vax.co.uk
Please read carefully before using this cleaner.
Always fully extend the mains cable before use.
Retain for future reference.
instruction manual
Carpet washer
Vax model number:
W91-RS-B Series
W90-RS-B Series
Vax Careline: (UK) 0844 412 8455
(ROI) 1-800 928 308
Version 1.3
W91-RS-B Series User Guide v1.3.qxd:User Guide 7/10/10 17:21 Page 1
2
parts overview
Fig.1/1
vax.co.uk
1. Diagram
1 Handle
2 Clean water tank release
3 Clean water tank
4 Dirty water tank lid
5 Wheels
6 Suction channel
7 Cord hooks
8 On/off switch
9 Handle release pedal
10 Vax Carpet Cleaning Solution
1
7
4
6
8
9
10
5
3
2
CLEANING
SOLUTION
7
W91-RS-B/W90-RS-B
W91-RS-B Series User Guide v1.3.qxd:User Guide 7/10/10 17:21 Page 2
3
safety information
2. Safety Information
FOR HOUSEHOLD USE ONLY.
When using the carpet washer, basic safety precautions
should always be observed, including the following:
1. Do not leave the carpet washer unattended when
plugged in. Unplug it from socket when not in use.
2. To prevent electric shock do not use outdoors.
3. Not to beused as a toy.Children should be supervisedto
ensure that they do not play with the appliance.
4. This appliance is not intended for use by persons
(including children) with reduced physical, sensory or
mental capabilities, or lack ofexperience and knowledge,
unless they have been given supervision or instruction
concerning the use of the appliance by a person
responsible for their safety.
5. Use only as described in this manual.
6. Do not use the carpet washer with a damaged cord or
plug. If the supply cord or plug is damaged, it must be
replaced by the manufacturer or a recommended
Service Agent to avoid hazard and invalidating the
guarantee.
7. Do not pull or carry by the cord, use the cord as a
handle, allow the cord to come into contact with hot
or sharp surfaces or close a door on the cord.
8. Do not unplug by pulling on the cord.
9. Do not handle the plug or carpet washer with wet
hands.
10. Do not put any objects into openings or operate with
openings blocked, keep them free of anything that
may reduce airflow.
11. Keep hair, loose clothing, fingers and all parts of the
body away from openings and moving parts.
12. Do not use the carpet washer on any glowing,
burning or smoking particles.
13. Do not use without the solution tank and dirty water
tank in place.
14. Turn off all controls before unplugging.
15. Do not use to pick up flammable or combustible
liquids such as petrol, or use in areas where they may
be present.
16. Keep the unit on the floor.
17. Do not use an extension cord.
18. Do not attempt to remove blockages with sharp
objects as they may cause damage.
19. Store indoors put away after use to prevent tripping
accidents.
20. Using improper voltage may result in damage to the
motor and possible injury to the user. The correct
voltage is listed on the rating label.
21. A hazard may occur if the carpet washer runs over
the power supply cord.
22. To prevent dirty water from running into motor, do
not hold the appliance upside-down or lay on its side.
Use appliance in normal vacuuming position.
23. Use extra care when cleaning on stairs.
24. Do not carry appliance while motor is running.
NOTE: Carpets should be dry vacuumed
thoroughly before washing.
NOTE: The unit must be unplugged from the
mains socket outlet after use, and before
cleaning or maintaining the unit.
IMPORTANT: This unit is not intended for
commercial use.
PLEASE KEEP THESE INSTRUCTIONS
FOR FURTHER USE.
!
Vax Careline: (UK) 0844 412 8455 (ROI) 1-800 928 308
!
!
W91-RS-B Series User Guide v1.3.qxd:User Guide 7/10/10 17:21 Page 3
vax.co.uk
4
assembly/ operation
3. Assembly
Putting your cleaner together
Insert middle frame to machine base (Fig 3/1).
Insert one screw on either side of middle frame to secure
(Fig 3/2).
Slide the upper handle down onto the unit. The handle
will click and lock in place. Run the mains wire above the
upper cord hook and secure with the cord clip (Fig 3/3).
Insert locking pins into either side of handle (Fig 3/4).
Screw locking pins into handle (Fig 3/5).
4. Operation
IMPORTANT: Turn off when emptying and filling
the tanks and performing any maintenance.
Grasp the solution reservoir under the handle and press
the handle release lever in (Fig 4/1).
Tilt the solution reservoir away from the cleaner and
remove (Fig 4/2).
Unscrew the cap from the back of the solution reservoir
(Fig 4/3).
Pour the correct amount of Vax Solution as directed on
the solution label into the clean water tank.
Fig.3/3
Fig.4/1
Fig.4/2
Fig.4/3
!
Fig.3/2
Fig.3/1
Fig.3/4 Fig.3/5
W91-RS-B Series User Guide v1.3.qxd:User Guide 7/10/10 17:21 Page 4
Loading...