Vax PowerMax VRS7W series Instruction Manual
vax.co.uk
Please read carefully before using this cleaner.
Always fully extend the mains cable before use.
Retain for future reference.
instruction manual
Carpet cleaner
Vax model number:
VRS7W series
Vax Careline: (UK) 0844 412 8455
(ROI) 1-800 928 308
Version 1.0
CaRPET CLEANER
VRS7W Series User Guide v1.0.qxd:User Guide 19/5/11 17:58 Page 1
2
parts overview
Fig.1/1
vax.co.uk
1. Diagram
1
7
4
6
8
9
5
3
2
7
11
10
12
13
1 Handle
2 Clean water tank release button
3 Clean water tank
4 Dirty water tank
5 Wheels
6 Static brushbar
7 Cord storage hooks
8 On/off switch
9 Recline pedal
10 Cord safety hook
11 Solution trigger (hidden)
12 Dirty water tank release
13 Clean water tank cap
VRS7W Series User Guide v1.0.qxd:User Guide 19/5/11 17:58 Page 2
3
safety information
2. Safety Information
FOR HOUSEHOLD USE ONLY.
When using the carpet cleaner, basic safety precautions
should always be observed, including the following:
1. Do not leave the carpet cleaner unattended when
plugged in. Unplug it from socket when not in use.
2. To prevent electric shock do not use outdoors.
3. Not tobe used as atoy. Children should be supervised to
ensure that they do not playwith the appliance.
4. This appliance is not intended for use by persons
(including children) with reduced physical, sensory or
mentalcapabilities,orlackof experience andknowledge,
unless they have been given supervision or instruction
concerning the use of the appliance by a person
responsible for their safety.
5. Use only as described in this manual.
6. Do not use the carpet cleaner with a damaged cord or
plug. If the supply cord or plug is damaged, it must be
replaced by the manufacturer or a recommended
Service Agent to avoid hazard and invalidating the
guarantee.
7. Do not pull or carry by the cord, use the cord as a
handle, allow the cord to come into contact with hot
or sharp surfaces or close a door on the cord.
8. Do not unplug by pulling on the cord.
9. Do not handle the plug or carpet cleaner with wet
hands.
10. Do not put any objects into openings or operate with
openings blocked, keep them free of anything that
may reduce airflow.
11. Keep hair, loose clothing, fingers and all parts of the
body away from openings and moving parts.
12. Do not use the carpet cleaner on any glowing,
burning or smoking particles.
13. Do not use without the clean and dirty water tanks in
place.
14. Turn off all controls before unplugging.
15. Do not use to pick up flammable or combustible
liquids such as petrol, or use in areas where they may
be present.
16. Keep the unit on the floor.
17. Do not use an extension cord.
18. Do not attempt to remove blockages with sharp
objects as they may cause damage.
19. Store indoors put away after use to prevent tripping
accidents.
20. Using improper voltage may result in damage to the
motor and possible injury to the user. The correct
voltage is listed on the rating label.
21. A hazard may occur if the carpet cleaner runs over
the power supply cord.
22. To prevent dirty water from running into motor, do
not hold the appliance upside-down or lay on its side.
Use appliance in normal vacuuming position.
23. Use extra care when cleaning on stairs.
24. Do not carry appliance while motor is running.
NOTE: Carpets should be dry vacuumed
thoroughly before washing.
NOTE: The unit must be unplugged from the
mains socket outlet after use, and before
cleaning or maintaining the unit.
IMPORTANT: This unit is not intended for
commercial use.
PLEASE KEEP THESE INSTRUCTIONS
FOR FURTHER USE.
!
Vax Careline: (UK) 0844 412 8455 (ROI) 1-800 928 308
!
!
VRS7W Series User Guide v1.0.qxd:User Guide 19/5/11 17:58 Page 3
vax.co.uk
4
assembly/ operation
3. Assembly
Putting your cleaner together
Insert body into machine base (Fig 3/1).
Insert one screw on either side of body to secure (Fig
3/2).
Slide the handle down onto the unit. The handle will click
and lock in place. (Fig 3/3).
Insert locking pins into both sides of handle (Fig 3/4).
Screw locking pins into handle (Fig 3/5).
Wrap cord around cord storage hooks.
4. Operation
IMPORTANT: Turn unit off when emptying and
filling tanks and performing any maintenance.
To remove clean water tank, press release button down
(Fig 4/1).
Tilt the clean water tank away from the cleaner and
remove (Fig 4/2).
Unscrew the cap from the back of the clean water tank
(Fig 4/3).
Pour the correct amount of Vax carpet cleaning solution
as directed on the label into the clean water tank.
Fig.3/3
Fig.4/1
Fig.4/2
Fig.4/3
!
Fig.3/2
Fig.3/1
Fig.3/4 Fig.3/5
VRS7W Series User Guide v1.0.qxd:User Guide 19/5/11 17:58 Page 4
Loading...