Page 1
Workman
User Guide
Vax Careline: AU: 1300 361 505
NZ: 0800 800 900
Get Cleaning...
What’s your Vax’s model number?
V C C
What’s your serial number?
Note these down in case you need them in future. Please keep instructions for further use.
vax.com.au VCC-05/VCC-07
–
0 5 / V C C
(Located on the base of the machine)
–
0 7
Page 2
Vax Service line: AU: 1300 361 505
NZ: 0800 800 900
vax.com.au
Page 3
vax.com.au
Machine Overview
VCC-05 & VCC-07
3
2
1
12
10
4
5
6
7
8
9
11
1 Hose inlet
2 Top cover retainer clip
3 Top cover
4 Carry handle
5 Power cord storage
6 Parking slot
16
17
7 Exhaust grill
8 On/o button
9 Wheel
10 360° rotating casters
11 Combination oor tool
12 Flexible hose
14
13
15
13 Extension tubes
14 Crevice tool
15 Dust brush
16 Paper dust bags
VCC-05 (x3) VCC-07 (x2)
17 Cloth dust bag (x1)
VCC-07 only
2
Page 4
General Safety Information
vax.com.au
FOR COMMERCIAL USE ONLY.
When using the vacuum cleaner, basic safety precautions should
always be observed, including the following:
1. This appliance is for dry use only and is not to be used or
stored outdoors or in wet conditions.
2. Turn off the vacuum cleaner controls before connecting to or
disconnecting from the mains supply.
3. Always unplug the vacuum cleaner before connecting or
disconnecting the vacuum hose.
4. This appliance is not intended for use by young or infirm
persons unless they have been adequately supervised by a
responsible person to ensure that they can use the appliance
safely. Young children should be supervised to ensure that they
do not play with the appliance.
5. Use only as described in this manual. Use only the
manufacturer’s recommended attachments. This appliance is
suitable for commercial use, for example in hotels, schools,
hospitals, factories, shops, offices and rental businesses.
6. Do not use the vacuum cleaner with a damaged cord or plug.
Do not use the vacuum cleaner if it has been dropped,
damaged, left outdoors or dropped into water. Return the
vacuum cleaner to a Vax Authorised Service Agent for
examination, repair or adjustment. Regularly examine the power
cord for damage, such as cracking or ageing. If damage is
found replace the cord before further use.
7. Do not pull or carry by the cord. Do not use the cord as a
handle, close a door on the cord or pull the cord around sharp
edges or corners. Do not run the vacuum cleaner over the cord.
Keep the cord away from heated surfaces.
8. Do not handle the plug or vacuum cleaner with wet hands.
Do not use outdoors or on wet surfaces.
9. Do not put any objects into openings. Do not use with any
openings blocked and do not restrict air flow. Keep all openings
free of dust, lint, hair or anything that may reduce airflow.
10. Keep hair, loose clothing, fingers and all parts of the body away
from openings and moving parts.
11. Do not pick up hot coals, cigarette butts, ash, matches or any
hot, smoking or burning objects.
12. Do not pick up flammable, hazardous dust or combustible
materials (lighter fluid, petrol, kerosene, etc) or use in the
presence of explosive liquids or vapours.
13. Do not vacuum up harmful or toxic material (chlorine bleach,
ammonia, drain cleaner, etc).
14. Do not vacuum up hard or sharp objects such as glass, nails,
screws, coins, etc.
15. Do not vacuum plaster dust, concrete dust or any other building
or vitreous materials.
16. Do not vacuum baking soda or any other powder-based carpet
refresher or deodoriser.
17. Do not use with blocked filters and without the filters in place.
18. Use extra care when vacuuming on stairs.
19. Keep vacuuming area well lit.
20. Store the vacuum cleaner indoors in a cool, dry area.
21. Turn off the switch before unplugging.
Motor Thermostat
IMPORTANT: The motor is equipped with a thermal cut-out.
If for any reason, the vacuum cleaner should over-heat, the
thermostat will automatically turn the unit off. Should this
occur, unplug the vacuum cleaner from the electrical outlet
and turn off the switch. Remove the dirt container and empty.
Clean the filters. Allow the cleaner to cool for approximately
one (1) hour before re-starting.
