Vax S4 Grime Master Get Started

Let’s get started
vax.co.uk
S4 series
S4 Grime Master
2
General Safety Information
Don’ts
1. Don’t touch any hot areas/accessories on the steamer. It’s normal for the steamer and accessories to heat up during use. Always turn off all controls and allow them to cool down before handling or changing.
2. Don’t leave the steamer plugged in when unattended.
3. Don’t use the steamer if it has been dropped, damaged, immersed in water or left outdoors.
4. Don’t run over the power cord or use steamer if the power cord or plug is damaged. Please contact our Customer Care Line on 0330 026 8455 (Mon-Fri 8.30am to 6.30pm, Sat 9.00am to 5.00pm).
5. Don’t handle the plug or use the steamer with wet hands.
6. Don’t pull or carry the steamer by the power cord. Don’t use the power cord as a handle, pull the power cord around corners, sharp edges or close a door over the power cord. Don’t unplug steamer by pulling on the power cord.
7. Don’t use the steamer without the tank cap in place, and ensure the tank cap is fully pushed down.
8. Don’t attempt to remove blockages with sharp objects as this may cause damage to the steamer.
9. Don’t aim the steamer at people, animals, plants and electrical components such as interior of ovens or wires. Never touch the steam jet or tools from a short distance (there is a risk of scalding).
10. Don’t use the steamer with incorrect voltage as this may result in damage or injury to the user. The correct voltage is listed on the ratings label.
3
General Safety Information
Do’s
1. Always fill the water tank with water only. Never add perfume, stain remover or products containing alcohol.
2. Always unplug and allow the steamer to cool down before carrying out any maintenance or refilling.
3. Always replace the fuse in the plug with a British 13amp fuse. Always protect the power cable from heated surfaces or near open flames.
4. Use only CE approved 13amp extension cords, non-approved extension cords may overheat. Care should be taken to arrange the extension cord as it could be a trip hazard.
5. Always carry the steamer by the handle.
6. Store the steamer in a cool, dry area. Before storing the steamer please ensure the water tank is thoroughly clean and dry.
PLEASE KEEP INSTRUCTIONS FOR FURTHER USE AND USE ONLY AS INSTRUCTED IN THIS GUIDE
4
General Safety Information
Basic safety precautions
This steamer is intended for household use only and NOT for commercial or industrial use
Only use the steamer indoors and keep the area you’re cleaning well lit.
Keep fingers, hair and loose clothing away from moving parts and openings whilst using the steamer.
This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved.
Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children without supervision.
Please refer to the surface manufacture’s care recommendations before use, and test over a small hidden area, if no damage occurs continue cleaning.
Not suitable for use on wax polished furniture, acrylic surfaces and synthetic, velvet or steam/water sensitive materials.
This steamer should not be used to clean electrical appliances such as microwaves, televisions and electrical heating systems etc.
Only Vax recommended tools should be used with the steamer.
Machine Overview
5
4
6
5
7
Unit
Accessories
2
3
1
10
9
14
11
1 Water tank 2 Nozzle 3 Variable steam dial 4 Water tank lid 5 Steam trigger 6 Steam trigger safety latch 7 Carry handle 8 LED indicator
a) Water heating/power on
(red LED)
b) Steam ready
(red LED) + (green LED)
9 Small brush
10 Concentration nozzle
11 Upholstery/clothes tool 12 Squeegee tool 13 Upholstery/clothes cloth 14 Measuring jug
13
12
8
b
a
Technical Specification Accessories & Consumables
Name Grime Master
Voltage 220 - 240V - 50Hz Water tank capacity 420ml (usable capacity 260ml) Wattage 1200w Cord length 3m Weight 1.3kg
Upholstery Cloth Kit
1-1-130746-00
Steam Cleaning Kit (Type 2)
1-1-132732-00
Getting Started
Operating your steam cleaner
6
C
AUTION: The nozzle gets very hot during use. Always switch off the steamer before emptying the water tank or changing the
cleaning accessories.
Do not open the water tank lid when using the steamer. The steamer is pressurised, do not remove lid when the tank is hot. F
ill tank only when cool.
I
MPORTANT: Please refer to surface manufacturer’s care recommendations before use and test the steamer on an hidden area
of surface to begin with. Test for colour fastness in a small hidden area of upholstery/fabric to check for colour removal b
efore use.
When using the steamer, basic safety precautions should always be observed. Don’t aim the steamer at people, animals, plants and electrical components such as interior of ovens or wires. Never touch the steam jet from a short distance (there is a risk of scalding). The steamer is equipped with a thermostat and a thermal cut-out. If for any reason the steamer overheats it will switch off. If this happens turn off and unplug the steamer, allow to cool for a least 2 to 4 hours Don’t use hot or boiling water to fill clean water tank.
Before you begin
1
2
3
NOTE: Do not over fill. (x1 jug only)
Place steamer on a level surface. Push down and twist water tank screw
cap anti-clockwise to remove.
Push down and twist water tank screw cap clockwise, until tightly fitted.
Plug into mains.
Fill measuring jug with maximum 260ml of water.
Slowly pour water into water tank, allowing space at the top.
