Vax VZL-6013A, VZL-6013AL, VZL-6013AA, VZL-6014, VZL-6014A Instruction Manual

www.vax.co.uk

Please read carefully before using this cleaner.

Always fully extend the mains cable before use.

Retain for future reference.

Vax careline

0870 6061248

instruction manual

Bagless upright

Vax model number:

VZL-6013
VZL-6013A
VZL-6013AL
VZL-6013AA
VZL-6014
VZL-6014A
VZL-6014AA

WARNING: This cleaner has a constantly

rotating brush bar which, when left in
contact with lino, parquet and other hard flooring
could potentially cause some damage to the floor
surface.

NOTE: Vax recommends that you raise the height
of the brush bar when using this cleaner on lino and
hard flooring. Vax cannot be held responsible for
damage to these surfaces if the customer fails to
take notice of this recommendation.

!

1. Diagram

www.vax.co.uk

2

parts overview

1 Handle Grip
2 On/off switch
3 Telescopic handle
4 Handle release button
5 Carrying handle
6 Dirt container release button
7 Dirt container assembly
8 Dirt container door hinge
9 Stair cleaning handle

(located below edge of dirt container)

10 Headlight
11 Carpet height adjuster

(located on back of dirt container)

12 Furniture guard
13 Hose handle

14 Combination tool
15 Powered hand tool
16 Hose
17 Hose/tool holder

18 Extension Tubes

19 Crevice tool
20 Quick release cord hooks
21 Handle release pedal
22 Hard Floor Brush

(Models: VZL-6014, VZL-6014A ,
VZL-6014AA only)

23 Additional stretch hose

(Models: VZL-6013AL, VZL-6014,
VZL-6014A, VZL-6014AA, only)

Fig.1/1

1

16

8

7

9

10

11

12

14

13

17

15

14

20

19

18

21

20

15

4

5

6

3

2

22

23

VZL-6013
VZL-6014

WARNING: This cleaner has

a constantly rotating brush
bar which, when left in contact
with lino, parquet and other hard
flooring could potentially cause
some damage to the floor surface.

NOTE: Vax recommends that you
raise the height of the brush bar
when using this cleaner on lino
and hard flooring. Vax cannot be
held responsible for damage to
these surfaces if the customer
fails to take notice of this
recommendation.

!

!

3

V

ax Careline 0870 606 1248

safety information

2. Safety Information

For Household Use Only

When using the vacuum cleaner, basic safety precautions
should always be observed, including the following:

1. Only use the vacuum cleaner indoors on dry
surfaces.

2. Turn off the vacuum cleaner controls before
connecting or disconnecting from the mains supply.

3. Always unplug the vacuum cleaner before
connecting or disconnecting the vacuum hose and
accessories.

4. This appliance is not intended for use by persons
(including children) with reduced physical, sensory or
mental capabilities, or lack of experience and
knowledge, unless they have been given supervision
or instruction concerning use of the appliance by a
person responsible for their safety. Children should
be supervised to ensure that they do not play with
the appliance.

5. Use only as described in this manual.
Use only the manufacturer’s recommended
attachments.

6. Do not use the vacuum cleaner if it has been
dropped, damaged, left outdoors or dropped into
water. Do not use the vacuum cleaner with a
damaged cord or plug. If the supply cord or plug is
damaged, return the vacuum cleaner to a Vax
Authorised Service Agent or suitably qualified
person for examination, repair or adjustment.

7. Do not pull or carry by the cord. Do not use the cord
as a handle, close a door on the cord or pull the cord
around sharp edges or corners. Do not run the
vacuum cleaner over the cord. Keep the cord away
from heated surfaces.

8. Do not handle the plug or vacuum cleaner with wet
hands. Do not use outdoors or on wet surfaces.

9. Do not put any objects into openings. Do not use
with any openings blocked and do not restrict air
flow. Keep all openings free of dust, lint, hair or
anything that may reduce airflow.

10. Keep hair, loose clothing, fingers and all parts of the
body away from openings and moving parts.

11. Do not pick up hot coals, cigarette butts, matches or
any hot, smoking or burning objects.

12. Do not pick up flammable or combustible materials
(lighter fluid, petrol, kerosene, etc) or use in the
presence of explosive liquids or vapours.

13. Do not vacuum up harmful or toxic material (chlorine
bleach, ammonia, drain cleaner, etc).

14. Do not vacuum up hard or sharp objects such as
glass, nails, screws, coins, etc.

15. Do not use without the filters in place.

16. Take extra care when vacuuming on stairs.

17. Keep vacuuming area well lit.

18. Store the vacuum cleaner indoors in a cool, dry area.

19. Turn off the on/off switch before unplugging the
vacuum cleaner.

20. Use only CE-approved 13 amp extension cords. Non­approved extension cords may overheat. Care should
be taken to arrange the cord so that the cord cannot
be pulled or tripped over.

