---
Vax Ltd., Kingswood Road, Hampton Lovett, Droitwich, Worcestershire, WR9 OQH, UK
email: info@vax.co.uk - website: vax.co.uk
Version 1.0
Vax U88-M8-B UG V1.0 [J149] [12.03.12]_User guide 12/03/2012 14:32 Page 12
– – – – –
Get Cleaning...
What’s your Vax model number? (Located on the top flap of the packaging)
What’s your serial number? (Located on the base of the machine)
Note these down in case you need them in future. Please keep instructions for further use.
e.g. U8 8 -M 8 -B
vax.co.uk
Bagless Upright
Mach 8
Vax Careline: (UK) 0844 412 8455
(ROI) 1-800 928 308
User Guide
Mach 8
Vax U88-M8-B UG V1.0 [J149] [12.03.12]_User guide 12/03/2012 14:32 Page 1
---
Unit
Accessories Filters
2
1
10
11
Machine Overview
2
Vax Careline: (UK) 0844 412 8455
(ROI) 1-800 928 308
1
Handle
2 Extension tube
3 Dirt container release button
4
Carry handle
5 Dirt container lid
6 Separator
7
Dirt container
8
Brushbar height adjust
9 Blockage indicator
10 Pre-motor filter (hidden)
11 Post motor filter (hidden)
12 Hose release button
13 Cord safety hook
14 Hose storage
15 Hose
16 Extension tube release button (hidden)
17 Cord storage hook
18 Cord
19 Power on/off button
20 2-in-1 tool (crevice tool & dusting brush)
PLEASE NOTE: some parts may vary
according to model. Please check inside flap
of box for more details.
1
3
16
3
4
5
6
7
10
11
8
18
12
15
14
19
1
9
20
12
17
17
20
2
Vax U88-M8-B UG V1.0 [J149] [12.03.12]_User guide 12/03/2012 14:32 Page 2
FOR HOUSEHOLD USE ONLY.
W
hen using the vacuum cleaner, basic safety precautions should always
be observed, including the following:
1. Only use the vacuum cleaner indoors on dry surfaces.
2. Turn off the vacuum cleaner controls before disconnecting or
connecting from the mains supply.
3. Always unplug the vacuum cleaner before connecting or
disconnecting the vacuum hose and accessories.
4. Children should be supervised to ensure that they do not play with
t
he appliance.
5. This appliance is not intended for use by persons (including
children) with reduced physical, sensory or mental capabilities,
or lack of experience and knowledge, unless they have been
given supervision or instruction concerning use of the appliance
by a person responsible for their safety.
6. Use only as described in this manual. Use only Vax
recommended attachments.
7. Do not use the vacuum cleaner if it has been dropped, damaged,
left outdoors or dropped into water. Do not use the vacuum
cleaner with a damaged cord or plug. If the supply cord is
damaged, it must be replaced by the manufacturer or a
recommended Service Agent to avoid hazard and invalidating
the guarantee.
8. Do not pull or carry by cord/hose. Do not use the cord/hose as
a handle, close a door on the cord/hose or pull cord/hose
around sharp edges or corners. Do not run the vacuum cleaner
over the cord/hose. Keep the cord away from heated surfaces.
9. Do not handle the plug or vacuum cleaner with wet hands.
Do not use outdoors or on wet surfaces.
10. Do not put any objects into openings. Do not use with any
openings blocked and do not restrict air-flow. Keep all openings
free of dust, lint, hair or anything that might reduce airflow.
11. Keep hair, loose clothing, fingers and all parts of the body away
from openings and moving parts.
12. Do not pick up hot coals, cigarette butts, matches or any hot,
smoking or burning objects.
13. Do not pick up flammable or combustible materials (lighter fluid,
petrol, kerosene etc.) or use in the presence of explosive liquids
or vapours.
14. Do not vacuum up harmful or toxic material (chlorine, bleach,
ammonia, drain cleaner etc.).
15. Do not vacuum up hard or sharp objects such as glass, nails,
screws, coins, etc.
16. Do not use without ALL of the filters in place.
1
7. Take extra care when vacuuming on stairs.
18. Keep vacuuming area well lit.
1
9. Store the vacuum cleaner in a cool, dry area.
2
0. Turn off the on/off switch before unplugging the vacuum cleaner
21. Use only CE-approved 13 amp extension cords. Non-approved
cords may overheat. Care should be taken to arrange the cord
so that the cord cannot be tripped over.
WARNING: Always switch off and unplug the vacuum
c
leaner from the electrical outlet before assembling,
opening or emptying the dirt container, or before
connecting/disconnecting the attachments.
CAUTION: The vacuum cleaner is a very powerful unit.
Before plugging the cord into the electrical outlet, make
sure the switch is in the ‘off’ position.
IMPORTANT: If the inlet, hose or extension tube is blocked,
switch off the vacuum cleaner and remove the blockage(s)
before re-starting the vacuum cleaner. See Maintenance; Clearing
Blockages.
IMPORTANT: Cleaning filters maintains vacuum
performance. Vax recommends that your filters should be
checked and cleaned periodically. If your filters are washable make
sure they are completely dry before inserting back into the vacuum
cleaner.
IMPORTANT:
The motor is equipped with a thermal cut-out.
If for any reason the unit should overheat, the thermostat
will automatically turn the unit off. Should this occur, unplug the
vacuum cleaner from the electrical outlet and turn off the switch.
Remove dirt container and empty. Clean filters. Allow the unit to cool
for approximately one (1) hour. To re-start, plug into an electrical
outlet and switch back on.
