Vax VCC-O5, Workman VCC-05, Workman VCC-07 Instruction Manual

Vaxcare:

AUST: 1300 361 505

NZ: 0800 800 900

MODIFIED NOV 2007 P/N C-5410

www.vax.com.au

Instruction Manual

Please read carefully before using the cleaner.

Always fully extend the mains cable before use.

Workman

VCC-O5
VCC-07

10. Troubleshooting

WARNING: To reduce the risk of injury,

unplug the vacuum cleaner before servicing.

PROBLEM: Vacuum cleaner won’t run

Cause:

Not properly plugged into electrical outlet.

Solution: Plug unit in firmly.

Cause: Vacuum cleaner not turned on.
Solution: Press on/off button.

Cause: No electricity in the electrical outlet.
Solution: Check fuse or breaker.

Cause: Blown fuse/tripped breaker.
Solution: Reset circuit breaker or replace fuse.

Cause: Motor thermostat has tripped.
Solution: Switch off and unplug the vacuum

cleaner. Leave for one (1) hour. See page 2.

PROBLEM: Cleaner won’t pick up/
loss of suction

Cause: Dust bag not installed correctly.
Solution: Review dust bag removal and

replacement.

Cause: Dust bag full or blocked.
Solution: Replace dust bag. Empty/clean/

replace cloth bag

Cause: Clogged filter.
Solution:

Remove/replace with new filter VCC-05.

Remove wash/replace HEPA filter VCC-07.

Cause: Blockage in hose.
Solution: Disconnect hose, remove the

obstruction then re-fit.

PROBLEM: Accessories won’t pick up

Cause: Accessories are not attached correctly.
Solution:

Refer to page 5 for fitting information.

PROBLEM: Dust escaping from the
vacuum cleaner

Cause: Dust bag full.
Solution:

Dispose of paper dust bag, replace

with a new one or empty/clean/replace cloth bag.

Cause: Dust bag not installed correctly.
Solution: Review dust bag removal and

replacement.

Cause: Hose is not installed correctly.
Solution: Review hose installation.

Cause: Filter not installed completely.
Solution: Review filter removal and

replacement.

8. VAXCARE Service & Help:
AUSTRALIA 1300 361 505
NEW ZEALAND 0800 800 900

If you have any queries or concerns about
using your Vax, call VAXCARE. Please make
a note of the part number or model number
of the appliance before calling.
(Aust only: Mon-Fri. 8:30am - 5:30pm. EST)
Calls are charged at the local rate.
An answerphone is available outside of
these hours. We will return your call the next
working day.
There are over 300 approved Vax Service Agents
in Australia and New Zealand. For the nearest
Service Agent, please refer to your Vax warranty
or call VAXCARE or visit www.vax.com.au

9. Technical Specification

Voltage 220-240V~50Hz
Wattage: 1400W Model VCC-05
1500W Model VCC-07
Capacity: 6 litres max Model VCC-05
8 litres max Model VCC-07
Filters: Pre-motor filter VCC-05 only
HEPA Model VCC-07 only
Cord length: 12 metres
Weight: 7.2kg Model VCC-05

8.5kg Model VCC-07

Subject to technical change without notice.

12 Month VAXCARE Commercial Warranty

Commercial User Guide.indd 1 5/10/07 11:12:18 AM

2 7

1. Safety Instructions

For Commercial Use Only

When using the vacuum cleaner, basic safety
precautions should always be observed,
including the following:

1. This appliance is for dry use only and is not
to be used or stored outdoors or in wet
conditions.

2. Turn off the vacuum cleaner controls before
connecting to or disconnecting from the
mains supply.

3. Always unplug the vacuum cleaner before
connecting or disconnecting the vacuum
hose.

4. This appliance is not intended for use
by young or infirm persons unless they
have been adequately supervised by a
responsible person to ensure that they can
use the appliance safely.

Young children should be supervised

to ensure that they do not play with the
appliance.

5. Use only as described in this manual. Use
only the manufacturer’s recommended
attachments. This appliance is suitable
for commercial use, for example in hotels,
schools, hospitals, factories, shops, offices
and rental businesses.

