Vax power 9 series User Manual

Bagless Upright
power
9
Get Cleaning...
What’s your Vax model number? (Located on the top flap of the packaging)
What’s your serial number? (Located on the base of the machine)
User Guide
Vax Careline: (UK) 0844 412 8455
(ROI) 1-800 928 308
vax.co.uk
Power 9 series
e.g. U89 - P 9- B
U89-P9 Power 9 Series User Guide v1.0.qxd:User guide 12/5/11 19:08 Page 1
---
Machine Overview
Unit
Accessories
2
Filters
20
1
4
9
18
20
Vax Careline: (UK) 0844 412 8455
(ROI) 1-800 928 308
19
17
8
5
6
7
8
18
17
11
13
14
15
19
23
13
22
21
2
3
16
10
12
1
Handle
2
TurboTool caddy
(
some modelsonly)
3 Dirt container release button 4 Carry handle 5
Dirt container lid 6 Separator 7 Dirt container 8
Pre-motor filter housing 9
Brushbar height adjust
10 Cord storage hook
11 Cord 12 Cord safety hook 13 Hose storage 14 Power on/off button 15 Recline pedal 16 Hose 17 Extension tube 18 Crevice tool 19 Dusting brush
20 TurboTool
(somemodels only)
21 Flexi crevice tool (somemodels only)
22 Flat nozzle/upholstery tool
(somemodels only)
23 Pre-motor filter
PLEASE NOTE: some parts may vary according to model. Please check inside flap of box for more details.
U89-P9 Power 9 Series User Guide v1.0.qxd:User guide 12/5/11 19:08 Page 2
FOR HOUSEHOLD USE ONLY.
W
hen using the vacuum cleaner, basic safetyprecautions
should always be observed, including the following:
1. Only use the vacuum cleaner indoors on dry
s
urfaces.
2
. Turn off the vacuum cleaner controls before
d
isconnecting or connecting from the mains supply.
3
. Always unplug the vacuum cleaner before
c
onnecting or disconnectingthe vacuum hose and
accessories.
4. Childrenshould be supervised to ensure thatthey
do not playwith the appliance.
5. This appliance is not intended for use by persons
(including children) with reduced physical, sensory
or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or
instruction concerning use of the appliance by a
person responsible for their safety.
6. Use only as described in this manual. Use only Vax
recommended attachments.
7. Do not use the vacuum cleaner if it has been
dropped, damaged, left outdoors or dropped into
water. Do not use the vacuum cleaner with a
damaged cord or plug. If the supply cord is damaged, it
must be replaced by the manufacturer or a
recommended Service Agent to avoid hazard and
invalidating the guarantee.
8. Do not pull or carry by cord/hose. Do not use the
cord/hose as a handle, close a door on the cord/hose
or pull cord/hose around sharp edges or corners. Do
not run the vacuum cleaner over the cord/hose. Keep
the cord away from heated surfaces.
9. Do not handle the plug or vacuum cleaner with wet
hands. Do not use outdoors or on wet surfaces.
10. Do not put any objects into openings. Do not use
with any openings blocked and do not restrict air-
flow. Keep all openings free of dust, lint, hair or
anything that might reduce airflow.
11. Keep hair, loose clothing, fingers and all parts of
the body away from openings and moving parts.
12. Do not pick up hot coals, cigarette butts, matches
or any hot, smoking or burning objects.
13. Do not pick up flammable or combustible
materials (lighter fluid, petrol, kerosene etc.) or use
in the presence of explosive liquids or vapours.
14. Do not vacuum up harmful or toxic material
(chlorine, bleach, ammonia, drain cleaner etc.).
1
5. Do not vacuum up hard or sharp objects such as
g
lass, nails, screws, coins, etc.
1
6. Do not use without ALL of the filters in place.
17. Take extra care when vacuuming on stairs.
1
8. Keep vacuuming area well lit.
1
9. Store the vacuum cleaner in a cool, dry area.
2
0. Turn off the on/off switch before unplugging the
vacuum cleaner
21. Use only CE-approved 13 amp extension cords.
Non-approved cords may overheat. Care should
be taken to arrange the cord so that the cord
cannot be tripped over.
WARNING: Always switch off and unplug the
vacuum cleaner from the electrical outlet before
assembling, opening or emptying the dirt container, or before
connecting/disconnecting the attachments.
