8
EEC STATEMENT OF COMPLIANCE
Manufacturer/EEC importer: Vax Limited, hereby on our own responsibility, declare that the
product V-094/V-094TB/V-094TH/V-094TT Performance Cylinder range is manufactured in compliance
with
the following Directives:
Safety: 73/23/EEC Low Voltage Directive
EMC: 89/336/EEC Electromagnetic Compatibility Directive
Waste electrical products should not be disposed of with household waste. Please recycle
where facilities exist. Check with your Local Authority or retailer for recycling advice.
V
ax Ltd., Kingswood Road, Hampton Lovett, Droitwich, Worcestershire WR9 0QH, UK
email: info@vax.co.uk - website: www.vax.co.uk
Instruction Manual
www.vax.co.uk
Vax Careline:
0870 6061248
Please read carefully before using
the cleaner. Always fully extend
the mains cable befor
e use.
Vax V-094/V-094TB/V-094TH/V-094TT
V-094 amended aw 1/11/05 11:15 am Page 1
2 3
Parts Overview
1
Dusting brush
2
Crevice tool
3
Combination floor head
TTuurrbbooTTooooll
(Model: V-094TT only)
TTuurrbbooBBrruusshh
(Model: V-094TB,
V-094TT, V-094TH only)
P
arts Overview
1
Hose Outlet
2
Front carry handle
3
Dust container
4
Central HEPA filter
5
Wheel
6
Cord rewind button
7
Storage slot
8
Post-motor filter cover
9
On/off button
10
Top carry handle
11
Handle release button
11.. DDiiaaggrraamm AAcccceessssoorriieess
Fig.1/2
Fig.1/3 Fig.1/4
Fig.1/1
31 2
Fig.1/5
HHaarrdd fflloooorr bbrruusshh
(Model: V-094TH only)
1
2
3
4
5
6
7
8
9
1
0
1
1
V-094 amended aw 1/11/05 11:16 am Page 3
4 5
2. Safety Information
FOR HOUSEHOLD USE ONLY
When using the vacuum cleaner, basic safety
precautions should always be observed, including
the following:
1. Only use the vacuum cleaner indoors on dry
surfaces.
2. Turn off the vacuum cleaner controls before
connecting or disconnecting from the mains
supply.
3. Always unplug the vacuum cleaner before
connecting or disconnecting the vacuum hose
and accessories.
4. Close attention is necessary when used by or
near children. Do not allow children to use as
a toy.
5. Use only as described in this manual.
Use only the manufacturer’s recommended
attachments.
6. Do not use the vacuum cleaner if it has been
dropped, damaged, left outdoors or dropped
into water. Do not use the vacuum cleaner with
a damaged cord or plug. If the supply cord or
plug is damaged, return the vacuum cleaner to
a Vax Authorised Service Agent or suitably
qualified person for examination, repair or
adjustment.
7. Do not pull or carry by the cord. Do not use the
cord as a handle, close a door on the cord or
pull the cord around sharp edges or corners.
Do not run the vacuum cleaner over the cord.
Keep the cord away from heated surfaces.
8. Do not handle the plug or vacuum cleaner with
wet hands. Do not use outdoors or on wet
surfaces.
9. Do not put any objects into openings. Do not
use with any openings blocked and do not
restrict air flow. Keep all openings free of dust,
lint, hair or anything that may reduce airflow.
10. Keep hair, loose clothing, fingers and all parts
of the body away from openings and moving
parts.
11. Do not pick up hot coals, cigarette butts,
matches or any hot, smoking or burning
objects.
12. Do not pick up flammable or combustible
materials (lighter fluid, petrol, kerosene, etc) or
use in the presence of explosive liquids or
vapours.
13. Do not vacuum up harmful or toxic material
(chlorine bleach, ammonia, drain cleaner, etc).
14. Do not vacuum up hard or sharp objects such
as glass, nails, screws, coins, etc.
15. Do not use without the filters in place.
16. Take extra care when vacuuming on stairs.
17. Keep vacuuming area well lit.
18. Store the vacuum cleaner indoors in a cool, dry
area.
19. Turn off the on/off switch before unplugging the
vacuum cleaner.
20. Use only CE-approved 13 amp extension
cords. Non-approved extension cords may
overheat. Care should be taken to arrange the
cord so that the cord cannot be pulled or
tripped over.
WARNING: Always switch off and unplug the
vacuum cleaner from the electrical outlet
before assembling, opening or emptying the dirt
container, or before connecting/disconnecting the
attachments.
