Energise Tempo
User Guide
U86-E1e Series
vax.co.uk
Contents
Contents
Machine Overview
General Safety Information
Getting Started
How to Use
Machine Overview
1
1 Handle
2 2-in-1 tool (crevice tool and dusting brush)
3 Brushbar height adjust
1
2
3
4
5
4 Cord wrap (hidden)
5 Separator
6 Dirt container
7 On/o button (hidden)
8 HEPA Media lter
9 Hose
10 TurboTool (some models only)
11 Tool Connector
12 TurboTool holder (some models only)
13 Hard oor adaptor
9
4
5
Looking After Your Machine
FAQs
Other Information
Guarantee
8
11
12
13
PLEASE NOTE: Some parts may vary according to
model. Please check inside ap of box for more details.
10
2
12
11
13
8
2
6
7
3
13
2vax.co.uk1
General Safety Information
This vacuum cleaner is intended for household use only and NOT for commercial or industrial use.
Please keep instructions for further use. When using the vacuum cleaner, basic safety precautions should always be observed,
including the following:
1. Do not leave the vacuum cleaner unattended when plugged in. Unplug the appliance from the socket when not in use.
2. Only use the vacuum cleaner indoors on dry surfaces.
3. Turn o the on/o switch on the vacuum cleaner controls before disconnecting or connecting from the mains supply.
4. Always unplug the vacuum cleaner before connecting or disconnecting the vacuum hose and accessories.
5. Children should be supervised to ensure that they do not play with the appliance.
6. This appliance is not intended for use by children under eight years of age and persons with reduced physical,
sensory or mental capabilities or lack of experience and knowledge, unless they have been given supervision or
instruction concerning use of the appliance in a safe way and understands the hazards involved.
7. Cleaning and maintenance shall not be made by children without supervision.
8. The appliance should only be used as described in the quick start guide or in the full online user guide.
9. Only Vax recommended attachments should be used with this appliance.
10. Do not use this vacuum cleaner if it has been dropped, damaged, left outdoors or dropped into water. Do not use
this vacuum cleaner with a damaged cord or plug. If the supply cord is damaged return the vacuum cleaner to a
Vax authorised Service Agent or a suitably qualied person for examination, repair or adjustment.
11. Do not pull or carry this appliance by the cord. Do not use the cord as a handle, close a door on the cord or pull
the cord around sharp edges or corners. Do not run the vacuum cleaner over the cord. Keep the cord away from
heated surfaces.
12. Do not handle the plug or the vacuum cleaner with wet hands.
13. Keep hair, loose clothing, ngers and all parts of the body away from openings and moving parts.
14. Do not vacuum any hot coals, cigarette butts, matches or any hot, smoking or burning objects.
15. Do not vacuum any ammable or combustible materials (lighter uid, petrol, kerosene etc.) or use in the presence
of explosive liquids or vapours.
16. Do not vacuum up harmful or toxic material (chlorine, bleach, ammonia, drain cleaner etc.)
17. Do not vacuum up hard or sharp objects such as glass, nails, screws, coins etc.
18. Store the vacuum cleaner in a cool, dry area.
19. Use only CE approved 13 amp extension cords. Non-approved cords may overheat. Care should be taken to arrange
the cord so that the cord cannot be tripped over.
20. Do not put any objects into openings. Do not use with any openings blocked and do not restrict airow.
Keep all openings free of dust, lint, hair or anything that might reduce airow.
21. Do not use without all of the lters in place.
22. Take extra care when vacuuming on the stairs.
23. Keep vacuuming area well lit.
PLEASE READ SAFETY INFORMATION BEFORE USE (p3)
Before plugging the cord into the electrical socket, make sure the switch is in the ‘o’ position.
Assembling your upright
Using a crosshead screwdriver,
remove the screw from the back of
the unit as shown.
Slide the handle down onto the
main body of the unit.
Getting Started
Return the screw and tighten,
securing the handle into the main
body of the unit.
