Vax U90-P4 SERIES, U91-P3, U91-P4, U88-P3, Power4 U90-P4 Series Instruction Manual

vax.co.uk
Please read carefully before using this cleaner.
Always fully extend the mains cord before use.
Retain for future reference.
instruction manual
Bagless upright
WARNING: This cleaner has a constantly
NOTE: Vax recommends that you raise the height of the brushbar when using this cleaner on lino and hard flooring. Vax cannot be held responsible for damage to these surfaces if the customer fails to take notice of this recommendation.
!
Vax model number:
U90-P4 Series
Vax Careline: (UK) 0844 412 8455
(ROI) 1-800 928 308
Version 1.4
Vax U90-P4 Series User Guide v1.4.qxd:UG 5/7/11 11:48 Page 1
1. Diagram
vax.co.uk
2
parts overview
5
7
9
4
3
2
1
17
16
14
11
6
8
10
Fig.1/1
1 Handle
2 TurboTool caddy
(some models only)
3 TurboTool (some models only)
4 Dirt container release button
5 Dirt container handle/carry handle
6 Cord
7 Central filter
8 Dirt container
9 Brushbar height adjust
10 Brushbar
11 Dusting brush
12 Crevice tool and extension wand
13 Hose
14 Hose storage holders
15 Lower hose
16 Power on/off
17 Recline pedal
14
15
13
12
WARNING: This cleaner has a
constantly rotating brushbar which, when left in contact with lino, parquet and other hard flooring could potentially cause some damage to the floor surface.
NOTE: Vax recommends that you raise the height of the brushbar when using this cleaner on lino and hard flooring. Vax cannot be held responsible for damage to these surfaces if the customer fails to take notice of this recommendation.
!
PLEASE NOTE: some parts may vary according to model. Please check inside flap of box for more details.
Vax U90-P4 Series User Guide v1.4.qxd:UG 5/7/11 11:48 Page 2
3
safety information
2. Safety Information
For Household Use Only
When using the vacuum cleaner, basic safety precautions should always be observed, including the following:
1. Only use the vacuum cleaner indoors on dry surfaces. Do not handle the plug or vacuum cleaner with wet hands. Do not use outdoors or on wet surfaces.
2. Turn off the vacuum cleaner controls before connecting or disconnecting from the mains supply.
3. Always unplug the vacuum cleaner before connecting or disconnecting the vacuum hose and accessories.
4. Children should be supervised to ensure that they do not play with the appliance.
5. The appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
6. Use only as described in this manual. Use only the manufacturer’s recommended attachments.
7. Do not use the vacuum cleaner if it has been dropped, damaged, left outdoors or dropped into water. Do not use the vacuum cleaner with a damaged cord or plug. If the supply cord or plug is damaged, it must be replaced by the manufacturer or a recommended Service Agent to avoid hazard and invalidating the guarantee.
8. Do not pull or carry by the cord. Do not use the cord as a handle, close a door on the cord or pull the cord around sharp edges or corners. Do not run the vacuum cleaner over the cord. Keep the cord away from heated surfaces.
9. Do not put any objects into openings. Do not use with any openings blocked and do not restrict air flow. Keep all openings free of dust, lint, hair or anything that may reduce airflow.
10. Keep hair, loose clothing, fingers and all parts of the body away from openings and moving parts.
11. Do not pick up hot coals, cigarette butts, matches or any hot, smoking or burning objects.
12. Do not pick up flammable or combustible materials (lighter fluid, petrol, kerosene, etc) or use in the presence of explosive liquids or vapours.
13. Do not vacuum up harmful or toxic material (chlorine bleach, ammonia, drain cleaner, etc).
14. Do not vacuum up hard or sharp objects such as glass, nails, screws, coins, etc.
15. Do not use without the filters in place.
16. Take extra care when vacuuming stairs.
17. Keep vacuuming area well lit.
18. Store the vacuum cleaner indoors in a cool, dry area.
19. Turn off the on/off switch before unplugging the vacuum cleaner.
20. Use only CE-approved 13 amp extension cords. Non­approved extension cords may overheat. Care should be taken to arrange the cord so that the cord cannot be pulled or tripped over.
WARNING: Always switch off and unplug the
vacuum cleaner from the electrical outlet before assembling, opening or emptying the dirt container, or before connecting/disconnecting the attachments.
CAUTION: The vacuum cleaner is powerful,
therefore aways ensure the power button is in the off position before plugging into the mains.
IMPORTANT: If the inlet or hose is blocked,
switch off the vacuum cleaner and remove the blockage(s) before re-starting the vacuum cleaner.
IMPORTANT: Cleaning filters maintains vacuum
performance.
This vacuum cleaner is intended for household use only and not for commercial or industrial use.
Please keep these instructions for further use.
!!!
!
Motor Thermostat
IMPORTANT: The motor is equipped with a
thermal cut-out. If for any reason, the vacuum cleaner should over-heat, the thermostat will automatically turn the unit off. Should this occur, unplug the vacuum cleaner from the electrical outlet and turn off the switch. Remove the dirt container and empty. Clean the filters. Allow the cleaner to cool for approximately one (1) hour. To re-start, plug into an electrical outlet and switch back on.
!
Vax Careline: (UK) 0844 412 8455 (ROI) 1-800 928 308
Vax U90-P4 Series User Guide v1.4.qxd:UG 5/7/11 11:48 Page 3
4
assembly
3. How to Assemble
IMPORTANT: Always unplug the vacuum cleaner from the electrical outlet before assembling or
removing the accessories.
Tool required: Crosshead screwdriver
1. Push back panel onto base of unit. Insert hose storage
hook and secure in place with two screws provided (Fig.3/1).
2. Place the handle onto the back panel and push down firmly (Fig.3/2).
3. Insert the lock pin into the hole located at the bottom of the handle, and secure into place with the small screw provided (Fig.3/3).
4. Attach hose onto cleaner (Fig. 3/4) and place the dirt container onto the unit.
5. Store the TurboTool in the caddy on the handle
(Fig.3/5).
!
Crosshead screwdriver required
Fig.3/1
Fig.3/2
Fig.3/3
Fig.3/5
Fig.3/4
Back of
unit
vax.co.uk
(Some models only)
Vax U90-P4 Series User Guide v1.4.qxd:UG 5/7/11 11:48 Page 4
Loading...
+ 8 hidden pages