Bagged Cylinder
Get Cleaning...
What’s your Vax’s model number?
What’s your serial number?
(Located on the base of the machine)
Note these down in case you need them in future. Please keep instructions for further use.
vax.com.au VBGSP1850
V B G S P 1 8 5 0
User Guide
Vax Careline: AU: 1300 361 505
NZ: 0800 800 900
Vax Service line: AU: 1300 361 505
NZ: 0800 800 900
vax.com.au 2
Machine Overview
Unit
Accessories Filters
15
1
3
2322
8
4
5
7 6
9
10
11
1 On/o button
2 Variable power
3 Cord rewind button
4 Bag full indicator
5 Carry handle
6 Lid release button
7 Hose inlet
8 Floor tool parking slot
9 Plug
10 Post motor lter cover
11 Wheel
12 Tool compartment lid
13 Tool compartment release
button
14 Power indicator LEDs
12 13214
16
17
20
19
21
15 Hose and handle
16 2-in-1 dusting brush/upholstery tool
17 Crevice tool
18 Large turbo tool
19 HEPA dust bag
(1pc tted, 2pc loose)
20 Telescopic extention tube
21 Hard oor tool
22 Pre motor lter
(Located inside the
dust bag cavity, behind the dust bag)
23 Post motor lter
(Located behind the exhaust lter cover)
18
General Safety Information
Vax Service line: AU: 1300 361 505
NZ: 0800 800 900
3
FOR HOUSEHOLD USE ONLY.
When using the vacuum cleaner, basic safety precautions should
always be observed, including the following:
1. Only use the vacuum cleaner indoors on dry surfaces.
2. Turn off the vacuum cleaner controls before disconnecting or
connecting from the mains supply.
3. Always unplug the vacuum cleaner before connecting or
disconnecting the vacuum hose and accessories.
4. Children should be supervised to ensure that they do not play
with the appliance.
5. This appliance is not intended for use by persons (including
children) with reduced physical, sensory or mental capabilities,
or lack of experience and knowledge, unless they have been
given supervision or instruction concerning use of the appliance
by a person responsible for their safety.
6. Use only as described in this manual. Use only Vax
recommended attachments.
7. Do not use the vacuum cleaner if it has been dropped, damaged,
left outdoors or dropped into water. Do not use the vacuum
cleaner with a damaged cord or plug.
8. Do not pull or carry by cord. Do not use the cord as a handle,
close a door on the cord or pull cord around sharp edges or
corners. Do not run the vacuum cleaner over the cord. Keep the
cord away from heated surfaces.
9. Do not handle the plug or vacuum cleaner with wet hands. Do
not use outdoors or on wet surfaces.
10. Do not put any objects into openings. Do not use with any
openings blocked and do not restrict airflow. Keep all openings
free of dust, lint, hair or anything that might reduce airflow.
11. Keep hair, loose clothing, fingers and all parts of the body away
from openings and moving parts.
12. Do not vacuum hot coals, cigarette butts, ash, matches or any
hot, smoking or burning objects.
13. Do not vacuum flammable or combustible materials (lighter fluid,
petrol, kerosene etc.) or use in the presence of explosive liquids
or vapours.
14. Do not vacuum harmful or toxic material (chlorine, bleach,
ammonia, drain cleaner etc.).
15. Do not vacuum plaster dust, concrete, or any other building
or vitreous materials.
16. Do not vacuum hard or sharp objects such as glass, nails,
screws, coins, etc.
17. Do not use without ALL of the filters and dust bag in place.
18. Take extra care when vacuuming on stairs.
19. Keep vacuuming area well lit.
20. Store the vacuum cleaner in a cool, dry area.
21. Turn off the on/off switch before unplugging the vacuum cleaner
22. Use only SAA-approved 10 amp extension cords. Non-approved
cords may overheat. Care should be taken to arrange the cord so
that the cord cannot be tripped over.
WARNING: Always switch off and unplug the vacuum
cleaner from the electrical outlet before assembling, opening
or emptying the dirt container, or before connecting/disconnecting
the attachments.
CAUTION: The vacuum cleaner is a very powerful unit.
Before plugging the cord into the electrical outlet, make sure
the switch is in the ‘off’ position.
IMPORTANT: If the inlet, hose or telescopic tube is blocked,
switch off the vacuum cleaner and remove the blockage(s)
before re-starting the vacuum cleaner. See Maintenance:
Clearing blockages.
IMPORTANT: Cleaning filters improves vacuum performance.
Vax recommends that they should be checked and cleaned
periodically (depending on the level of use). Make sure all filters are
completely dry before inserting back into the vacuum cleaner.
NOTE: If the supply cord is damaged it must be replaced by
the manufacturer, or a similarly qualified person in order to
avoid a hazard, or invalidating the warranty.
IMPORTANT: Vax recommends the use of a Residual Current
Device with a Residual Current Rating of 30mA or less.
IMPORTANT: The motor is equipped with a thermal cut-out.
If for any reason the unit should overheat, the thermostat will
automatically turn the unit off. Should this occur, unplug the vacuum
cleaner from the electrical outlet and turn off the switch. Remove
dirt container and empty. Clean filters. Allow the unit to cool for
approximately one (1) hour. To re-start, plug into an electrical outlet
and switch back on.
DAMAGE TO THE VACUUM CLEANER CAUSED AS A DIRECT
RESULT OF NOT ADHERING TO THE GENERAL SAFETY
INFORMATION ABOVE INVALIDATES THE WARRANTY.
This machine is intended for household use only, and NOT
for commercial or industrial use.
PLEASE KEEP THESE INSTRUCTIONS FOR FURTHER USE.
Loading...