Vax VZL-7022, VZL-7022P, VZL-7022HF, Mach2 VZL-7022, Mach2 VZL-7022P Instruction Manual

www.vax.co.uk

Please read carefully before using this cleaner.

Always fully extend the mains cable before use.

Retain for future reference.

Vax careline

0870 6061248

instruction manual

Bagless cylinder

Vax model number:

VZL-7022
VZL-7022P
VZL-7022HF

Vax VZL-7022(HF).qxd:Vax VZL-7022HF User Guide 10/4/08 14:49 Page 1

1. Diagram

www.vax.co.uk

2

parts overview

1

2

4

6

7

10

3

11

1 Hose inlet
2 Dirt container
3 Cyclone separator
4 Dirt container handle
5 Carry handle
6 Auto cord rewind
7 On/off button
8 Plug
9 Post-motor filter cover

10 Wheel

Accessories

11 2-in-1 tool
12 Crevice tool
13 Combination floor head
14 Telescopic tube
15 TurboTool

(VZL-7022P only)

16 TurboBrush (VZL-7022P only)

17 Hard Floor Tool

(VZL-7022HF only)

18 Hose

Fig.1/1

5

8

9

15

14

16

18

12

13

17

Vax VZL-7022(HF).qxd:Vax VZL-7022HF User Guide 10/4/08 14:49 Page 2

3

V

ax Careline 0870 606 1248

safety information

2. Safety Information

For Household Use Only

When using the vacuum cleaner, basic safety precautions
should always be observed, including the following:

1. Only use the vacuum cleaner indoors on dry
surfaces.

2. Turn off the vacuum cleaner controls before
connecting or disconnecting from the mains supply.

3. Always unplug the vacuum cleaner before
connecting or disconnecting the vacuum hose and
accessories.

4. Children should be supervised to ensure that they
do not play with the appliance.

5. This appliance is not intended for use by persons
(including children) with reduced physical, sensory or
mental capabilities, or lack of experience and
knowledge, unless they have been given supervision
or instruction concerning use of the appliance by a
person responsible for their safety.

6. Use only as described in this manual.
Use only the manufacturer’s recommended
attachments.

7. Do not use the vacuum cleaner if it has been
dropped, damaged, left outdoors or dropped into
water. Do not use the vacuum cleaner with a
damaged cord or plug. If the supply cord or plug is
damaged, return the vacuum cleaner to a Vax
Authorised Service Agent or suitably qualified
person for examination, repair or adjustment.

8. Do not pull or carry by the cord. Do not use the cord
as a handle, close a door on the cord or pull the cord
around sharp edges or corners. Do not run the
vacuum cleaner over the cord. Keep the cord away
from heated surfaces.

9. Do not handle the plug or vacuum cleaner with wet
hands. Do not use outdoors or on wet surfaces.

10. Do not put any objects into openings. Do not use
with any openings blocked and do not restrict air
flow. Keep all openings free of dust, lint, hair or
anything that may reduce airflow.

11. Keep hair, loose clothing, fingers and all parts of the
body away from openings and moving parts.

12. Do not pick up hot coals, cigarette butts, matches or
any hot, smoking or burning objects.

13. Do not pick up flammable or combustible materials
(lighter fluid, petrol, kerosene, etc) or use in the
presence of explosive liquids or vapours.

14. Do not vacuum up harmful or toxic material (chlorine
bleach, ammonia, drain cleaner, etc).

15. Do not vacuum up hard or sharp objects such as
glass, nails, screws, coins, etc.

16. Do not use without the filters in place.

17. Take extra care when vacuuming on stairs.

18. Keep vacuuming area well lit.

19. Store the vacuum cleaner indoors in a cool, dry area.

20. Turn off the on/off switch before unplugging the
vacuum cleaner.

21. Use only CE-approved 13 amp extension cords. Non­approved extension cords may overheat. Care should
be taken to arrange the cord so that the cord cannot
be pulled or tripped over.

WARNING: Always switch off and unplug the

vacuum cleaner from the electrical outlet
before assembling, opening or emptying the dirt
container, or before connecting/disconnecting the
attachments.

CAUTION: The vacuum cleaner is a very powerful

unit. Before plugging the cord into the electrical
outlet, make sure the switch is in the ‘off’ position. Hold
the vacuum cleaner firmly when starting and in use.

IMPORTANT: If the inlet, hose or telescopic tube is

blocked, switch off the vacuum cleaner and
remove the blockage(s) before re-starting the vacuum
cleaner.

IMPORTANT: Washing filters improves vacuum

performance. Make sure all the filters are
completely dry before inserting back into the vacuum
cleaner.

This vacuum cleaner is intended for household use only
and not for commercial or industrial use.

Motor Thermostat

IMPORTANT: The motor is equipped with a

thermal cut-out. If for any reason, the vacuum
cleaner should over-heat, the thermostat will
automatically turn the unit off. Should this occur,
unplug the vacuum cleaner from the electrical outlet
and turn off the switch. Remove the dirt container
and empty. Clean the filters. Allow the cleaner to cool
for approximately one (1) hour. To re-start, plug into
an electrical outlet and switch back on.

!!!!!

Vax VZL-7022(HF).qxd:Vax VZL-7022HF User Guide 10/4/08 14:49 Page 3

www.vax.co.uk

4

assembly / operation

3. How to Assemble

IMPORTANT: Always unplug the vacuum cleaner
from the electrical outlet before assembling or

removing the accessories.

1. Insert the flexible hose (Fig.3/1) into the inlet on the
main body of the vacuum cleaner. Making sure the
projected parts on the hose are aligned. Turn the
hose to the right until it clicks into lock position.

2. Push the telescopic extension tube on to the end of
the handle (Fig.3/2).

3. The telescopic tube can be lengthened or shortened
by pushing the button in and sliding the tube apart
or together as required (Fig.3/3).

4. Fit the combination floor head, TurboBrush

(Model:

VZL-7022Ponly)

or hard floor tool (Model: VZL-7022HF

only)

by pushing onto the extension tube (Fig.3/4).

4. How to Operate

Cord Release

Fully unwind the power cord. A yellow mark on the power
cord indicates the recommended cord length. Do not
exceed the cord length beyond the red mark.

On/off Button

1. Insert the plug into the electrical outlet.

2. Press the on/off switch located on the top of the
vacuum cleaner, to switch on the vacuum cleaner
and press the button again to turn the vacuum
cleaner off.

Carpet Cleaning

For carpet and rug cleaning, press the rocker switch on
the combination floor head to raise the brushes.

Model VZL-7022P only: Attach the TurboBrush to the end

of the extension tube. For large carpeted areas.

Hard Floor Cleaning

For hard floor cleaning, press the rocker switch on the
combination floor head to lower the brushes.

(Model: VZL-7022HF only) For hard floor cleaning use the

hard floor tool for vacuuming parquet and laminate
coverings.

Cord Rewind

To rewind the power cord, press the cord rewind button,
located on the top of the vacuum cleaner, and guide the
power cord with one hand. This will prevent the cord from
whipping which could cause damage or injury.

Carry Handle

Use the carry handle located at the rear end of the
vacuum cleaner to move from room to room.

Hose Storage

For convenience there is a parking slot located at the rear
of the vacuum cleaner where the floor tool and hose can
be parked for carrying and storage.

!

Fig.3/1

Fig.3/2

Fig.3/3

Fig.3/4

Vax VZL-7022(HF).qxd:Vax VZL-7022HF User Guide 10/4/08 14:49 Page 4