WARNING: Always switch off and unplug the vacuum cleaner
from the electrical outlet before assembling, opening or
emptying the dirt container, or before connecting/disconnecting
the attachments.
CAUTION: The vacuum cleaner is a very powerful unit.
Before plugging the cord into the outlet make sure the switch
is in the ‘off’ position. Hold the vacuum cleaner firmly when
starting.
IMPORTANT: If the inlet or hose is blocked, switch off the
vacuum cleaner and remove the blockage(s) before re-starting.
IMPORTANT: It is very important that filters are kept clean
to obtain maximum performance from your vacuum cleaner.
Not cleaning and not replacing your filters regularly can reduce
the suction power and cause overheating and permanent
damage to the vacuum cleaner.
This appliance is suitable for commercial use.
PLEASE KEEP THESE INSTRUCTIONS FOR FURTHER USE.
DAMAGE TO THE VACUUM CLEANER CAUSED AS
A DIRECT RESULT OF NOT ADHERING TO THE GENERAL
SAFETY INSTRUCTIONS IN THIS USER GUIDE INVALIDATES
THE WARRANTY.
3
Vax Service line: AU: 1300 361 505
NZ: 0800 800 900
Page 5
Operation
How to assemble
Insert the exible hose into
the inlet on the main body
of the vacuum cleaner.
Turn the hose clockwise
until it cannot be turned
any further.
Push the extension tube on
to the end of the handle.
The extension tubes can
be used together to
lengthen or shortened by
using one section of the
extension tube as required.
Fit the combination oor
head by pushing onto the
extension tube.
Accessories
The accessories can be attached directly to the handle by removing the extension tube and pushing in the
desired accessory.
The accessories can also be attached to the extension tube for extra reach. Remove the combination oor
head and push on the desired accessory.
Crevice Tool: for crevices, corners, cracks, sills, etc.
Dusting brush: for delicate surfaces.
vax.com.au 4
Page 6
vax.com.au
Operation
How to operate
Fully unwind the power cord.
On/O Button
Insert the power plug into the electrical outlet.
Ensure the vacuum cleaner is switched o. Press the
on/o button located at the rear of the machine to turn
on and press the button again to turn the vacuum
cleaner o.
Carry Handle
Cable Storage
Carpet Cleaning
For carpet and rug
cleaning press the rocker
switch on the combination
oor head to raise the
brushes.
Hose Storage
Hard Floor Cleaning
For hard oor cleaning,
press the rocker switch on
the combination oor head
to lower the brushes.
Use the carry handle
located on the top of the
machine to move the
vacuum cleaner from room
to room.
After use, turn the vacuum
cleaner o and unplug
from the electrical outlet.
Wrap the cord around the
cable storage hook for
moving the unit from room
to room or for storage.
5
For convenience there is a
parking slot located on the
side of the vacuum cleaner
where the oor tool and
hose can be parked for
carrying and storage.
Vax Service line: AU: 1300 361 505
NZ: 0800 800 900
Page 7
Maintenance
(Keep your Vax as good as new)
Dirt container removal and replacement
IMPORTANT: Always unplug the vacuum cleaner from the electrical outlet before removing the dust bag.
IMPORTANT: DO NOT use the vacuum cleaner without ALL of the lters in place.
Dust Bag Replacement
Turn o the vacuum cleaner and unplug it from the
mains. Remove the hose. Unclip the retainer clip on the
top of the unit and lift up to gain access to the dust
bag compartment.
Lift out the full dust bag
Dispose the full dust bag
and insert a new dust bag
into the vacuum cleaner.
Align the front of the dust
bag with the air entrance.
Pre-motor lter (Model VCC-05 only)
Turn o the vacuum cleaner and unplug it from the electrical outlet.
NOTE: The seal ring
around the dust bag
opening should cover the
air entrance connector
inside the housing.
Unclip the retainer clip on
the top of the vacuum
cleaner and lift up to gain
access to the dirt container
department.
The pre-motor lter is
found in the centre of the
dirt container. Rotate the
lter retaining disc
anti-clockwise to gain
access to the lter.
vax.com.au 6
The pre-motor lter can be
lifted out.
NOTE: Vax recommends
replacing the pre-motor
lter every 3-6 months
depending on the level of
use or when it becomes
discoloured.
Replace with a new lter
inside and turn the retaining
disc clockwise to secure.