6. Do not use the vacuum cleaner with a
damaged cord or plug. Do not use the
vacuum cleaner if it has been dropped,
damaged, left outdoors or dropped into
water. Return the vacuum cleaner to a Vax
Authorised Service Agent for examination,
repair or adjustment.

Regularly examine the power cord for

damage, such as cracking or ageing. If
damage is found replace the cord before
further use.

7. Do not pull or carry by the cord. Do not use
the cord as a handle, close a door on the
cord or pull the cord around sharp edges
or corners. Do not run the vacuum cleaner
over the cord. Keep the cord away from
heated surfaces.

8. Do not handle the plug or vacuum cleaner
with wet hands. Do not use outdoors or on
wet surfaces.

9. Do not put any objects into openings. Do
not use with any openings blocked and do
not restrict air flow. Keep all openings free of
dust, lint, hair or anything that may reduce
airflow.

10. Keep hair, loose clothing, fingers and all
parts of the body away from openings and
moving parts.

11. Do not pick up hot coals, cigarette butts,
matches or any hot, smoking or burning
objects.

12. Do not pick up flammable, hazardous
dust or combustible materials (lighter fluid,
petrol, kerosene, etc) or use in the presence
of explosive liquids or vapours.

13. Do not vacuum up harmful or toxic material
(chlorine bleach, ammonia, drain cleaner,
etc).

14. Do not vacuum up hard or sharp objects
such as glass, nails, screws, coins, etc.

15. Do not use without the filters in place.

16. Use extra care when vacuuming on stairs.

17. Keep vacuuming area well lit.

18. Store the vacuum cleaner indoors in a cool,
dry area.

19. Turn off the switch before unplugging.

WARNING: Always switch off and unplug the
vacuum cleaner from the electrical outlet before
assembling, opening or emptying the dirt
container, or before connecting/disconnecting
the attachments.

CAUTION: The vacuum cleaner is a very
powerful unit. Before plugging the cord into
the outlet make sure the switch is in the ‘off’
position. Hold the vacuum cleaner firmly when
starting.

IMPORTANT: If the inlet or hose is blocked,
switch off the vacuum cleaner and remove the
blockage(s) before re-starting.

IMPORTANT: Cleaning filters improves vacuum
performance. Make sure all filters are replaced
back into the vacuum cleaner before using.

This appliance is suitable for commercial use.
PLEASE KEEP THESE INSTRUCTIONS FOR
FURTHER USE.

Motor Thermostat
IMPORTANT: The motor is equipped with a

thermal cut-out. If for any reason, the vacuum
cleaner should over-heat, the thermostat will
automatically turn the unit off. Should this occur,
unplug the vacuum cleaner from the electrical
outlet and turn off the switch. Remove the dirt
container and empty. Clean the filters. Allow the
cleaner to cool for approximately one (1) hour
before re-starting.

7. Clearing Blockages

WARNING: To reduce the risk of injury,

the power cord must be disconnected
before performing maintenance or
troubleshooting checks.

Turn vacuum cleaner off and disconnect the
power plug from the electrical outlet.
The flexible hose can be disconnected from
the vacuum cleaner by rotating anti-clockwise
and pulling away from the machine. Remove
any blockages found then reconnect the hose
(Fig.7/1).

HEPA Pre-motor Filter (Model VCC-07 only)

1. Turn off the vacuum cleaner and unplug it
from the electrical outlet.

2. Unclip the retainer clip on the top of the
vacuum cleaner and lift up to gain access
to the dirt container department (Fig.6/8).

3. The HEPA pre-motor filter is found in the
centre of the dirt container. Rotate the filter
clockwise to remove (Fig.6/9).

Fig.6/9

NOTE: Do NOT use any detergents or boiling
water to wash the filter.

5. Replace the HEPA filter back in the machine
before use.

4. Gently tap the filter against the side of the
rubbish bin to remove excess dirt. The filter
may then be rinsed in cool water. Allow to
thoroughly air dry before replacing.

Replace the filter every 3-6 months

depending on useage or when the filter
becomes discoloured (Fig.6/7).

Commercial User Guide.indd 2 5/10/07 11:12:19 AM