Page 1
COMMERCIAL
U88-T1 Series
User Guide
Vax Careline: (UK) 0844 412 8455
(ROI) 1-800 928 308
Performance is everything.
vax.co.uk
Page 2
9
1
2
4
5
3
6
7
8
Machine Overview
2
vax.co.uk
1 Handle
2 Long crevice tool
3 Brush bar height adjust
4 Cord wrap
5 HEPA central lter
6 Dirt container
7 On/o button
8 Pre-motor lter
9 Hose
PLEASE NOTE: Some parts may
vary according to model. Please check
inside ap of box for more details.
Vax Careline: (UK) 0844 412 8455
(ROI) 1-800 928 308
Page 3
Assembly
3vax.co.uk
Slide the handle down onto the
main body of the unit.
Assembling your upright
PLEASE READ SAFETY INFORMATION BEFORE USE (PAGE 8)
Insert the upper carry handle into
the rear of the unit.
Insert the U shaped pin at the
front of the unit.
Connect the upper hose to the
upper hose connector until it clicks
into position (1).
Insert the lower hose to the lower
hose connector (2).
Attach the dirt container to the unit
until a click is heard.
Secure the carry handle to
the vacuum by tightening the
three screws located on the back
of the unit.
1
2
Page 4
Operation
4
Twist the upper cord wrap to fully
unwrap the cord then plug the unit
into the electrical socket.
Place foot on the on/o button to
switch the vacuum cleaner on.
Select a carpet height setting by
adjusting the brush bar height.
High — long carpet pile and
hard oors.
Low — short carpet pile.
Place foot on the vacuum to recline
the vacuum body as desired.
Operating the appliance
IMPORTANT: Vax recommends that you raise the height of the brush bar to the highest position
when using this cleaner on lino and hard ooring due to constant rotation. Vax cannot be held
responsible for damage to these surfaces if the customer fails to take notice of this recommendation.
IMPORTANT: When the
vacuum cleaner is stood
in the upright position, or
when using the hose and
tools, the brush bar height
adjust must be set to the
highest position.
!
!
!
!
!
!
!
!
vax.co.uk
Vax Careline: (UK) 0844 412 8455
(ROI) 1-800 928 308
Page 5
Maintenance
5
Press dirt container release button
to remove the dirt container.
Turn the lid of the dirt container
anticlockwise to remove the lid.
Turn the HEPA lter anticlockwise
to remove the HEPA lter.
Tap the HEPA lter against a bin
and wash it under running water
(max 40°C). Dry thoroughly and
replace by turning it clockwise
until it locks.
Emptying and cleaning the dirt container
Cleaning the HEPA lter
NOTE: It is very important
to keep the lters clean
to maintain maximum
performance of the vacuum.
Do not use detergents to
clean the lter.
NOTE: Always switch o the appliance and unplug the mains socket before carrying out any
maintenance or cleaning. Clean the outside of the appliance with a damp cloth.
Hold dirt container over a bin and
press dirt release button to open,
allowing dirt to fall out.
!
!
!
!
!
!
!
!
Max
40°C
vax.co.uk
A
A
B
B
Page 6
Maintenance
6
Cleaning the pre-motor lter
Removing the belt
Removing debris from the hose
IMPORTANT: To reduce the risk of electric shock, turn the vacuum cleaner o and unplug from the
electrical socket before performing maintenance/troubleshooting checks. Disconnect the hose from the
vacuum cleaner and remove any blockages found, then reconnect the hose securely.
!
!
!
!
Remove the pre motor lter from
underneath the dirt container
as shown.
Using scissors, cut any threads from the brushbar and remove.
Turn unit over and remove four
screws as indicated by arrows.
Tap the lter against a bin and
wash it under running water
(max 40°C).
Dry thoroughly (24hrs) and replace
it in the unit.
Remove the two screws under the
wheels and separate the brush bar
cover from the base of the unit.
To replace the belt, lift the brush
bar out of the base of the unit.