CAUTION: The vacuum cleaner is a very powerful
unit. Before plugging the cord into the electrical outlet,
make sure the switch is in the ‘off’ position.
IMPORTANT: If the inlet, hose or telescopic tube
is blocked, switch off the vacuum cleaner and
remove the blockage(s) before re-starting the vacuum
cleaner. See Maintenance; Clearing Blockages.
IMPORTANT: Cleaning filters maintains vacuum
performance. Vax recommends that your filters
should be checked and cleaned periodically. If your filters are
washable make sure they are completely dry before
inserting back into the vacuum cleaner.
IMPORTANT: The motor is equipped with a thermal
cut-out. If for any reason the unit should overheat, the
thermostat will automatically turn the unit off. Should this
occur, unplug the vacuum cleaner from the electrical outlet
and turn off the switch. Remove dirt container and empty.
Clean filters. Allow the unit to cool for approximately one (1)
hour. To re-start, plug into an electrical outlet and switch
back on.
This vacuum cleaner is intended for household use only and NOT for commercial or industrial use.
PLEASE KEEP INSTRUCTIONS FOR FURTHER USE.
!
General Safety Information
!!!
!
vax.co.uk
3
U89-P9 Power 9 Series User Guide v1.0.qxd:User guide 12/5/11 19:08 Page 3
---
Operation
Assembling your vacuum cleaner
4
Keep your Vax like new
IMPORTANT: The condition of the filters affects the
performance of your machine. Please check and clean filters periodically (depending on the level of use). For full cleaning instructions, see page 7.
!
IMPORTANT: Do not use the vacuum cleaner without all of the filters in place.
!
Vax Careline: (UK) 0844 412 8455
(ROI) 1-800 928 308
Push the lower back panel onto the base of the unit.
Secure with the two long screws provided.
Slide end of the hose into the hose connector.
Attach handle to the back panel by pushing down firmly.
Secure locking pin with the small screw provided.
Place pre-motor filter and holder onto the base of the unit.
Insert locking pin into place at the bottom of the handle.
Connect hose. Attach dirt container and click
into place.
2
1
U89-P9 Power 9 Series User Guide v1.0.qxd:User guide 12/5/11 19:08 Page 4
Operation
vax.co.uk
5
IMPORTANT: When the
vacuum cleaner is stood in the upright position or when using the hose and tools, the brushbar height adjust must be set to the highest position.
!
IMPORTANT: Vax recommends that you raise the height of the brushbar to the highest
position when using this cleaner on lino and hard flooring due to constant rotation. Vax cannot be held responsible for damage to these surfaces if the customer fails to take notice of this recommendation.
Operating the appliance
Twist cord storage hook to release cord.
Turn unit on.
Recline unit. In upright position turn brushbar
height adjust to desired setting.
High - long carpet pile and hard floors Low - short carpet pile
1
2
!
U89-P9 Power 9 Series User Guide v1.0.qxd:User guide 12/5/11 19:08 Page 5
---
Operation
6
Vax Careline: (UK) 0844 412 8455
(ROI) 1-800 928 308
NOTE: The crevice tool and TurboTool can be attached to both extension tube and hose directly. NOTE: The dusting brush can only be attached to the hose directly. NOTE: This unit has a constantly rotating brushbar. Vax recommends you raise the brushbar before
attaching accessories.
Using accessories
Attaching to hose
Remove hose from its holder and unwind hose from unit.
Choose an accessory. Attach accessory to hose.
Attaching to extension tube
Remove extension tube from holder.
Attach extension tube to hose. Attach accessory to
extension tube.
U89-P9 Power 9 Series User Guide v1.0.qxd:User guide 12/5/11 19:08 Page 6
---
8
Maintenance (Keep your Vax as good as new)
Vax Careline: (UK) 0844 412 8455
(ROI) 1-800 928 308
Advanced filter cleaning
t
a
p
Maintenance (Keep your Vax as good as new)
vax.co.uk
9
Removing blockages
WARNING: To reduce the risk of electric shock, turn the vacuum cleaner off and unplug from
the electrical outlet before performing maintenance/troubleshooting checks. Disconnect the
hose from the vacuum cleaner and remove any blockages found then reconnect the hose securely.
Removing blockages from the brushbar
!
Removing blockages from the TurboTool (some models only)
Turn the TurboTool over and slide off the locking ring.
Detach lower housing and remove blockage.