This vacuum cleaner is intended for household use only and NOT
for commercial or industrial use.
PLEASE KEEP INSTRUCTIONS FOR FURTHER USE.
!!!!!
General Safety Information
vax.co.uk
3
Vax U88-M8-B UG V1.0 [J149] [12.03.12]_User guide 12/03/2012 14:32 Page 3
---
Assembling the appliance
4
Vax Careline: (UK) 0844 412 8455
(ROI) 1-800 928 308
Operation
IMPORTANT: When the
vacuum cleaner is stood in
the upright position, or when using
the hose and tools, the brushbar
height adjust must be set to the
highest position.
!
IMPORTANT: Vax recommends that you raise the height of the brushbar to the highest position when using
this cleaner on lino and hard flooring due to constant brushbar rotation. Vax cannot be held responsible for
damage to these surfaces if the customer fails to take notice of this recommendation.
Insert handle into main unit. Push
down until handle locks into place.
To remove, press handle release
button.
Push 2-in-1 tool into storage area on
the back of the main unit.
Twist cord storage hook to release
cord.
Turn unit on.
Place foot on floor nozzle and pull
back machine to recline into
operating position
In upright position turn brushbar
height adjust to desired setting.
High - long carpet pile and hard floors
Low - short carpet pile
!
Operating the appliance
Vax U88-M8-B UG V1.0 [J149] [12.03.12]_User guide 12/03/2012 14:32 Page 4
vax.co.uk
5
NOTE: The 2-in-1 tool can only be attached to the extension tube.
NOTE: This unit has a constantly rotating brushbar. Vax recommends you raise the brushbar to the highest setting
before attaching accessories.
Using accessories
Attaching to extension tube
Remove hose from its holder and
unwind hose from unit.
Press the extension tube release
button and remove tube from holder.
Attach hose to extension tube.
For crevice tool, slide brush
downwards until it clicks into place.
For dusting brush, slide brushes
upwards until it snaps into place.
Operation
Vax U88-M8-B UG V1.0 [J149] [12.03.12]_User guide 12/03/2012 14:32 Page 5
---
6
Vax Careline: (UK) 0844 412 8455
(ROI) 1-800 928 308
Maintenance (Keep your Vax as good as new)
Emptying the dirt container
Cleaning the HEPA pre-motor filter
!
40° C
max
24hr
Keep your Vax like new
IMPORTANT: The condition of the filters affects the performance of your machine.
Please check and wash filters periodically (depending on the level of use).
IMPORTANT: Do not use the vacuum cleaner without all of the filters in place.
!
!
Cleaning the separator
Vax U88-M8-B UG V1.0 [J149] [12.03.12]_User guide 12/03/2012 14:32 Page 6
vax.co.uk
7
Maintenance (Keep your Vax as good as new)
Cleaning the post-motor
24hr
!
40° C
m
ax
Vax U88-M8-B UG V1.0 [J149] [12.03.12]_User guide 12/03/2012 14:32 Page 7
---
Identification and removal of blockages
WARNING: To reduce the risk of electric shock, turn the vacuum cleaner off and unplug from the electrical
outlet before performing maintenance/troubleshooting checks.
!
Removing blockages from the brushbar
8
Vax Careline: (UK) 0844 412 8455
(ROI) 1-800 928 308
Maintenance (Keep your Vax as good as new)
Unscrew the six screws on
the base of the unit.
Remove floor nozzle cover. Lift brushbar. Remove the belt from the
end of the brushbar.
The blockage indicator will change in colour from green to red should a blockage
occur. Disconnect the hose from the vacuum cleaner and remove any blockages found
then reconnect the hose securely. Refer to FAQs for further possible causes and
solutions.
Vax U88-M8-B UG V1.0 [J149] [12.03.12]_User guide 12/03/2012 14:32 Page 8
6
6
6
6
---
UK Service & Help
Vax Careline:
(UK) 0844 412 8455
(ROI) 1-800 928 308
Monday - Friday 8.30am to 6.30pm
Saturday - Sunday 9.00am to 5.00pm
If you have queries or concerns about using your Vax, call the Vax Careline. Calls are charged at the UK local rate.
Please make a note of the serial number and model number of the vacuum cleaner before calling. For the nearest
Service Agent, please call the Vax Careline or visit vax.co.uk
Consumables
To purchase spares and accessories, please visit vax.co.uk
Type 42 Filter Kit: 1-1-131746-00
Technical Specification
Voltage: 220-240V ~50Hz
Wattage: 1500W
Capacity: 1.1L
Filters: Pre-motor filters (washable) / Post motor (washable)
Cord length: 6m (approx)
Weight: 5.6 kg
Subject to technical change without notice.
EEC Statement of Compliance
Manufacturer/EEC importer: Vax Limited, hereby on our own responsibility, declare that the U88-M8 series is
manufactured in compliance with the following Directives:
Safety: 2006/95/EC Low Voltage Directive
EMC: 2004/108/EC Electromagnetic Compatibility Directive
Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist.
Check with your Local Authority or retailer for recycling advice.
10
Vax Careline: (UK) 0844 412 8455
(ROI) 1-800 928 308
Other Information
Vax U88-M8-B UG V1.0 [J149] [12.03.12]_User guide 12/03/2012 14:32 Page 10
vax.co.uk
11
Notes
Vax U88-M8-B UG V1.0 [J149] [12.03.12]_User guide 12/03/2012 14:32 Page 11
Loading...