Next, remove the belt from the
spindle and end of the brush bar.
vax.co.uk
Vax Careline: (UK) 0844 412 8455
(ROI) 1-800 928 308
Max
40°C
24hr
Page 7
FAQs
7
Is there an accessory missing?
• Check the ‘Machine Overview’ page in this guide to make sure the part is denitely included in your unit.
• If it is missing, we’re here to help. Simply call us on 0844 412 8455
Why won’t the vacuum cleaner pick up?
• The dirt container may be incorrectly installed; remove the dirt container from the unit by pressing the dirt
container release button and then re-attaching it to the unit, ensuring it is locked rmly back into place.
• The lter may be clogged; refer to ‘Maintenance: Cleaning the lters’ on pages 5 and 6.
• The dirt container may be blocked; refer to ‘Maintenance: Emptying and cleaning the dirt container’ on page 5.
• There may be a blockage in the hose/tube; disconnect from the vacuum cleaner. Carefully remove any
blockages found and reconnect securely.
Why is dust escaping from the vacuum?
• The lter may be clogged; refer to ‘Maintenance: Cleaning the lters’ on pages 5 and 6.
• The dirt container may be blocked; refer to ‘Maintenance: Emptying and cleaning the dirt container’ on page 5.
• The dirt container may be incorrectly installed; remove the dirt container from the unit by pressing the dirt
container release button and then re-attaching it to the unit, ensuring it is locked rmly back into place.
What do I do if the unit/an accessory becomes damaged or broken?
• We’re here to help. Simply call 0844 412 8455 or visit vax.co.uk
Why won’t the accessories pick up properly?
• Hose blockages: remove the hose from the unit. Carefully remove any blockages found and reconnect
hose securely.
• Accessory blockages: remove accessory from handle/tube. Carefully remove blockage and re-attach to the
vacuum cleaner.
• The accessory may be faulty. Simply call us on 0844 412 8455 for assistance.
Why will the vacuum cleaner not run?
• It may not be plugged into the electrical socket correctly; ensure that the plug is pushed in securely.
• The electrical socket may not be working properly; check the fuse or breaker, or consult an electrician.
• The motor thermostat may have tripped; switch o and unplug the vacuum cleaner, and leave for one hour
before switching the cleaner back on.
What do I do if the unit becomes damaged or broken?
• We’re here to help. Simply call 0844 412 8455 or visit vax.co.uk
vax.co.uk
Page 8
General Safety Information
8
FOR HOUSEHOLD USE ONLY.
When using the vacuum cleaner, basic safety precautions should always be observed, including the following:
1. Only use the vacuum cleaner indoors on dry surfaces.
2. Turn o the vacuum cleaner controls before disconnecting or connecting from the mains supply.
3. Always unplug the vacuum cleaner before connecting or disconnecting the vacuum hose and accessories.
4. Children should be supervised to ensure that they do not play with the appliance.
5. This appliance is not intended for use by persons (including children) with reduced physical, sensory or
mental capabilities, or lack of experience and knowledge, unless they have been given supervision or
instruction concerning use of the appliance by a person responsible for their safety.
6. Use only as described in this manual. Use only Vax recommended attachments.
7. Do not use the vacuum cleaner if it has been dropped, damaged, left outdoors or dropped into water. Do not
use the vacuum cleaner with a damaged cord or plug. If the supply cord is damaged, it must be replaced by
the manufacturer or a recommended Service Agent to avoid hazard and invalidating the guarantee.
8. Do not pull or carry by cord/hose. Do not use the cord/hose as a handle, close a door on the cord/hose or
pull cord/hose around sharp edges or corners. Do not run the vacuum cleaner over the cord/hose. Keep the
cord away from heated surfaces.
9. Do not handle the plug or vacuum cleaner with wet hands. Do not use outdoors or on wet surfaces.
10. Do not put any objects into openings. Do not use with any openings blocked and do not restrict air-ow.
Keep all openings free of dust, lint, hair or anything that might reduce airow.
