www.vax.co.uk
Please read carefully before using this cleaner.
Always fully extend the mains cable before use.
R
e
tain f
or future reference.
Vax careline
0870 6061248
instruction manual
Steam cleaner
Vax model number:
V-083
V-083Q
Vax V-083(Q) User Guide.qxd 25/1/07 11:11 Page 1
V-083(Q)
1. Diagram
www.vax.co.uk
2
parts overview
1 Hanging hook
2 Steam regulator
3 Control switches
4
Water tank cap
5 Water tank
6 Lock button
7 Floor head
8 Towel grips
9 Brush slides
10 Cord holder
11 Lower handle
12
Power cord
13
C
or
d holder
14 Squeegee tool
15
Utility t
ool
16 Deflector nozzle
17 Floor cloth
18 Utility cloth
19 Spot brush
20
Nozzle brush
21
No
zzle pin
22 Funnel
23
Carpe
t glide base
(V-083Q only)
24 Steam comb (V-083Q only)
A B
C D
A On/off switch
B Steam switch
C Power ON light (red)
D Steam ready light (green)
1
2
3
4
5
6
7
8
9
10
11
12
1
3
Fig.1/1
17
14
15
16
19
22
20
21
18
Accessories
24
corner gliders
23
Vax V-083(Q) User Guide.qxd 25/1/07 11:11 Page 2
3
Vax Careline 0870 606 1248
safety information
2. Safety Information
For Household Use Only
When using the steam cleaner, basic safety precautions
should always be observed, including the following:
1. Do not leave the steam cleaner unattended when
plugged in. Unplug it from the socket when not in use.
2. To prevent electric shock do not use outdoors.
3. Not to be used as a toy. Close supervision is necessary
when used near children or the infirm.
4. Use only as described in this manual.
5. Do not use with a damaged cord or plug. If the supply
cord and/or plug is damaged, they must be replaced by
the manufacturer, a Vax Service Agent or similarly
qualified persons in order to avoid hazard.
6. Do not pull or carry by the cord, use the cord as a
handle, allow the cord to come into contact with hot or
sharp surfaces or close a door on the cord.
7. Do not unplug by pulling on the cord.
8. Do not handle the plug or cleaner with wet hands.
9. Do not put any objects into openings or operate with
openings blocked.
10. Do not use without the tank cap in place.
11. Turn off all controls before unplugging.
12. Do not use an extension cord.
13. Store indoors, put away after use to prevent tripping
accidents.
14. Using improper voltage may result in damage to the
steam cleaner and possible injury to the user. The
correct voltage is listed on the rating label.
15. This steam cleaner is intended for household use only.
16. A hazard may occur if the steam cleaner runs over the
power cord.
17. Never immerse the steam cleaner in water or other
liquids.
18. K
eep the s
team cleaner away from the rain and
moisture. The steam cleaner is not suitable for outdoor
use.
19.
Only use the s
team cleaner in containers/pools that
are not filled with water or other liquids.
20.
Do no
t operate the steam cleaner without water in
the tank. Always top up with water in good time.
21. Empty the water tank when the steam cleaner is not
in use.
22. Never fill the tank with anything other than water.
Never put additives (such as perfume, stain remover
or products containing alcohol) in the water as they
may damage the steam cleaner or make it dangerous
to use.
23. Always remove the mains plug and handle the steam
cleaner with care when topping up with water.
24. Do not overfill the tank. Do not exceed the maximum
prescribed filling level. Please use the funnel included.
25. Ensure that the water tank’s closure cap has been
screwed down fully before use.
26. Do not touch any hot areas on the steam cleaner. It is
normal for the steam cleaner to heat up during
operation.
27. Do not use the steam cleaner to treat any items of
clothing that are still being worn on the body.
28. The force and heat of the steam may have an adverse
effect on some materials. Always check whether a
surface is suitable for treatment with the steam
cleaner by carrying out a test beforehand on a
concealed area.
29. Always include these operating instructions if passing
the steam cleaner onto a third party.
30. Never aim the steam cleaner at people, animals or
plants (risk of scalding!) Do not aim the steam cleaner
at electrical systems or wires.
31. Please always switch the appliance off and remove
the mains plug from the socket if leaving the work
area.
32. Accessories become hot during use- allow them to
cool down before handling.
33. Maintain and clean the steam cleaner only when the
unit is cold.
Steam Release Safety Feature
IMPORTANT: This steam cleaner is equipped
with a steam release valve mechanism, located
at the rear of the steam generator. In event of a steam
flow blockage, the safety valve is designed to release
the steam. Regular cleaning of the steam chamber and
nozzle is therefore recommended to avoid such an
occurr
ence. If the steam is released from the safety
valve, stop cleaning and unplug the steam cleaner
from the electrical outlet. Allow the steam cleaner to
cool down thoroughly for at least one hour. After this
time, clean the steam chamber and nozzle following
the instructions in section 6.
If steam is still being released from the safety valve
after cleaning, contact a Vax Service Agent.
!
Vax V-083(Q) User Guide.qxd 25/1/07 11:11 Page 3
www.vax.co.uk
4
assembly / operation
3. How to Assemble
IMPORTANT: Never unscrew the tank cap
during use.
IMPORTANT: Never fill the tank directly from
a tap. Use a jug and the funnel provided.
IMPORTANT: Do not operate a damaged
appliance or damaged accessories.
IMPORTANT: This steam cleaner is not intended
for commercial use.
NOTE: Carpets should be dry vacuumed thoroughly
before using the steam cleaner.
NOTE: If the supply cord is damaged, it must be
replaced by the manufacturer, a Vax Service Agent or
similarly qualified persons to avoid hazard.
Place the steam cleaner in a horizontal position and
remove the water tank cap. Use the funnel provided to
slowly fill the water tank with clean water. Replace the cap
securely (Fig3/1).
Insert the power plug into an electrical outlet. Make sure
the steam cleaner is switched off.
Press the on/off switch located on the handle to switch
the steam cleaner on.
The red heater “ON” light should now be illuminated.
Press the steam switch to the “ON” position.
After approximately 30 seconds the green “Steam Ready”
light should come on.
Turn the Steam regulator control to maximum and point
the steam nozzle towards a cloth or sink for approximately
10-15 seconds, to stabilise the flow and produce a
continuous steam.
Ensure the steam switch is turned off before connecting
the floor head or an
y of the other cleaning accessories.
4. How to Operate
Align the hole in the side of the floor head with the lock
button on the main body of the steam cleaner. Ensure that
the lock button clicks firmly into place (Fig4/1).
Connect the floor cloth to the floor head by using the
towel grips (Fig4/2).
Turn the steam switch on.
Carpet Cleaning
When cleaning carpets and rugs, leave the steam regulator
control set to “maximum”. Use slow backward strokes and
lift the floor head slightly during forward strokes to reduce
friction between the cloth and the carpet.
N.B Do not press the appliance hard against the carpet.
For large carpeted areas
(Model: V-083Q only)
For freer movement of the steamer over larger carpeted
areas the carpet glide attachment can be used.
De
tach and r
emo
v
e the s
team comb section from the
carpet glide attachment.
Fold the cloth and place inside the carpet glide base.
!!!
!
Fig.3/1
Fig.4/1
Fig.4/2
Vax V-083(Q) User Guide.qxd 25/1/07 11:11 Page 4
Loading...