7
Press steam trigger to release steam from the nozzle.
Slide steam trigger safety switch to the lock position.
Slide steam trigger safety switch to the unlock position.
The
RED LED will illuminate when
steamer on and water heating.
Within 5 minuets the GREEN LED will also illuminate. The steamer is ready to use
Turn steam dial to desired steam pressure setting.
Getting Started
Slide steam trigger safety switch to the lock position.
Allow the steamer to fully cool down and all pressure released. Push down and twist water tank screw cap anti-clockwise (the lid should turn freely to remove) Empty any excess water over the sink and allow to fully dry before storing away.
Unplug from the mains. Press the steam trigger to release excess pressure.
All cleaning pads are machine washable (Max 40°C) allow to fully dry before use.
40°c
Max
8
Refilling and Storing
Refilling and Storing
IMPORTANT: Always hold steam trigger down to release remaining steam pressure and allow the steamer to fully cool down before
c
arrying out any maintenance or refilling. Only clean the external surface of the steamer with a slightly damp cloth.
Taking care of your machine
The water tank should be treated with lime scale remover approximately every 6 months toprolong the steam cleaner’s life. When d
escaling the steamer follow lime scale remover instructions for 260ml capacity (using max 50°C water) then pour away liquid
and repeat process if necessary, rinse the water tank and allow to fully dry before storing away.
IMPORTANT: The steamer must have cooled down before refilling or storing.
TIP: Rinse the water tank out after 5 filling operations. Fill the water tank with water and giving it a good shake to loosen any lime
scale that has deposited on the bottom of the water tank. Empty water over a sink and allow to fully dry before storing away.
IMPORTANT: Never use bleach or fabric softener when washing the cleaning pad.
What to do if it goes wrong
CAUTION: to reduce the risk of personal injury, unplug the steamer and ensure unit has fully cooled down before performing maintenance/troubleshooting checks.
Is there an accessory missing?
• Check the ‘This pack contains’ panel on the box to make
sure the part is included with your machine.
The steamer has no power?
• The plug may not be fully pushed into the electrical socket.
• Check the fuse in the plug if this needs replacing, always
replace with a British 13amp fuse.
• The steamer is equipped with a thermostat and a thermal
cut-out. If for any reason the steamer overheats it will
switch off. If this happens turn off and unplug the steamer,
allow to cool for a least 2 to 4 hours.
Why is the steamer not producing steam?
• There may be no water in clean water tank, check the
clean water tank has water.
• Check the steam trigger safety latch has been unlocked
on the handle.
• Check the water tank has not been overfilled, there must
be a space in the tank for the water to heat. If overfilled
the steamer will delivery very little steam or
water droplets.
• The water may not yet be at temperature; the red and
green ready indicator lights will both be illuminated.
• Check the water tank does not have a build up of lime
scale. The water tank should be treated with lime scale
remover approximately every 6 months.
vax.co.uk/support
vaxireland.ie
or call:
(UK) 0330 026 8455
(ROI) 1-800 928 308
This does not aect your statutory rights
Instead of taking me back
to the shop, simply visit:
we’re here if you need us
9
10
Other Information
UK Service & Help
Vax Careline: (UK) 0330 026 8455 (ROI) 1-800 928 308
Monday-Friday 8.30am to 6.30pm Saturday 9.00am to 5.00pm
Any queries or concerns about using your Vax, call the Vax Careline. Calls are charged at the UK local rate. Please make a note of the serial number and model number of the steam cleaner before calling. For the nearest Service Agent, please call the Vax Careline or visit vax.co.uk
Consumables
To purchase spares and accessories, please visit vax.co.uk Upholstery cloth kit: 1-9-130146-00 Guarantee will only be valid with the use of genuine Vax spares and accessories.
Technical Specification
Wattage: 1200W Voltage: 220 - 240V - 50Hz Water tank capacity: 420ml (usable capacity 260ml) Weight: 1.3kg Cord length: 3m
Subject to technical change without notice.
S4 Grime Master User Guide v1.2- 28.02.13_User guide 02/09/2014 10:36 Page 10
11
* Calls are charged at the UK local rate. Please make a note of the serial number and model number of the steam cleaner before calling.
S4 Grime Master User Guide v1.2- 28.02.13_User guide 02/09/2014 10:36 Page 11
Vax Ltd., 5th Floor 2 Colmore Square, 38 Colmore Circus, Queensway, Birmingham, B4 6BN, UK email: info@vax.co.uk website: vax.co.uk
Version 1.0
EEC Statement of Compliance: Manufacturer/EEC importer: Vax Limited, hereby on our own responsibility, declare that the S4 series is manufactured in compliance with the following Directives. Safety: 2006/95/EC Low Voltage Directive EMC: 2004/108/EC Electromagnetic Compatibility Directive
Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist. Check with your Local Authority or retailer for recycling advice.
© 2014 All rights reserved. VAX®, VAX Lozenge, are trade marks or registered trade marks of Techtronic Floor Care Technology Ltd.
S4 Grime Master User Guide v1.2- 28.02.13_User guide 02/09/2014 10:36 Page 12
Loading...