Page 8
vax.com.au
Maintenance
(Keep your Vax as good as new)
HEPA Pre-motor filter (Model VCC-07 only)
Turn o the vacuum cleaner and unplug it from the electrical outlet.
Unclip the retainer clip on
the top of the vacuum
cleaner and lift up to gain
access to the dirt container
department.
The HEPA pre-motor lter
is found in the centre of
the dirt container.
Rotate the lter clockwise
to remove.
Gently tap the lter against
the side of the rubbish
bin to remove excess dirt.
The lter may then be
rinsed in cool water.
Allow to thoroughly air
dry before replacing.
Replace the lter every
3-6 months depending on
usage or when the lter
becomes discoloured.
NOTE: Do NOT use any
detergents or boiling water
to wash the lter.
Replace the HEPA lter
back in the machine
before use.
Ensure lter is thoroughly
dry before replacing after
washing.
Clearing blockages
WARNING: To reduce the risk of injury, the power cord must be disconnected before performing maintenance
or troubleshooting checks.
Turn vacuum cleaner o and disconnect the power plug
from the electrical outlet.
The exible hose can be disconnected from the vacuum
cleaner by rotating anti-clockwise and pulling away
from the machine. Remove any blockages found then
reconnect the hose.
7
Vax Service line: AU: 1300 361 505
NZ: 0800 800 900
Page 9
FAQ’s
WARNING: To reduce the risk of personal injury, unplug the vacuum cleaner before performing
maintenance/troubleshooting checks.
Problem Cause Solution
Cleaner won’t run
Cleaner won’t pick up/loss
of suction
Accessories won’t pick up Accessories are not attached correctly. Refer to page 4 for fitting information.
Dust escaping from the
vacuum cleaner
Not properly plugged into electrical outlet. Plug unit in firmly.
Vacuum cleaner not turned on. Press on/off button.
No electricity in the electrical outlet. Check fuse or breaker.
Blown fuse/tripped breaker. Reset circuit breaker or replace fuse.
Motor thermostat has tripped.
Dust bag not installed correctly. Review dust bag removal and replacement.
Dust bag full or blocked.
Clogged filter.
Blockage in hose.
Dust bag full.
Dust bag not installed correctly. Review dust bag removal and replacement.
Hose is not installed correctly. Review hose installation.
Filter not installed completely. Review filter removal and replacement.
Switch off and unplug the vacuum cleaner.
Leave for one (1) hour. See page 3.
Replace dust bag. Empty/clean/replace
cloth bag
Remove/replace with new filter VCC-05.
Remove wash/replace HEPA filter VCC-07.
Disconnect hose, remove the obstruction
then re-fit.
Dispose of paper dust bag, replace with a new
one or empty/clean/replace cloth bag.
vax.com.au 8
Page 10
vax.com.au
Other Information
Insulated
Use
Instructions
Vax Service & Help
Vax Careline:
Australia 1300 361 505
New Zealand 0800 800 900
Monday-Friday 8.30am to 5.00pm
If you have queries or concerns about using your Vax, call the Vax Careline. Calls are charged at the standard
local rate. Please make a note of the serial number and model number of the vacuum cleaner before calling.
For the nearest Service Agent, please call the Vax Customer Careline or visit vax.com.au
Technical Specication
Voltage: 220-240V ~50Hz
Wattage: VCC-05 1400W
VCC-07 1500W
Capacity: VCC-05 6L
VCC-07 8L
Filters: VCC-05 Pre-motor cloth
VCC-07 Pre-motor HEPA
Cord length: 12m
Weight: VCC-05 10.75kg
VCC-07 12.85kg
Noise Level: VCC-05 81dBA
VCC-07 84dBA
A-weighted sound pressure level L
Subject to technical change without notice.
N197
Double
Indoor
PA
Read
Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist.
Check with your Local Authority or retailer for recycling advice.
9
Vax Service line: AU: 1300 361 505
NZ: 0800 800 900
Page 11
vax.com.au
Notes
10
Page 12
Distributed by Techtronic Industries Australia Pty. Ltd.
Level 1, 660 Doncaster Road, Doncaster, Australia 3108.
www.vax.com.au Service Line: AU: 1300 361 505 / NZ: 0800 800 900
Loading...