Vax VX54 User Manual
DynamoPower
TOTAL HOME
DYNAMIC POWERFUL
PERFORMANCE, FOR TOTAL
HOME CLEANING
LET’S GET STARTED.
VX54
vax.com.au
vax.co.nz
Let’s talk safety
Basic
safety
precautions
Don’ts
This vacuum cleaner is intended for household use only and
NOT for commercial or industrial use.
READ ALL THE INSTRUCTIONS BEFORE USING
THIS APPLIANCE
• Only use the vacuum cleaner indoors and keep the area you’re
cleaning well lit.
• Keep ngers, hair and loose clothing from moving parts and
openings whilst using the vacuum cleaner.
• This appliance is not intended for use by persons (including
children) with reduced physical, sensory or mental capabilities
or lack of experience and knowledge unless they have
been given supervision or instruction concerning use of the
appliance by a person responsible for their safety.
• Do not pull or carry by cord, use cord as a handle, close a door
on cord, or pull cord around sharp edges or corners. Do not
place product on cord. Do not run appliance on cord.
• Don’t handle the plug or use the vacuum cleaner with wet hands.
• Don’t use the vacuum cleaner with incorrect voltage as this may
result in damage or injury to the user. The correct voltage is
listed on the rating label.
• Don’t vacuum up hot coals, cigarette butts, ash, matches or
smoking hot burning items or use in an area where there may be
harmful uids (chlorine, bleach, and ammonia drain cleaner).
Children should not play with the vacuum cleaner. Cleaning and user
maintenance should not be made by children without supervision
• Only Vax recommend tools and accessories should be used with this
vacuum cleaner
• Vax recommends the use of a Residual Current Device rating of 30 mA or less.
• If the supply cord is damaged, it must be replaced by the manufacturer,
or similarly qualied person in order to avoid a hazard, or invalidating
the warranty.
• IMPORTANT: The motor is equipped with a thermal cut-out. If for any
reason the unit should overheat, the thermostat will automatically turn the
unit o. Should this occur, unplug the vacuum cleaner from the electrical
outlet and turn o the switch. Remove dirt container and empty. Clean
lters. Allow the unit to cool for approximately one (1) hour. To re-start,
plug into an electrical outlet and switch back on.
• Don’t attempt to remove blockages with sharp objects as this may cause
damage to the vacuum cleaner.
• Do not vacuum hard or sharp objects such as glass, nails, screws or coins etc.
• Do not vacuum plaster dust, concrete dust or any other building
or vitreous material.
• Do not vacuum our, baking soda or any other powder-based carpet
refresher or deodoriser.
• Don’t use this vacuum cleaner if it has been dropped, damaged or left outdoors.
• Don’t vacuum up any ammable or combustible materials (lighter uid, petrol,
kerosene etc.) or use the vacuum cleaner in an area with explosive vapours
or liquid.
Do’s
• Always make sure the lter and dirt container are tted
correctly before using your vacuum cleaner.
• Turn o all controls on the vacuum cleaner before
disconnecting or connecting the battery.
• Take extra care when cleaning on the stairs.
• Always switch o the vacuum cleaner before disconnecting
or connecting the hose and accessories.
• Always protect the charger cord from heated surfaces
or near open ames.
• Use only SAA approved 10amp extension cords. Care should be taken to
arrange the extension cord as it can be a trip hazard.
• Always carry the vacuum cleaner by the handle.
• Store your vacuum cleaner in a cool, dry area.
• Always keep the power cord away from the brushes whilst using your
vacuum cleaner.
PLEASE KEEP INSTRUCTIONS FOR FURTHER USE.
Thank you for buying this
Dynamo Power Total Home.
Taking care of your carpets and hard oors
The Dynamo Power Total Home is designed to make vacuuming carpets and hard
oors regularly, as eective and ecient as possible and this user guide will help you
get the most out of your machine.
Maintaining your carpets and hard oors will ensure they keep their appearance
for longer. You’ve chosen carpets and hard oors for your home for a reason
and Vax will help you take good care of them.
Taking care of your Dynamo Power Total Home
Also inside this guide are instructions on maintaining your new machine, so that it’s
always ready when you are to tackle your carpets and hard oors.
Contents
Let’s talk safety
Getting to know your machine
Getting started
Using your machine
Taking care of your machine
Let’s talk technical
Dynamo Power
Total Home
Included with
your machine
Combination Floorhead
Telescopic Extension Tube
3-in-1 Tool
Accessory Hose
We’re here if you need us
For troubleshooting simply visit or call:
Australia: 1300 361 505* New Zealand: 0800 800 900*
vax.com.au vax.co.nz
*Monday – Friday: 8:30am -5:00pm
Calls are charged at the standard local rate. Please make note of the serial
number and model number of the product before calling.
Accessories
Notes
What to do if it goes wrong
Getting in touch
Hardoor Tool
TurboTool
Turbo Brush
Up-top Tool
Getting to know your machine
!
Double
Insulated
This product
meets applicable
regulatory
requirements
Indoor
Use
Read
Instructions
Separator and shroud
Hose entry point
Dirt container release button
Getting started
Dirt bin lid release clip
PLEASE READ ‘LET’S TALK SAFETY’ AT THE BEGINNING BEFORE USE
Before you begin cleaning
Dirt container
• Always switch o and unplug the vacuum cleaner before connecting or disconnecting the hose/attachments,
or removing and emptying the dirt container.
• The vacuum cleaner is equipped with a thermal cut-out. If for any reason the vacuum cleaner does overheat the
thermostat will automatically turn the vacuum cleaner o. If this happens, switch the vacuum cleaner o and unplug
from electrical socket. Remove and empty the dirt container also check the vacuum cleaner for blockages. Allow the
vacuum cleaner to cool for approximately 1 hour (if you have cleaned the lters please wait 24 hours for the lters
to fully dry before putting back into the vacuum machine).
• For best cleaning results, lters should be tapped over a bin every 4-6 uses to remove dirt and debris and washed
every 3 to 6 months (depending on the level of use).
• If the vacuum cleaner is blocked, switch o and unplug before removing the blockage.
Carry handle
Assembling your vacuum cleaner
click!
Power On/O button
Post-motor lter cover
Technical Specication
Name Dynamo Power Total Home
Voltage 220-240V~50Hz
Wattage 1600w
Cord length 6m
Weight 5.2kg
Subject to technical change without notice.
Cord rewind button
Post-motor lter
cover release clip
Accessories & Consumables
Filter pack*
VX54F
*To purchase consumables and accessories, please visit vax.com.au
Press both buttons
at the end of the hose
and push hose into
the hose entry point.
Fully unwind the power
cord. A yellow mark on
the cord indicates the
recommended cord length.
Do not exceed the cord
beyond the yellow mark.
Insert the hose grip into the
telescopic extension tube.
Plug in and switch the
unit on by pressing the
power button.
Press the button on the
telescopic extension
tube and adjust to
required length.
Insert the other end of
the telescopic extension
tube into the oorhead.
When unwinding the
power cord always pull
out to the yellow marker
but no further.
CAUTION
Loading...