VT-CC1110PA-470M
VT-CC1110PA-470M
VT-CC1110PA-470M
VT-CC1110PA-470M SoC
SoC
SoC
SoC Wireless
Wireless
Wireless
Wireless Module
Module
Module
Module
User
User
User
User Guide
Guide
Guide
Guide
V-CHIP MICROSYSTEMS Co. Ltd
Address: Room 612-613, Science and Technology Service Center Building,
NO.1, Qilin Road, Nanshan District, Shenzhen, Guangdong
TEL ： 0755-88844812
FAX ： 0755-22643680
E-mail ： sales@digirf.com
Post Code ： 518052
Web Site ： www.digiRF.com
COPYRIGHT @ 2012 Shenzhen V-CHIP MICROSYSTEMS Co. Ltd VERSION:
VT-CC1110-APR-2012
VT-CC1110PA-470M
VT-CC1110PA-470M
VT-CC1110PA-470M
VT-CC1110PA-470M
General
General
General
General Description
Description
Description
Description
VT-CC1110PA-470M is based on RF Transceiver CC1110 of TI Chipcon ， it’s a small size and ultra low power
UHF wireless module. CC1110 is a low cost true single chip UHF transmitter designed for very low power
wireless applications. The circuit is mainly intended for the ISM (Industrial, Scientific and Medical) and SRD
(Short Range Device) frequency bands at 315, 433, 868 and 915 MHz , The max RF output power can be set as
high as +10dBm, with data rate as high as 500Kbps. The module integrated
PA
to make the maximum output
power up to +20dBm. The integrated EEPROM on the module can be used to store important data. Customer can
use it conveniently and reducing your development time.
Features
Features
Features
Features
�
Central frequency is 470MHz,
Frequency bands
:470 ± 5MHz
� Programmable output power up to +20dBm for all supported frequencies ，
the communication distance is above 800m in sight .
� High receiver sensitivity down to -110dBm(at 2.4Kbps data rate)
� Programmable baseband modulator with GFSK/2-FSK/ASK/OOK/MSK
�
Programmable data rate 1.2 ～ 500Kbps
�
CRC computation and CRC check sum to keep data transmit reliable
�
Support carrier sense and digital RSSI output
� Integrated industrial 8051 MCU, support IAR.
� 32KB Flash, 4KB RAM, Optional integrated EEPROM(2~64KB)
� 7-12bit ADC with up to eight inputs, 128-bit AES security coprocessor, Powerful DMA functionality.
�
Two USARTs, I2S interface, 4 timers, 21 PGIO pins.
�
Low current consumption with receive mode <22mA, transmit mode at +20dBm output power <100mA
� Low current consumption at power down state <2uA
� Wake-on-radio functionality for automatic low-power RX polling
� Small dimension: 31.5mm × 27.0mm × 13.1 mm(SMA connector and header included)
� Operating supply voltage: 2.4 ～ 3.6V DC
Applications
Applications
Applications
Applications
�
Logistics Tracking System, Warehouse patrol, Electronic label.
� Replace RS232 and RS485 in data transmission
� Industrial monitoring and control in data acquisition
� AMR – Automatic Meter Reading
� Home and building automation
�
Consumer Electronics products of wireless control
�
Wireless alarm and security systems
COPYRIGHT @ 2012 Shenzhen V-CHIP MICROSYSTEMS Co. Ltd VERSION:
VT-CC1110-APR-2012
VT-CC1110PA-470M
VT-CC1110PA-470M
VT-CC1110PA-470M
VT-CC1110PA-470M
�
Wireless sensor networks
General
General
General
General Characteristics
Characteristics
Characteristics
Characteristics
Test operating conditions ： Ta=25 ° C ， VCC=3.3V if nothing else stated.
Parameter
Parameter
Parameter
Parameter Type
Type
Type
Type Condition/Note
Condition/Note
Condition/Note
Condition/Note
Operating supply voltage DC 2.4 ～ 3.6V
Central frequency 470MHz
Can be programmable to other frequency in bands
470 ± 5MHz
Frequency accuracy ± 10KHz
Modulation format
GFSK/2-FSK/ASK/OOK/M
SK
Programmable
Transmit power -10 ～ +20dBm Programmable
TX current consumption <110mA Po=20dBm
Receiver sensitivity -110dBm 2.4Kbps
RX current consumption <22mA 2.4Kbps
Sleep State current consumption <2uA Power Mode 3
Data rate 1.2 ～ 500Kbps Programmable
Spurious harmonics < -30dBm TX power +10dBm.
Communication distance >800m
2-FSK modulation, 2.4Kbps data rata, +20dBm
output power.
Antenna impedance 50ohm PCB antenna
Operating temperature -20 ～ +75 ° C
Storage temperature range -50 ～ +125 ° C
Dimension 31.5 mm × 27.0 mm × 13.1mm See more in PCB description
Note
Note
Note
Note ：
1 ． The module transmission data rate will affect Transmission distance ,the higher the data rate , the closer the
distance, and the lower the receiving sensitivity .
2 ． The supply voltage to the module will affect TX power, in the operating supply voltage range, the lower the
voltage, the lower the TX power.
3 ． The module central frequency will change as the operating temperature change, use it under suggest temperature,
the module can work well.
4 ． The antenna will strongly affect the communication distance, please select matched antenna and connect it
correctly.
5 ． The module mount will affect the communication distance.
Loading...