Vax Careline:
0870 6061248
Instruction Manual
Please read carefully before using
this cleaner. Always fully extend
the mains cable before use.
www.vax.co.uk
BAGGED CYLINDER VACUUM CLEANER
Vax Model Number: V-002
Vax V-002 mojo D6 bf 6/21/05 2:51 PM Page 1
1 Combination floor head
2 2 x Extension tube
3 Flexible hose
4 Hose grip/handle
5 Bag full indicator
6 Carry handle
7 Wheel
8 Crevice tool
9 Dusting brush
10 Top cover
11 Pre-motor filter
12 Paper dust bag
13 Cord rewind button
14 On/off button
15 Post-motor filter cover
16 Plug
17 Tool storage
18 Parking slot
1. Diagram
Parts Overview
2
Fig.1/1
FRONT
5
2
3
12
6
7
15
16
14
1
17
4
8
9
11
10
13
18
Vax V-002 mojo D6 bf 6/21/05 2:51 PM Page 2
Safety Information
3
2. Safety Information
FOR HOUSEHOLD USE ONLY.
When using the vacuum cleaner, basic safety
precautions should always be observed, including the
following:
1. Only use the vacuum cleaner indoors on dry
surfaces.
2. Turn off the vacuum cleaner controls before
connecting to or disconnecting from the mains
supply.
3. Always unplug the vacuum cleaner before
connecting or disconnecting the vacuum hose.
4. Close attention is necessary when used by
or near children. Do not allow children to use
as a toy.
5. Use only as described in this manual. Use only
the manufacturer’s recommended attachments.
6. Do not use the vacuum cleaner if it has been
dropped, damaged, left outdoors or dropped into
water. Do not use the vacuum cleaner with a
damaged cord or plug. If the supply cord or plug
is damaged, return the vacuum cleaner to a Vax
Authorised Service Agent or suitably qualified
person for examination, repair or adjustment.
7. Do not pull or carry by the cord. Do not use the
cord as a handle, close a door on the cord or pull
the cord around sharp edges or corners.
Do not run the vacuum cleaner over the cord.
Keep the cord away from heated surfaces.
8. Do not handle the plug or vacuum cleaner
with wet hands. Do not use outdoors or on
wet surfaces.
9. Do not put any objects into openings. Do not use
with any openings blocked and do not restrict air
flow. Keep all openings free of dust, lint, hair or
anything that may reduce airflow.
10. Keep hair, loose clothing, fingers and all parts
of the body away from openings and moving
parts.
11. Do not p ick up hot c oals, cigarette butts,
matches or any hot, smoking or burning objects.
12. Do not pick up flammable or combustible
materials (lighter fluid, petrol, kerosene, etc)
or use in the presence of explosive liquids
or vapours.
13. Do not vacuum up harmful or toxic material
(chlorine bleach, ammonia, drain cleaner, etc).
14. Do not vacuum up hard or sharp objects such as
glass, nails, screws, coins, etc.
15. Do not use without the filters in place.
16. Take extra care when vacuuming on stairs.
17. Keep vacuuming area well lit.
18. Store the vacuum cleaner indoors in a cool,
dry area.
19. Turn off the switch before unplugging.
20. Use only CE-approved 13 amp extension cords.
Non-approved extension cords may overheat.
Care should be taken to arrange the cord so that
the cord cannot be pulled or tripped over.
WARNING: Always switch off and unplug the
vacuum cleaner from the electrical outlet before
assembling, opening or emptying the dust bag, or
before connecting/disconnecting the attachments.
CAUTION: The vacuum cleaner is a very powerful
unit. Before plugging the cord into the outlet make
sure the switch is in the ‘off’ position. Hold the
vacuum cleaner firmly when starting and in use.
IMPORTANT: If the inlet or hose is blocked, switch
off the vacuum cleaner and remove the blockage(s)
before re-starting the vacuum cleaner.
IMPORTANT: Washing filters and changing the dust
bag improves vacuum performance. Make sure all
filters are completely dry before inserting back into the
vacuum cleaner.
This vacuum cleaner is intended for household use
only and not for commercial or industrial use.
PLEASE KEEP THESE INSTRUCTIONS FOR
FURTHER USE.
Motor Thermostat
IMPORTANT: The motor is equipped with a thermal
cut-out. If for any reason, the vacuum cleaner should
over-heat, the thermostat will automatically turn the
unit off. Should this occur, unplug the vacuum cleaner
from the wall outlet and turn off the switch. Remove
the dirt container and empty. Clean the filters. Allow
the cleaner to cool for approximately one (1) hour.
