Vax VZL-6012, Mach2 VZL-6012 Instruction Manual
www.vax.co.uk
Please read carefully before using this cleaner.
Always fully extend the mains cable before use.
Retain for future reference.
Vax careline
0870 6061248
instruction manual
Bagless upright
Vax model number:
VZL-6012
WARNING: This cleaner has a constantly
rotating brush bar which, when left in
contact with lino, parquet and other hard flooring
could potentially cause some damage to the floor
surface.
NOTE: Vax recommends that you raise the height
of the brush bar when using this cleaner on lino and
hard flooring. Vax cannot be held responsible for
damage to these surfaces if the customer fails to
take notice of this recommendation.
!
1. Diagram
www.vax.co.uk
2
parts overview
1
1 Handle Grip
2 Handle/Extension Wand
3 Turbo Tool
4 Carry Handle
5 Foam Filter
(located behind dirt container)
6 Exhaust Hepa Filter
(located under dirt container)
7 Dirt Container Release Button
8 On/Off Switch
9 Dirt Container
10 Central Dust Chamber
11 Bin Release Empty Button
(located on back of dirt container)
12 Headlight
13 Carpet Height Adjuster
14 Bumper
15 Hose Guide
16 Upper Cord Wrap With Quick Cord
Release
17 Crevice Tool
18 Lower Cord Wrap
19 Handle Release Pedal
20 Wand Cap
21 Handle/Extension Wand Release
Button
22 Upper Hose
23 Dust Brush / Upholstery Tool
24 Power Cord
25 Lower Hose
26 Wheels
Fig.1/1
2
3
8
9
10
11
12
13
14
5
6
2
0
21
22
23
24
25
26
15
16
17
18
19
4
7
VZL-6012
WARNING: This cleaner has
a constantly rotating brush
bar which, when left in contact
with lino, parquet and other hard
flooring could potentially cause
some damage to the floor surface.
NOTE: Vax recommends that you
raise the height of the brush bar
when using this cleaner on lino
and hard flooring. Vax cannot be
held responsible for damage to
these surfaces if the customer
fails to take notice of this
recommendation.
!
3
V
ax Careline 0870 606 1248
safety information
2. Safety Information
For Household Use Only
When using the vacuum cleaner, basic safety precautions
should always be observed, including the following:
1. Only use the vacuum cleaner indoors on dry
surfaces.
2. Turn off the vacuum cleaner controls before
connecting or disconnecting from the mains supply.
3. Always unplug the vacuum cleaner before
connecting or disconnecting the vacuum hose and
accessories.
4. Close attention is necessary when used by or near
children. Do not allow children to use as
a toy.
5. Use only as described in this manual.
Use only the manufacturer’s recommended
attachments.
6. Do not use the vacuum cleaner if it has been
dropped, damaged, left outdoors or dropped into
water. Do not use the vacuum cleaner with a
damaged cord or plug. If the supply cord or plug is
damaged, return the vacuum cleaner to a Vax
Authorised Service Agent or suitably qualified
person for examination, repair or adjustment.
7. Do not pull or carry by the cord. Do not use the cord
as a handle, close a door on the cord or pull the cord
around sharp edges or corners. Do not run the
vacuum cleaner over the cord. Keep the cord away
from heated surfaces.
8. Do not handle the plug or vacuum cleaner with wet
hands. Do not use outdoors or on wet surfaces.
9. Do not put any objects into openings. Do not use
with any openings blocked and do not restrict air
flow. Keep all openings free of dust, lint, hair or
anything that may reduce airflow.
10. Keep hair, loose clothing, fingers and all parts of the
body away from openings and moving parts.
11. Do not pick up hot coals, cigarette butts, matches or
any hot, smoking or burning objects.
12. Do not pick up flammable or combustible materials
(lighter fluid, petrol, kerosene, etc) or use in the
presence of explosive liquids or vapours.
13. Do not vacuum up harmful or toxic material (chlorine
bleach, ammonia, drain cleaner, etc).
14. Do not vacuum up hard or sharp objects such as
glass, nails, screws, coins, etc.
15. Do not use without the filters in place.
16. Take extra care when vacuuming on stairs.
17. Keep vacuuming area well lit.
18. Store the vacuum cleaner indoors in a cool, dry area.
19. Turn off the on/off switch before unplugging the
vacuum cleaner.
20. Use only CE-approved 13 amp extension cords. Nonapproved extension cords may overheat. Care should
be taken to arrange the cord so that the cord cannot
be pulled or tripped over.
WARNING: Always switch off and unplug the
vacuum cleaner from the electrical outlet
before assembling, opening or emptying the dirt
container, or before connecting/disconnecting the
attachments.
CAUTION: The vacuum cleaner is a very powerful
unit. Before plugging the cord into the electrical
outlet, make sure the switch is in the ‘off’ position. Hold
the vacuum cleaner firmly when starting and in use.
IMPORTANT: If the inlet, hose or extension tube is
blocked, switch off the vacuum cleaner and
remove the blockage(s) before re-starting the vacuum
cleaner.
IMPORTANT: Cleaning filters regularly improves
vacuum performance. Make sure all filters are
replaced back into the vacuum cleaner before using. This
vacuum cleaner is intended for household use only and
not for commercial or industrial use.
PLEASE KEEP THESE INSTRUCTIONS FOR
FURTHER USE.
!!!
!
Motor Thermostat
IMPORTANT: The motor is equipped with a
thermal cut-out. If for any reason, the vacuum
cleaner should over-heat, the thermostat will
automatically turn the unit off. Should this occur,
unplug the vacuum cleaner from the electrical outlet
and turn off the switch. Remove the dirt container
and empty. Clean the filters. Allow the cleaner to cool
for approximately one (1) hour. To re-start, plug into
an electrical outlet and switch back on.
!
www.vax.co.uk
4
how to assemble / how to operate
3. How to assemble
Handle Assembly
Slide handle through top of
back panel until it snaps
into place.
Tool Storage
Attach tools: (a) Slide the dust brush into the hole on the
back of the cleaner with bristles facing out. (b) Slide the
crevice tool onto round post on the back of the cleaner
and snap into place (Fig.3/2). (c) Clip Turbo Tool onto the
front of the cleaner (Fig.3/2).
4. How to operate
Cord release
Turn Quick Cord Release for easy cord removal.
Carpet height adjuster
Turn the carpet height adjuster knob to match the
surface being cleaned.
IMPORTANT: For easiest adjustment, place
cleaner in full upright position.
On/Off Switch
Plug cord into electrical outlet. Turn cleaner on by
pressing the on/off switch located on the side of unit.
Handle Release Pedal
To release handle, push the handle release pedal located
on the lower left side of the cleaner.
CAUTION: Brushbar continues to rotate while hose
is removed or in use and at all times while cleaner
is on. Keep hair, loose clothing, fingers, and all parts of
body away from brush area while cleaner is on. Cleaner
must be in the upright position to lift the rotating brush
off the carpet when cleaning above the floor.
Fig.3/1
BACK FRONT
Fig.3/2
Fig.4/1
Fig.4/2
ON
OFF
Fig.4/3
Fig.4/4
!
a
b
c
!
Cord Release
Height adjuster
WARNING: This cleaner has a constantly
rotating brush bar which, when left in contact
with lino, parquet and other hard flooring could
potentially cause some damage to the floor surface.
NOTE: Vax recommends that you raise the height of
the brush bar when using this cleaner on lino and hard
flooring. Vax cannot be held responsible for damage to
these surfaces if the customer fails to take notice of
this recommendation.
!
Loading...