only use the charger DC/ charging cable to charge the

Bluetooth speaker in the original packing box.

* Long time without using of speaker or battery has been exhausted, the

indicator will be delayed a few seconds to shine.
* The speaker require around three hours to full charge.
* Keep 5-10cm between speaker and mouth when calling.

Product description:

1. Support BT2.1+EDR and comply with its former version, 10 meters remote
control scope, wireless communication (consistent with the Bluetooth protocol
specifications CLASS)

2. Built-in lithium battery: 3.7-4 .2 V, can use USB to connect your computer to

charge, or a USB power supply of DC 5V, the charger light will turn red and

when charging is completed, the red light will disappear.

3. Bluetooth version: 2.1+EDR

4. Bluetooth protocol: Support A2DP and AVRCP profile.

5. Works with iPod, iPhone, Mobile phone, computer etc.

6. Mini design for easy portability

Operation instruction:

1. Slide the power key located under neath the speaker and hear

confirmation sound.

2. Open the Bluetooth device’s search function and find the device Connection

(connection code 0000 or no need any code). After entering the connection

code, you will hear another confirmation sound from the speaker.

3. Begin using your

4. If speaker supporting Mirco SD card/TF card, it is with prev and next song

function, you can swift bluetooth and card to enjoy your music.



Myvision Bluetooth Speaker.





FCC Statement



Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.

This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more of
the following measures:

-- Reorient or relocate the receiving antenna.

-- Increase the separation between the equipment and receiver.

-- Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.

-- Consult the dealer or an experienced radio/TV technician for help

This device complies with part 15 of the FCC rules. Operation is subject to the
following two conditions (1)this device may not cause harmful interference,
and (2) this device must accept any interference received, including
interference that may cause undesired operation