CAUTION: The vacuum cleaner is a very powerful
unit. Before plugging the cord into the electrical
outlet, make sure the switch is in the ‘off’ position.
Hold the vacuum cleaner firmly when starting and
in use.
IMPORTANT: If the inlet, hose or telescopic tube is
blocked, switch off the vacuum cleaner and remove
the blockage(s) before re-starting the vacuum
cleaner.
IMPORTANT: Washing filters improves vacuum
performance. Make sure all the filters are
completely dry before inserting back into the
vacuum cleaner.
This vacuum cleaner is intended for household use
only and not for commercial or industrial use.
Motor Thermostat
IMPORTANT:
The motor is equipped with a
thermal cut-out. If for any reason, the vacuum
cleaner should over-heat, the thermostat will
automatically turn the unit off. Should this occur,
unplug the vacuum cleaner from the electrical
outlet and turn the unit off. Remove the dirt
container and empty. Clean the filters. Allow the
cleaner to cool for appr
oximately one (1) hour. To
re-start, plug into an electrical outlet and switch
back on.
3. How to Assemble
IMPORTANT: Always unplug the vacuum cleaner
from the electrical outlet before assembling or
removing the accessories.
1
. Insert the flexible hose into the inlet on the main
body of the vacuum cleaner. Push in until it
clicks into position (Fig.3/1).
2. Push the telescopic extension tube on to the
end of the handle (Fig.3/2).
3. The telescopic extension tube can be
lengthened or shortened by pushing the button
in and sliding the tube apart or together as
required (Fig.3/3).
4. 4. Fit the combination floor head by pushing
onto the extension tube (Fig. 3/4).the extension
tube (Fig.3/4).
4. How to Operate
Cor
d Release
Fully unwind the power cord. A yellow mark on the
power cord indicates the recommended cord
length. Do not exceed the cord length beyond the
red mark.
On/off Button
1. Insert the power plug into the electrical outlet.
Make sure the vacuum cleaner is switched off.
2. Press the on/off switch located on the top of
the vacuum cleaner, to switch on the vacuum
cleaner and press the button again to turn the
vacuum cleaner off.
Carpet Cleaning
For carpet and rug cleaning, press the rocker
switch on the combination floor head to raise the
brushes.
Hard Floor Cleaning
For hard floor cleaning, press the rocker switch on
the combination floor head to lower the brushes.
Cord Rewind
To rewind the power cord, press the cord rewind
button, located on the top of the vacuum cleaner,
and guide the power cord with one hand. This will
prevent the cord from whipping which could cause
damage or injury.
Carry Handle
Use the carry handle located on the top of the
vacuum cleaner or the front to move from room to
room.
Hose Storage
For convenience there is a slot located on either the
back or the base of the vacuum cleaner where the
floor tool and hose can be parked for carrying and
storage.
5. Accessories
1. The accessories can be attached directly to the
handle by removing the telescopic tubes and
pushing in the desired accessory.
2. The accessories can also be attached to the
telescopic extension tube for extra reach.
Remove the combination floor head and push
on the desired accessory.
Crevice tool: For crevices, corners and cracks, etc.
Dusting brush: For delicate surfaces.
Upholstery tool: For carpet, upholstery, stairs, etc.
Turbobrush (Model: V-094TB, V-094TT,
V-094TH only): For pet hair and larger carpeted
areas. (NOTE: not recommended for hard floors).
T
urboTool (Model: V-094TT only):
For pet hair
,
upholstery and stair cleaning. The T
urboTool
should be pulled backwar
ds for optimum cleaning.
Har
d floor brush (Model: V
-094TH only):
For
har
d floor
, par
quet and laminate coverings.
S
afety Information
H
ow to Assemble / How to Operate / Accessories
Fig.3/1
Fig.3/2
Fig.3/3
Fig.3/4
V-094 amended aw 1/11/05 11:16 am Page 5
7
T
roubleshooting / UK Service & Help / Technical Specification
D
irt Container & Filters: Removal & Replacement / Storage
9. Troubleshooting
WARNING: To reduce the risk of personal injury, unplug the vacuum cleaner before performing
maintenance/troubleshooting checks.
PROBLEM: Vacuum cleaner won't run
Cause:
Not properly plugged into electrical outlet.
Solution: Plug in securely.
Cause: No electricity in the electrical outlet.
Solution: Check fuse or breaker.
Cause: On/off switch not turned on.
Solution: Push on/off switch to ‘on’.
Cause: Motor thermostat has tripped.
Solution: Switch off and unplug the vacuum cleaner. Leave for one (1) hour before switching the
vacuum cleaner back on.