WARNING: Always switch off and unplug the

vacuum cleaner from the electrical outlet
before assembling, opening or emptying the dirt
container, or before connecting/disconnecting the
attachments.

CAUTION: The vacuum cleaner is a very powerful

unit. Before plugging the cord into the electrical
outlet, make sure the switch is in the ‘off’ position. Hold
the vacuum cleaner firmly when starting and in use.

IMPORTANT: If the inlet, hose or extension tube is

blocked, switch off the vacuum cleaner and
remove the blockage(s) before re-starting the vacuum
cleaner.

IMPORTANT: Cleaning filters regularly improves

vacuum performance. Make sure all filters are
replaced back into the vacuum cleaner before using. This
vacuum cleaner is intended for household use only and
not for commercial or industrial use.

PLEASE KEEP THESE INSTRUCTIONS FOR
FURTHER USE.

!!!

!

Motor Thermostat

IMPORTANT: The motor is equipped with a

thermal cut-out. If for any reason, the vacuum
cleaner should over-heat, the thermostat will
automatically turn the unit off. Should this occur,
unplug the vacuum cleaner from the electrical outlet
and turn off the switch. Remove the dirt container
and empty. Clean the filters. Allow the cleaner to cool
for approximately one (1) hour. To re-start, plug into
an electrical outlet and switch back on.

!

www.vax.co.uk

4

assembly

3. How to assemble

Attach Handle

Grasp orange tie wrap and pull until the black plug comes
out of the handle cavity (Fig.3/1).

Hold plug with one hand; upper handle with the other
hand. Push plug into upper handle, aligning with opposite
end of plug and push firmly until you hear a snap or click
(Fig.3/2). After ends are connected, pull on plug to make
sure it is securely attached.

Align the groove on the back of the upper handle with
the small projection on the back of the handle housing.
Push upper handle down until you hear a click (Fig.3/3).

Press button at handle base and push handle all the way
down (Fig.3/4).

Adjusting Handle

For convenience in storing or carrying your cleaner, the
handle is designed to retract into the body of the cleaner.
Lower the handle by depressing the button located at the
handle base and pushing the handle down. Raise the
handle by depressing the button and pulling the handle
upward, locking it into the desired position (Fig.3/5).

Transporting Cleaner

To move your cleaner from room to room, put handle in
upright position, tilt cleaner back on rear wheels and push
forward (Fig.3/6).

Fig.3/1

Fig.3/2

Fig.3/3

Fig.3/4

Fig.3/5

Fig.3/6

5

V

ax Careline 0870 606 1248

operation

4. How to operate

Carrying Cleaner

The cleaner can also be moved by using the carrying
handle (Fig.4/1).

Handle Positions

The handle of your cleaner has three positions; upright
for storage and when using cleaning tools; operating
position for general operation on carpet and floors; low
for reaching under low furniture.

Step on handle release lever to lower handle (Fig.4/2).

Carpet Height Adjustment

The cleaning of carpet and rugs takes place at the nozzle
(A). When it is necessary to raise and lower the nozzle for
various carpet pile heights, place handle in upright
position and turn the carpet height adjuster (B) to the
desired setting (Fig.4/3).

NOTE: The nozzle will not move into the adjusted
position until the cleaner handle is lowered to the
operating position.

Settings

For maximum cleaning performance, the following carpet
height settings are recommended:

• Lowest setting: for all types of carpet.

NOTE: If the cleaner is difficult to push, turn knob to
the next higher setting.

• Higher settings: for very deep pile carpet, where easier
pushing effort is desired, while maintaining good cleaning
performance.

Cleaning Lightweight Flexible Rugs

Stand on one end of rug and move cleaner toward other
end or edge. Before reaching edge, push down on handle.
This will lift up the nozzle (front of cleaner) as shown and
will prevent rug from clinging to cleaner (Fig.4/4).

Continue to lift up nozzle so that when you have reached
the edge, it is completely off the rug. Move cleaner back
to start again, lower nozzle, and use only forward strokes.

Stair Cleaning

A stair cleaning handle has been designed for ease in
using your cleaner on stairs. With handle in operating
position, place fingers under edge of stair cleaning
handle and guide cleaner with other hand on upper
handle (Fig.4/5).

Fig.4/1

Fig.4/2

Fig.4/3

A

B

Fig.4/4

WARNING: This cleaner has a constantly

rotating brush bar which, when left in contact
with lino, parquet and other hard flooring could
potentially cause some damage to the floor surface.

NOTE: Vax recommends that you raise the height of
the brush bar when using this cleaner on lino and hard
flooring. Vax cannot be held responsible for damage to
these surfaces if the customer fails to take notice of
this recommendation.

!