To re-start, plug into a wall outlet and switch back on.
Vax V-002 mojo D6 bf 6/21/05 2:51 PM Page 3
On/off Button
Plug the cord in to the electrical outlet. Turn the
vacuum cleaner on by depressing the button located
on the top left side of the vacuum cleaner (Fig.4/1).
The vacuum cleaner can be turned off by pressing the
on/off button again.
Carpet Cleaning
For carpet and rug cleaning, press the rocker switch
on the combination floor tool to raise the brushes
(Fig.4/2).
Hard Floor Cleaning
For hard floor cleaning, press the rocker switch on
the combination floor tool to lower the brushes
(Fig.4/2).
Cord Rewind
After use, turn the vacuum cleaner off and unplug from
the electrical outlet. Press the button for the cord
rewind to draw the power cord automatically (Fig.4/3).
How to Assemble/How to Operate
4
Fig.4/3
3. How to Assemble
IMPORTANT: Always unplug the vacuum cleaner
from the electrical outlet before assembling or
removing the accessories.
1. Insert the flexible hose into the inlet on the main
body of the vacuum cleaner. Push in until it clicks
into position (Fig.3/1).
2. Join the extension tubes together and push on to
the end of the handle (Fig.3/2).
3. Fit the combination floor tool by pushing it on to
the extension tube (Fig.3/3).
4. How to Operate
Cord Release
Fully unwind the power cord. A yellow mark on the
power cord indicates the recommended cord length.
Do not exceed the cord length beyond the red mark.
Fig.4/1
Fig.3/1
Fig.3/2
Fig.3/3
Fig.4/2
Vax V-002 mojo D6 bf 6/21/05 2:51 PM Page 4
5
Carry Handle
Use the carry handle located on the top of the
vacuum cleaner to move from room to room.
(Fig.4/4).
Hose Storage
1. For convenience there is a slot located at the
back of the vacuum cleaner where the floor tool
and hose can be parked for carrying and
storage.
2. For storage, the vacuum cleaner can also be
stood in an upright position. Another slot is
located on the underside of the cleaner to park
the floor tool and hose using the hook on the onhose tool storage.
5. Accessories
1. The accessories can be attached directly to the
handle by removing the tubes and floor head
tubes and pushing in the desired accessory
(Fig.5/1).
2. The accessories can also be attached to one or
two extension tubes for extra reach. Remove
the combination floor tool and push on the
desired accessory.
Crevice tool: For crevices, corners, cracks etc.
Dusting brush: Push the brush section securely on
to the end of the crevice tool. For delicate surfaces
and skirting boards.
How to Operate/Accessories/Dust Bag & Filters: Removal & Replacement
Fig.4/4
6. Dust Bag & Filters:
Removal & Replacement
IMPORTANT: Always unplug the vacuum cleaner
from the electrical outlet before removing the dust
bag.
IMPORTANT: Do NOT use the vacuum cleaner
without ALL of the filters in place.
IMPORTANT: The vacuum cleaner is equipped with
a dust bag indicator. If the indicator turns red, the
bag will need to be changed.
1. Turn off the vacuum cleaner and unplug from
the electrical outlet. Lift up the top cover to gain
access to the dust bag compartment (Fig.6/1).
2. Push in the tab to unlock the bag from position
and lift out (Fig.6/2).
3. Dispose of the full dust bag and insert a new
dust bag. Click into place, then close the top
cover.
Pre-motor Filter
1. Turn off the vacuum cleaner and unplug from the
electrical outlet. Lift up the top cover to gain
access to the dust bag compartment.
Fig.6/1
Fig.5/1
Fig.6/2
Vax V-002 mojo D6 bf 6/21/05 2:51 PM Page 5
7. Clearing Blockages
WARNING: To reduce the risk of electric shock, the
power cord must be disconnected before
performing maintenance/troubleshooting checks.
1. Switch the vacuum cleaner off and disconnect
the power plug from the electrical outlet.
2. The flexible hose can be disconnected from the
vacuum cleaner by pushing in the button on the
hose and pulling away from the machine
(Fig.7/1). Remove any blockages found then
reconnect the hose securely.
8. Storage
IMPORTANT: Always unplug the vacuum cleaner
from the electrical outlet and rewind the power cord
as directed before storing.
NOTE: Always store the cleaner upright or base
down.
Fig.7/1
2. Lift out the pre-motor filter situated at the back of
the compartment (Fig.6/3). Wash the filter by
running it under the tap in lukewarm (max 40ºC)
water. Vax recommends washing the filter when it
is discoloured or clogged. This should be
checked every time the dust bag is replaced.