Cause: Blown fuse/tripped breaker.
Solution: Reset circuit breaker or replace fuse.
PROBLEM: Cleaner won’t pick up/loss of suction.
Cause:
Dirt container not installed properly.
Solution: Review dirt container replacement.
Cause: Dirt container full or blocked.
Solution: Empty dirt container.
Cause: Clogged filters.
Solution: Remove, clean and replace filters.
PROBLEM: Accessories won’t pick up.
Cause:
Accessories are not attached correctly.
Solution: Refer to section 5.
PROBLEM: Dust escaping from the vacuum cleaner.
Cause:
Dirt container full.
Solution: Empty dirt container.
Cause: Dirt container not installed correctly.
Solution: Review dirt container replacement.
Cause: Hose not installed correctly.
Solution: Review installation.
Cause: Filter not installed completely.
Solution: Remove, clean and replace filters.
6. Dirt Container & Filters: Removal
& Replacement
IMPORTANT: Always unplug the vacuum cleaner
from the electrical outlet before removing the dirt
c
ontainer.
IMPORTANT: Do NOT use the vacuum cleaner
without ALL of the filters in place.
Emptying the Dirt Container
1. Press the button located on the top carry handle
to access the dust container (Fig 6/1)
2. 2. Remove the dust container by pulling the
handle (Fig 6/2)
3. Press the button located on the rim of the dust
container to empty the dirt into a rubbish bin
(Fig.6/3)
When all of the dirt has fallen, close the dirt
container flap, close the safety latch and replace the
dirt container
.
Cleaning the Filter
1. Remove the dust container as directed.
2. T
wist the filter safety catch located on top of the dust
container and pull out the central filter unit (Fig 6/4)
3. Gently tap the filter against the side of a rubbish
bin to remove excess dirt.
4
. The central filter can be washed in warm water
[
max 40
O
C
]. Allow to air dry completely before
r
eplacing.
NOTE: Do NOT use any detergents or boiling water
to wash the filter. Vax recommends replacing the filter
every 9-12 months.
5
. Replace the central filter unit to the dust container
ensuring the filter safety catch has been reset.
6. Replace the dust container as directed.
Post-motor Filter
NOTE:
This is located on the back of the vacuum
cleaner.
1. Release the post-motor cover and remove the
filter by pressing in the catch on the back of the
vacuum cleaner.
2. The post-motor filter can be washed in warm
water [max 40
O
C]. Allow to air dry for 24 hours
before replacing.
3. Replace the post-motor filter and cover before
re-starting the vacuum cleaner.
NOTE: Do NOT use any detergents or boiling water
to wash the filter. Vax recommends washing the filter
every 9-12 months.
7. Cleaning Blockages
WARNING: To reduce the risk of electric shock, the
power cord must be disconnected before performing
maintenance/troubleshooting checks.
1. Turn the vacuum cleaner off and unplug from the
electrical outlet.
2. The flexible hose can be disconnected fr
om the
vacuum cleaner by pushing in the button on the hose
and pulling away fr
om the machine. Remove any
blockages found then reconnect the hose securely.
3. To remove blockages from the TurboTool, rotate
the locking ring 180
O
, then turn the TurboTool over.
Pivot the lower housing open, then remove any
obstructions. To re-assemble, ensure the tabs are
engaged, pivot the lower housing closed and reposition the locking ring.
8. Storage
IMPOR
T
ANT:
Always unplug the vacuum cleaner
fr
om the electrical outlet and r
ewind the power cord
as dir
ected befor
e storing.
NOTE: Always store the vacuum cleaner base
down.
Fig.6/1
Fig.6/2
Fig.6/4
10. UK Service & Help
Vax Care 0870 6061248
Monday-Friday
. 9.00am to 5.00pm.
An answerphone will be available out of these
hours. Any queries or concerns about using your
Vax, call the Vax Careline. Calls are charged at the
UK national rate.
Please make a not of the model number and serial
number of your Vax before calling. There are over
400 approved Vax Service Agents in the UK. For
the nearest Vax Service Agent, please call the Vax
Careline or visit www.vax.co.uk
www.vax.co.uk
11. T
echnical Specification
V
oltage:
220-240V ~50Hz
W
attage:
1600W-1700W (dependant on
model)
Capacity:
2.2 litr
es appr
ox
Filters:
W
ashable central HEP
A filter
Post-motor filter
Cor
d length:
5.8m (appr
ox)
W
eight:
7.2kg
Subject to technical change
without notice.
Fig.6/3
6
V-094 amended aw 1/11/05 11:16 am Page 7
Loading...