Initial setup for normal operation
1. Use the base accessories.
a) Shortest hose
b) Extension tube set to shortest practicable length.
2. Clean lters installed.
3. Dust receptacle empty.
4. All Bleeds must be closed.
5. Variable Power set to Maximum.
6. Floor heads/tools set to Carpet Mode for carpet cleaning.
7. Mechanical Agitation turned ON for carpet cleaning.
8. Floor heads/tools set to Hard Floor Mode for hard
oor cleaning.
9. Mechanical Agitation turned OFF for hard oor cleaning.
Connect the upper hose to the
upper hose connector, rotate hose
clockwise to secure.
Wrap the hose around the machine
and insert the lower hose to the
lower hose connector.
Place the 2-in-1 tool into the
holder.
4vax.co.uk3
How to Use How to Use
Attaching the TurboTool holder
1
2
Attach the TurboTool holder to
handle. Then t the TurboTool to
the TurboTool holder.
Using the Hard Floor Adaptor
Apply the Hard Floor Adaptor for optimum results on hard oors.
The Hard Floor Adaptor can be used on any oor setting.
Operating the appliance
Twist the upper cord wrap to fully
unwrap the cord then plug the
unit into the electrical socket and
turn on.
IMPORTANT: Vax recommends
that you raise the height of
the brush bar to the hard oor
position when using this cleaner
on lino and hard oor due to
constant rotation. Vax cannot be
held responsible for damage to
these surfaces if the consumer
fails to take notice of this
recommendation.
Select a oor height setting by adjusting the
brush bar height.
High – long carpet pile.
Low – short carpet pile.
Hard oors – see ‘Using the Hard oor adaptor
Lie vacuum cleaner on its back
exposing brush bar
Align Hard Floor Adaptor with base
of vacuum cleaner, push until its
clicks into place
Place foot on the vacuum to
recline the vacuum body as
desired.
Place foot on the on/o button to
switch the vacuum cleaner on.
6vax.co.uk5
How to Use
Looking After Your Machine
Using the accessories
Pull out the lower hose from the
lower hose connector.
Choose an accessory.
Attach accessory to hose end
Emptying and cleaning the dirt container
Always switch o the appliance and unplug the mains socket before carrying out any maintenance.
Press dirt container release button
to remove the dirt container.
Hold dirt container over a bin and
press the dirt container latch to open,
allowing dirt to fall out.
Cleaning the separator
If required use tool connector
IMPORTANT: When the vacuum cleaner is stood in the upright position, or when using the hose and tools, the
brush bar height adjust must be set to the highest position.
To use the 2-in-1 dusting brush, push the tab and slide up the dusting
brush until it clicks into place.
Turn the lid of the dirt container
anticlockwise to remove.
Wipe the separator with a cloth to
remove any dirt.
8vax.co.uk7
Looking After Your Machine
Locking ring
Tabs
Tabs
Tabs
Looking After Your Machine
Cleaning the HEPA lter
IMPORTANT: It is very important to keep the lters clean to maintain maximum performance of the vacuum.
Vax recommend that your lters should be cleaned at least every 3 months (depending on the level of use).
Do not use detergent to clean the lters.
Turn the lid of the dirt container
anticlockwise to remove the lid.
Then turn the separator clockwise
to remove lter from the dirt
container lid.
Remove the HEPA central lter
from the separator.
Tap the HEPA central lter against a
bin to release dirt and then return to
the unit.
Clearing blockages
Hose blockages
The exible hose may be disconnected from the
vacuum cleaner. Carefully remove any blockages found
and reconnect the hose securely.
Accessory blockages
Remove accessory from the hose. Carefully remove
the blockage and return to the cleaner.
TurboTool blockages
Slide o the locking ring. To re-assemble the TurboTool,
Detach lower housing and remove
blockage.
ensure that the tabs are engaged
and pivot the lower housing
closed. Slip the locking ring over
the neck of the TurboTool and into
the groove to secure.
