vax.co.uk
Please read carefully before using this cleaner.
Always fully extend the mains cable before use.
Retain for future reference.
instruction manual
Bagless upright
Vax model number:
U90-M3 series
U90-M4 series
Version 1.4
Vax Careline: (UK) 0844 412 8455
(ROI) 1-800 928 308
WARNING: This cleaner has a constantly
rotating brushbar which, when left in
contact with lino, parquet and other hard flooring
could potentially cause some damage to the floor
surface.
NOTE: Vax recommends that you raise the height
of the brushbar when using this cleaner on lino and
hard flooring. Vax cannot be held responsible for
damage to these surfaces if the user fails to take
notice of this recommendation.
!
U90-M3 & M4 Series User Guide v1.4.qxd:UG 15/7/10 15:36 Page 1
1. Diagram
vax.co.uk
2
parts overview
1
1 Handle grip
2 On/off switch
3 Telescopic handle
4 Handle release button
5 Carry handle
6 Dirt container release button
7 Dirt container assembly
8 Dirt container hinge
9 Stair cleaning handle
(located below edge of dirt container)
10 Headlight
11 Carpet height adjuster
(located on back of dirt container)
12 Furniture guard
13 Hose handle
14 2-in-1 tool
15 TurboTool
16 Hose
17 Hose/tool holder
18 Extension tubes
19 Crevice tool
20 Quick release cord hooks
21 Handle release pedal
22 Hard floor tool
(Some models only)
23 Additional stretch hose
(Some models only)
Fig.1/1
16
8
7
9
10
11
12
14
13
17
15
14
20
19
18
21
20
15
4
5
6
3
2
U90-M3 / U90-M4
2
2
2
3
PLEASE NOTE: some parts may vary according to model. Please check inside flap of box for more details.
U90-M3 & M4 Series User Guide v1.4.qxd:UG 15/7/10 15:36 Page 2
3
safety information
Vax Careline: (UK) 0844 412 8455 (ROI) 1-800 928 308
2. Safety Information
For Household Use Only
When using the vacuum cleaner,basic safety precautions
should always be observed, including the following:
1. Only use the vacuum cleaner indoors on dry surfaces.
Do not handle the plug or vacuum cleaner with wet
hands. Do not use outdoors or on wet surfaces.
2. Turn off the vacuum cleaner controls before
disconnecting or connecting from the mains supply.
3. Always unplug the vacuum cleaner before
connecting or disconnecting the hose and
accessories.
4. Children should be supervised to ensure that they do
not play with the appliance.
5. This appliance is not intended for use by persons
(including children) with reduced physical, sensory or
mental capabilities, or lack of experience and
knowledge, unless they have been given supervision
or instruction concerning use of the appliance by a
person responsible for their safety.
6. Use only as described in this manual. Use only Vax
recommended attachments.
7. Do not use the vacuum cleaner if it has been
dropped, damaged, left outdoors or dropped into
water. Do not use the vacuum cleaner with a
damaged cord or plug. If the supply cord is damaged,
it must be replaced by the manufacturer or a
recommended Service Agent to avoid hazard and
invalidating the guarantee.
8. Do not pull or carry by cord/hose. Do not use the
cord/hose as a handle, close a door on the cord/hose
or pull cord/hose around sharp edges or corners. Do
not run the vacuum cleaner over the cord/hose. Keep
the cord away from heated surfaces.
9. Do not put any objects into openings. Do not use
with any openings blocked and do not restrict
airflow. Keep all openings free of dust, lint, hair or
anything that might reduce airflow.
10. Keep hair, loose clothing, fingers and all parts of the
body away from openings and moving parts.
11. Do not pick up hot coals, cigarette butts, matches or
any hot, smoking or burning objects.
12. Do not pick up flammable or combustible materials
(lighter fluid, petrol, kerosene etc.) or use in the
presence of explosive liquids or vapours.
13. Do not vacuum up harmful or toxic material (chlorine,
bleach, ammonia, drain cleaner etc.).
14. Do not vacuum up hard or sharp objects such as
glass, nails, screws, coins, etc.
15. Do not use without ALL of the filters in place.
16. Take extra care when vacuuming on stairs.
17. Keep vacuuming area well lit.
18. Store the vacuum cleaner in a cool, dry area.
19. Turn off the on/off switch before unplugging the
vacuum cleaner
20. Use only CE-approved 13 amp extension cords. Nonapproved cords may overheat. Care should be taken
to arrange the cord so that the cord cannot be
tripped over.
WARNING: Always switch off and unplug the
vacuum cleaner from the electrical outlet
before assembling, opening or emptying the dirt
container, or before connecting/disconnecting the
attachments.
CAUTION: The vacuum cleaner is a very
powerful unit. Before plugging the cord into
the electrical outlet, make sure the switch is in the
‘off’ position. Hold the vacuum cleaner firmly when
starting and in use.