To re-assemble the TurboTool, ensure that the tabs are engaged and pivot the lower housing closed. Slip the locking ring over the neck of the TurboTool and into the groove to finish.
Locking
ring
Tabs
Unscrew the four screws on the base of unit.
Remove floor nozzle cover.
Lift brushbar. Remove the belt
from the end of the brushbar.
U89-P9 Power 9 Series User Guide v1.0.qxd:User guide 12/5/11 19:08 Page 9
---
10
FAQs
Vax Careline: (UK) 0844 412 8455
(ROI) 1-800 928 308
!
WARNING: to reduce the risk of personal injury, unplug the vacuum cleaner before performing maintenance/troubleshooting checks.
Is there an accessory missing?
Check the ‘Parts Overview’ page in this
guide to make sure the part is definitely included in your unit.
If it is missing, we’re here to help. Simply call us on 0844 412 8455
Why won’t the vacuum cleaner pick up?
The dirt container may be incorrectly
installed; remove the dirt container from the unit by pressing the dirt container release button and then re-attaching it to the unit, ensuring it is locked firmly back into place.
The filter may be clogged; refer to ‘Maintenance: Cleaning the filters’ on page 7.
The dirt container may be blocked; refer to ‘Maintenance: Emptying and cleaning the dirt container’ on pages 7 and 8.
There may be a blockage in the hose/tube; disconnect from the vacuum cleaner. Carefully remove any blockages found and reconnect securely.
Why is dust escaping from the vacuum?
The filter may be clogged; refer to
‘Maintenance: Cleaning the filters’ on pages 7 and 8.
The dirt container may be blocked; refer to ‘Maintenance: Emptying and cleaning the dirt container’ on page 7.
The dirt container may be incorrectly installed; remove the dirt container from the unit by pressing the dirt container release button and then re-attaching it to the unit, ensuring it is locked firmly back into place.
What do I do if the unit/an accessory becomes damaged or broken?
We’re here to help. Simply call 0844 412 8455 or visit vax.co.uk
Why won’t the accessories pick up properly?
• Hose blockages: remove the hose from
the unit. Carefully remove any blockages found and reconnect hose securely.
• Accessory blockages: remove accessory from handle/tube. Carefully remove blockage and re-attach to the vacuum cleaner.
The accessory may be faulty. Simply call us on 0844 412 8455 for assistance.
Why will the vacuum cleaner not run?
It may not be plugged into the electrical
outlet correctly; ensure that the plug is pushed in securely.
The electrical outlet may not be working properly; check the fuse or breaker, or consult an electrician.
The motor thermostat may have tripped; switch off and unplug the vacuum cleaner, and leave for one hour before switching the cleaner back on.
:
U89-P9 Power 9 Series User Guide v1.0.qxd:User guide 12/5/11 19:08 Page 10
vax.co.uk
11
Other Information
UK Service & Help
Vax Careline:
(UK) 0844 412 8455
(ROI) 1-800 928 308
Monday-Friday 8.30am to 6.30pm
Saturday-Sunday 9.00am to 5.00pm
Any queries or concerns about using your Vax, call the Vax Careline. Calls are charged at the UK local rate. Please make a note of the serial number and model number of the vacuum cleaner before calling. For the nearest Service Agent, please call the Vax Careline or visit vax.co.uk
Consumables
To purchase spares and accessories, please visit vax.co.uk
Type B pre-motor filter: 1-1-130851-00
Technical Specification
Voltage: 220-240V ~50Hz Wattage: 2300W Capacity: 5L Filters: pre-motor filter (washable) Cord length: 10m (approx) Weight: 8.7kg - 8.9kg (depending on model)
Subject to technical change without notice.
EEC Statement of Compliance
Manufacturer/EEC importer: Vax Limited, hereby on our own responsibility, declare that the U89-P9 series is manufactured in compliance with the following Directives:
Safety: 2006/95/EC Low Voltage Directive EMC: 2004/108/EC Electromagnetic Compatibility Directive
Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist. Check with your Local Authority or retailer for recycling advice.
U89-P9 Power 9 Series User Guide v1.0.qxd:User guide 12/5/11 19:08 Page 11
---
Vax Ltd., Kingswood Road, Hampton Lovett, Droitwich, Worcestershire, WR9 OQH, UK
email: info@vax.co.uk - website: vax.co.uk
Version 1.0
U89-P9 Power 9 Series User Guide v1.0.qxd:User guide 12/5/11 19:08 Page 12
Loading...