Replacing the belt
Turn unit over and remove the
six screws using a crosshead
screwdriver as indicated by arrows.
Remove the brushbar cover from
the base of the unit.
Lift the brush bar out of the base of
the unit. Next, remove the belt from
the brushbar and from the motor
spindle towards the rear of the oor
head. Replace the belt.
10vax.co.uk9
FAQs
Other Information
WARNING: To reduce the risk of personal injury, unplug the vacuum cleaner before performing
maintenance/troubleshooting checks.
Is there an accessory missing?
• Check the ‘Machine Overview’ page in this guide to make sure the part is denitely included in your unit.
• If it is missing, we’re here to help. Simply call us on 0844 412 8455
Why won’t the vacuum cleaner pick up?
• The lters may be clogged: Refer to the Maintenance sections (Page 5).
• The Dirt Container is full or blocked: Refer to the Maintenance sections (Page 5).
• The Dirt Container may be incorrectly installed: Refer to the Maintenance sections (Page 5).
Why is dust escaping from the vacuum?
• The lters may not be installed correctly. Refer to the Maintenance sections (Page 5).
• The Dirt container may be incorrectly installed: Remove the Dirt Container from the unit by pressing the Dirt Container
Release Button (6) and reattach it to the unit, ensuring it is locked rmly back into place.
• The lters may be clogged: Refer to the Maintenance sections (Page 5).
What do I do if an accessory/the unit becomes damaged or broken?
• Visit www.vax.co.uk for parts and spares.
• Please call our Vax careline to purchase new spares or order a replacement: 0844 412 8455
Why will the vacuum cleaner not run?
• It may not be plugged into the electrical socket correctly: Ensure that the plug is pushed into the electrical socket securely
• The electrical socket may not be working: Check the fuse or breaker and consult an electrician.
• The motor Thermostat may have tripped: Switch o and unplug the vacuum cleaner. Leave for one hour before switching
the vacuum cleaner back on.
UK Service & Help
Any queries or concerns about using your Vax, simply visit; vax.co.uk/support – vaxireland.ie or call the
Vax Careline. Calls are charged at the UK local rate. Please make a note of the serial number and model
number of the vacuum cleaner before calling.
Vax Careline:
(UK) 0844 412 8455
(ROI) 1-800 928 308
Monday-Friday 8.30am to 6.30pm
Saturday 9.00am to 5.00pm
Consumables
To purchase spares and accessories, please visit vax.co.uk
The use of genuine vax spare parts helps to maintain optimised
performance and validates your guarantee
Filter kit: (Type 94) 1-1-134293-00
Belt kit: (Type 17) 1-1-132048-00
Technical Specication
Voltage: 220-240V -50Hz
Wattage: 850W
Capacity: 2.4L
Cord length: 7m
Weight: 4.7kg (dependant on model)
Subject to technical change without notice.
EEC Statement of Compliance
Manufacturer/EEC importer: Vax Limited, hereby on our own responsibility, declare that the
U86-E1e Series is manufactured in compliance with the following Directives:
Safety: 2006/95/EC Low Voltage Directive
EMC: 2004/108/EC Electromagnetic Compatibility Directive
Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist.
Check with your Local Authority or retailer for recycling advice.
12vax.co.uk11
Guarantee
It’s quick and easy to register for your
FREE 2 year guarantee
Notes
online at: vax.co.uk/guarantees
Please retain your original receipt for proof of purchase.
UK based customer care centre — Open 6 days a week
Monday-Friday 8:30am-6:30pm
Saturday 9:00am-5:00pm
we’re here if you need us
Instead of taking me back to the shop, simply visit:
vax.co.uk/support or call (UK) 0844 412 8455 (ROI) 1-800 928 308
Let us know what you think @VaxUK
Designed in the UK
2
14vax.co.uk13
Vax Ltd., Kingswood Road, Hampton Lovett, Droitwich, Worcestershire, WR9 0QH, UK
email: info@vax.co.uk website: vax.co.uk
vax.co.uk
Loading...