11. Keep hair, loose clothing, ngers and all parts of the body away from openings and moving parts.
12. Do not pick up hot coals, cigarette butts, matches or any hot, smoking or burning objects.
13. Do not pick up ammable or combustible materials (lighter uid, petrol, kerosene etc.) or use in the presence
of explosive liquids or vapours.
14. Do not vacuum up harmful or toxic material (chlorine, bleach, ammonia, drain cleaner etc.).
15. Do not vacuum up hard or sharp objects such as glass, nails, screws, coins, etc.
16. Do not use without ALL of the lters in place.
17. Take extra care when vacuuming on stairs.
18. Keep vacuuming area well lit.
19. Store the vacuum cleaner in a cool, dry area.
20. Turn o the on/o switch before unplugging the vacuum cleaner
21. Use only CE-approved 13 amp extension cords.Non-approved cords may overheat. Care should be taken to
arrange the cord so that the cord cannot be tripped over.
WARNING: Always switch o and unplug the vacuum cleaner from the electrical socket before assembling, opening or
emptying the dirt container, or before connecting/disconnecting the attachments.
CAUTION: The vacuum cleaner is a very powerful unit. Before plugging the cord into the electrical socket, make sure the
switch is in the ‘o’ position.
IMPORTANT: If the inlet, hose or telescopic tube is blocked, switch o the vacuum cleaner and remove the blockage(s)
before re-starting the vacuum cleaner. See Maintenance; Clearing Blockages.
IMPORTANT: Cleaning lters maintains vacuum performance. Vax recommends that your lters should be checked and
cleaned periodically. If your lters are washable make sure they are completely dry before inserting back into the vacuum cleaner.
IMPORTANT: The motor is equipped with a thermal cut-out. If for any reason the unit should overheat, the thermostat will
automatically turn the unit o. Should this occur, unplug the vacuum cleaner from the electrical socket and turn o the switch.
Remove dirt container and empty. Clean lters. Allow the unit to cool for approximately one (1) hour. To re-start, plug into an
electrical socket and switch back on.
This vacuum cleaner is intended for household use only and NOT for commercial or industrial use.
PLEASE KEEP THESE INSTRUCTIONS FOR FUTURE REFERENCE.
!
!
!
!
!
!
!
!
!
!
!
!
!
!
!
!
!
!
!
!
vax.co.uk
Vax Careline: (UK) 0844 412 8455
(ROI) 1-800 928 308
Page 9
Machine Overview
9
Service & Help
Vax Careline:
(UK) 0844 412 8455
(ROI) 1-800 928 308
Monday-Friday 8.30am to 6.30pm
Saturday-Sunday 9.00am to 5.00pm
Any queries or concerns about using your Vax, call the Vax Careline. Calls are charged at the UK local rate.
Please make a note of the serial number and model number of the vacuum cleaner before calling. For the
nearest Service Agent, please call the Vax Careline or visit vax.co.uk
Consumables
To purchase spares and accessories, please visit vax.co.uk
Type 54 lter kit: 1-1-131932-00
Technical Specication
Voltage: 220-240V -50Hz
Wattage: 1800W
Capacity: 2L
Cord length: 7.5m
Weight: 6kg in use
Subject to technical change without notice.
EEC Statement of Compliance
Manufacturer/EEC importer: Vax Limited, hereby on our own responsibility, declare that the
U88-T1 series is manufactured in compliance with the following Directives:
Safety: 2006/95/EC Low Voltage Directive
EMC: 2004/108/EC Electromagnetic Compatibility Directive
Disposal
This product should not be disposed of with the house-hold waste. Please recycle where facilities exist.
Check with your Local Authority or retailer for recycling advice.
vax.co.uk
Page 10
Notes
10
vax.co.uk
Vax Careline: (UK) 0844 412 8455
(ROI) 1-800 928 308
Page 11
Notes
11vax.co.uk
Page 12
COMMERCIAL
Vax Ltd., Kingswood Road, Hampton Lovett, Droitwich, Worcestershire, WR9 0QH, UK
email: info@vax.co.uk website: vax.co.uk
Version 1.0
Performance is everything.
Loading...