IMPORTANT: If the inlet, hose or extension
tube is blocked, switch off the vacuum cleaner
and remove the blockage(s) before re-starting the
vacuum cleaner.
IMPORTANT: Cleaning filters regularly
maintains vacuum performance. Make sure all
filters are replaced back into the vacuum cleaner
before using.
This vacuum cleaner is intended for household use
only and not for commercial or industrial use.
PLEASE KEEP THESE INSTRUCTIONS FOR
FURTHER USE.
!!!
!
Motor Thermostat
IMPORTANT: The motor is equipped with a
thermal cut-out. If for any reason, the
vacuum cleaner should over-heat, the thermostat
will automatically turn the unit off. Should this
occur, unplug the vacuum cleaner from the
electrical outlet and turn off the switch. Remove
the dirt container and empty. Clean the filters.
Allow the cleaner to cool for approximately one
(1) hour. To re-start, plug into an electrical outlet
and switch back on.
!
U90-M3 & M4 Series User Guide v1.4.qxd:UG 15/7/10 15:36 Page 3
vax.co.uk
4
assembly
3. How to assemble
Attach Handle
Grasp orange tie wrap and pull until the black plug comes
out of the handle cavity (Fig.3/1).
Hold plug with one hand; upper handle with the other
hand. Push plug into upper handle, aligning with opposite
end of plug and push firmly until you hear a snap or click
(Fig.3/2). After ends are connected, pull on plug to make
sure it is securely attached.
Align the groove on the back of the upper handle with
the small projection on the back of the handle housing.
Push upper handle down until you hear a click (Fig.3/3).
Press button at handle base and push handle all the way
down (Fig.3/4).
Adjusting Handle
For convenience in storing or carrying your cleaner, the
handle is designed to retract into the body of the cleaner.
Lower the handle by depressing the button located at the
handle base and pushing the handle down. Raise the
handle by depressing the button and pulling the handle
upward, locking it into the desired position (Fig.3/5).
Transporting Cleaner
To move your cleaner from room to room, put handle in
upright position, tilt cleaner back on rear wheels and push
forward (Fig.3/6).
Fig.3/1
Fig.3/2
Fig.3/3
Fig.3/4
Fig.3/5
Fig.3/6
U90-M3 & M4 Series User Guide v1.4.qxd:UG 15/7/10 15:36 Page 4
5
operation
4. How to operate
Carrying Cleaner
The cleaner can also be moved by using the carrying
handle (Fig.4/1).
Handle Positions
The handle of your cleaner has three positions; upright
for storage and when using cleaning tools; operating
position for general operation on carpet and floors; low
for reaching under low furniture.
Step on handle release lever to lower handle (Fig.4/2).
Carpet Height Adjustment
The cleaning of carpet and rugs takes place at the nozzle
(A). When it is necessary to raise and lower the nozzle for
various carpet pile heights, place handle in upright
position and turn the carpet height adjuster (B) to the
desired setting (Fig.4/3).
NOTE: The nozzle will not move into the adjusted
position until the cleaner handle is lowered to the
operating position.
Settings
For maximum cleaning performance, the following carpet
height settings are recommended:
• Lowest setting: for all types of carpet.
NOTE: If the cleaner is difficult to push, turn knob to
the next higher setting.
• Higher settings: for very deep pile carpet, where easier
pushing effort is desired, while maintaining good cleaning
performance.
Cleaning Lightweight Flexible Rugs
Stand on one end of rug and move cleaner toward other
end or edge. Before reaching edge, push down on handle.
This will lift up the nozzle (front of cleaner) as shown and
will prevent rug from clinging to cleaner (Fig.4/4).
Continue to lift up nozzle so that when you have reached
the edge, it is completely off the rug. Move cleaner back
to start again, lower nozzle, and use only forward strokes.
Stair Cleaning
A stair cleaning handle has been designed for ease in
using your cleaner on stairs. With handle in operating
position, place fingers under edge of stair cleaning
handle and guide cleaner with other hand on upper
handle (Fig.4/5).
Fig.4/1
Fig.4/2
Fig.4/3
A
B
Fig.4/4
Vax Careline: (UK) 0844 412 8455 (ROI) 1-800 928 308
WARNING: This cleaner has a constantly rotating
brushbar which, when left in contact with lino,
parquet and other hard flooring could potentially cause
some damage to the floor surface.
NOTE: Vax recommends that you raise the height of the
brushbar when using this cleaner on lino and hard
flooring. Vax cannot be held responsible for damage to
these surfaces if the user fails to take notice of this
recommendation.
!
U90-M3 & M4 Series User Guide v1.4.qxd:UG 15/7/10 15:36 Page 5
Loading...