Always allow the filter to air dry for 24 hours
before replacing into the cleaner.
Post-motor (exhaust) Filter
1. Turn off the vacuum cleaner and unplug from the
electrical outlet.
2. Located at the rear of the vacuum cleaner is the
post-motor filter which can also be removed and
washed.
3. Push down on the latch to release the postmotor filter cover (Fig.6/4).
4. Remove the post-motor filter and wash by
running it under the tap in lukewarm (max 40ºC)
water. Vax recommends washing the filter every
6-9 months. Always allow the filter to air dry for
24 hours before replacing back into the cleaner.
Dust Bag & Filters: Removal & Replacement/Clearing Blockages/Storage
6
Fig.6/4
Fig.6/3
Vax V-002 mojo D6 bf 6/21/05 2:51 PM Page 6
9. Troubleshooting
WARNING: TO REDUCE RISK OF PERSONAL INJURY, UNPLUG VACUUM CLEANER BEFORE
SERVICING
PROBLEM: Cleaner won’t run
Cause: Not properly plugged into electrical outlet.
Solution: Plug in firmly.
Cause: No electricity in electrical outlet.
Solution: Check fuse or breaker.
Cause: On/off switch not turned on.
Solution: Push on/off switch to on.
Cause: Motor thermostat has tripped.
Solution: Switch off and unplug cleaner. Leave for one (1) hour before switching the cleaner back on.
Cause: Blown fuse/tripped breaker.
Solution: Reset circuit breaker or replace fuse.
PROBLEM: Vacuum cleaner won't pick up/loss of suction
Cause: Dust bag not installed correctly.
Solution: Review dust bag removal and replacement.
Cause: Dust bag full or blocked.
Solution: Replace dust bag.
Cause: Clogged filter.
Solution: Remove filter and clean.
Cause: Blockage in hose.
Solution: Disconnect hose, remove obstruction and then re-fit.
PROBLEM: Accessories won't pick up
Cause: Accessories not attached correctly.
Solution: Refer to page 5 for fitting information.
PROBLEM: Dust escaping from the vacuum cleaner
Cause: Dust bag full.
Solution: Dispose of dust bag and replace with a new one.
Cause: Dust bag not installed correctly.
Solution: Review dust bag removal and replacement.
Cause: Hose not installed correctly.
Solution: Review hose installation.
Cause: Filter not installed completely.
Solution: Review filter removal and replacement.
Troubleshooting
7
Vax V-002 mojo D6 bf 6/21/05 2:51 PM Page 7
UK Service & Help/Technical Specification
8
11. Technical Specification
Voltage: 220-240V ~50Hz
Wattage: 1400W
Capacity: 0.8 litres max
Filters: Fibre pre-motor filter
Fibre post-motor filter
Cord length: 4.5m
Weight: 4.2kg
Subject to technical change without notice.
10. UK Service & Help
Vax Care 0870 6061248
Monday-Friday 9.00am to 5.00pm.
An answerphone is available out of these hours.
Any queries or concerns about using the Vax, call
the Vax Careline. Calls are charged at the UK national
rate.
Please make a note of the serial number and model
number of the carpet cleaner before calling. There are
over 400 approved Vax Service Agents in the UK. For
the nearest Service Agent, please call the Vax Careline.
www.vax.co.uk
Vax V-002 mojo D6 bf 6/21/05 2:51 PM Page 8
This page has been intentionally left blank.
9
Vax V-002 mojo D6 bf 6/21/05 2:51 PM Page 9
10
This page has been intentionally left blank.
Vax V-002 mojo D6 bf 6/21/05 2:51 PM Page 10
11
This page has been intentionally left blank.
Vax V-002 mojo D6 bf 6/21/05 2:51 PM Page 11
EEC STATEMENT OF COMPLIANCE
Manufacturer/EEC importer: Vax Limited, hereby on our own responsibility, declare that the product
V-002 Mojo II is manufactured in compliance with the following:
Safety: 73/23/EEC Low Voltage Directive, as modified by 93/68/EEC
EMC: 89/336/EEC Electromagnetic Compatibility Directive, as modified by 93/68/EEC
Waste electrical products should not be disposed of with household waste. Please recycle where
facilities exist. Check with your Local Authority or retailer for recycling advice.
Vax Ltd., Kingswood Road, Hampton Lovett, Droitwich, Worcestershire, WR9 OQH, UK
email: info@vax.co.uk - website: www.vax.co.uk
Version 1
Vax V-002 mojo D6 bf 6/21/05 2:51 PM Page 12
Loading...