Vax Careline:
0870 6061248
Instruction Manual
Please r
ead car
efully before using
this cleaner. Always fully extend
the mains cable befor
e use.
www.vax.co.uk
CARPET WASHER
Vax Model Number: V-022/V-022Q
Duo
Vax V-022(Q).qxd 23/8/06 11:47 Page 1
1 Handle
2 Clean water tank release latch
3 Carry handle
4 Clean water tank
5 Dirty water tank release latch
6 Dirty water tank handle
7 Fixed brushbar
8 Dirty water tank
9 Dirty water tank lid
10 Power cord
11 Quick cord release
12 Handle release pedal
13 On/off switch
14 Upper cord clip
15 Solution release trigger
16 1 x Upper handle screw
17 2 x Right and left base screws
18 1 x Middle base screw
19 3 x Nuts
20
1 x V
ax AAA Carpet Cleaner 750ml
1. Diagram
P
arts Overview
2
Fig.1/1
1
2
3
4
5
6
8
7
9
16
17
18
19
15
14
10
13
11
12
20
Vax V-022(Q).qxd 23/8/06 11:47 Page 2
S
afety Information
3
2. Safety Information
FOR HOUSEHOLD USE ONLY.
When using the carpet washer, basic safety
precautions should always be observed, including the
following:
1. Only use the vacuum cleaner indoors on dry
surfaces.
2. Turn off the carpet washer controls before
connecting to or disconnecting from the mains
supply.
3. Always unplug the carpet washer before
connecting or disconnecting the vacuum hose.
4. Close attention is necessary when used by
or near children. Do not allow children to use
as a toy.
5. Use only as described in this manual. Use only
the manufacturer’s recommended attachments.
6. Do not use the carpet washer if it has been
dropped, damaged, left outdoors or dropped into
water. Do not use the carpet washer with a
damaged cord or plug. If the supply cord or plug
7. Do not pull or carry by the cord. Do not use the
cord as a handle, close a door on the cord or pull
the cord around sharp edges or corners. Do not
run the carpet washer over the cord. Keep the
cord away from heated surfaces.
8. Do not handle the plug or vacuum cleaner with
wet hands. Do not use outdoors or on wet
surfaces.
9. Do not put any objects into openings. Do not use
with any openings blocked and do not restrict air
flow. Keep all openings free of dust, lint, hair or
anything that may reduce airflow.
10. Keep hair, loose clothing, fingers and all parts
of the body away from openings and moving parts.
11. Do not pick up hot coals, cigarette butts,
matches or any hot, smoking or burning objects.
12.
Do not pick up flammable or combustible
materials (lighter fluid, petrol, kerosene, etc)
or use in the presence of explosive liquids
or vapours.
13. Do not vacuum up harmful or toxic material
(chlorine bleach, ammonia, drain cleaner, etc).
14. Do not vacuum up hard or sharp objects such
as glass, nails, scr
ews, coins, etc.
15. Do not use without the filters in place.
16. Take extra care when vacuuming on stairs.
17. Keep vacuuming area well lit.
18. Store the carpet washer indoors in a cool,
dry area.
19. Turn off the switch before unplugging.
20. Use only CE-approved 13 amp extension cords.
Non-approved extension cords may overheat.
Care should be taken to arrange the cord so that
the cord cannot be pulled or tripped over.
WARNING: Always switch off and unplug the carpet
w
asher from the electrical outlet before assembling,
opening or emptying the water tanks, or before
connecting/disconnecting the attachments.
CAUTION: The carpet washer is a very powerful unit.
Before plugging the cord into the outlet make sure the
switch is in the ‘off’ position. Hold the carpet washer
firmly when starting and in use.
IMPORTANT: If the inlet is blocked, switch off the
carpet washer and remove the blockage(s) before restarting the carpet washer.
IMPORTANT: Washing filters improves vacuum
performance. Make sure all filters are completely dry
before inserting back into the carpet washer.
This carpet washer is intended for household use only
and not for commercial or industrial use.
PLEASE KEEP THESE INSTRUCTIONS FOR
FURTHER USE.
Motor Thermostat
IMPORTANT: The motor is equipped with a thermal
cut-out. If for any reason, the carpet washer should
over-heat, the thermostat will automatically turn the
unit off. Should this occur, unplug the carpet washer
from the electrical outlet and turn off the switch.
Remove the dirty water tank and empty. Clean the
filters. Allow the cleaner to cool for approximately
one (1) hour. To re-start, plug into an electrical outlet
and switch back on.
Vax V-022(Q).qxd 23/8/06 11:47 Page 3
3. Use & Function
Assembling the Carpet Washer
IMPORTANT: Always unplug the carpet washer from
the electrical outlet before assembling or removing the
accessories.
1. Stand the base in an upright position. Push the
mid-section on to the base by aligning the tabs on
the backside of the base (Fig.3/1).
NOTE: Make sure the power cord is out of the way
to avoid pinching.
2. Insert three (3) nuts into the recesses at the back
of base. While holding the nuts in place insert the
screws through the front of the mid-section and
tighten (Fig.3/2).
NOTE: Do not trap the cable when assembling the
carpet washer.
3. Slide the handle down on to the unit. Place screw
into the recess at the back and tighten (Fig.3/3).
Fig.3/3
Fig.3/2
Fig.3/1
4. Place the clean water tank into the cleaner until it
clicks into place (Fig.3/4).
Cord Storage
Wrap cord around upper and lower cord wraps
(Fig.3/5). Clip plug to cord to secure for storage.
4. Preparing the Carpet
IMPORTANT: The carpet washer is not a dry vacuum
cleaner.
1. Vacuum carpet thoroughly. Use a vacuum
cleaner with a revolving brushbar for best
results.
2. Remove as much furniture from the room as
possible. If unable to remove the furniture, place
plastic or foil under and around the legs until the
carpet has dried completely.
HELPFUL HINTS FOR CLEANING CARPET:
1. Only use Vax AAA Carpet Cleaner with this
carpet washer.
2. Do not oversaturate carpet with cleaning solution
while using the carpet washer.
3.
For heavily soiled ar
eas, additional applications
may be necessary.
4. Allow plenty of time to dry carpet thoroughly.
5.
W
ipe cleaning solution fr
om woodwork and
wood to prevent any damage.
6. Try not to walk on carpet until it is completely dry.
7. After carpet is thoroughly dry, vacuum the carpet
using a vacuum cleaner with a revolving brushbar.
Fig.3/5
Fig.3/4
U
se & Function/Preparing the Carpet
4
Vax V-022(Q).qxd 23/8/06 11:47 Page 4
Loading...