Vax C91-P2 User Manual

powerpower

Vax C91-P2 Series User Guide v3.qxd:C91-P2 Series User Guide 27/4/09 14:10 Page 1

Bagless cylinder

Vax careline 0870 606 1248

Vax model number: C91-P2 SERIES

7 6

1. Parts Overview

The Unit

1 On/Off Button

Insert the plug into the electrical outlet. Press the on/off switch on the top of the vacuum cleaner, to switch the vacuum cleaner on and press the button again to turn the vacuum cleaner off.

2 Post-motor filter cover

3 Plug 4 Floor tool parking slot

For convenience there is a parking slot located at the rear of the vacuum cleaner where the Floor Tool can be parked for carrying and storage.

5 Pre-motor filter

Located inside the dirt bin.

6 Dirt container 7 Hose inlet

8 Carry handle

Located on the top of the unit, used to move the vacuum cleaner from room to room.

instruction manual

9 Auto-Cord rewind

To rewind the power cord, press the cord rewind button, located on the top of the vacuum cleaner

10 Variable power

Power can be increased or reduced for greater suction control

11 Dirt bin quick release button

Hold the dirt container over a bin and press the release button.

12 Dirt Container Carry Handle

Use the carry handle located on the front of the dirt bin to carry the dirt container.

What is your vax’s model number?

C 9 1 P 2

What is your vax’s serial number?

Note this down in case you need it in future

---

(on the base of your cleaner)

vax.co.uk

Retain this guide for future reference.

!17!

Vax C91-P2 Series User Guide v3.qxd:C91-P2 Series User Guide 27/4/09 14:10 Page 2

vax.co.uk

Parts Overview

The Accessories

13 Hose

14 Dusting Brush

For delicate surfaces.

15 Crevice Tool

For crevices, corners and cracks

16 UpholsteryTool

For carpet, upholstery and stairs etc.

17 TurboTool™ (model C91-P2-P only)

Perfect for pickingup pet hair

KEEP YOUR VAX LIKE NEW!

Your Filters:

Replacement filter kits are available at vax.co.uk

18 Combination floor tool

For carpet and rug cleaning: Press the rocker switch on the Combination Floor Head to raise the brushes. For hard floor cleaning: Press the rocker switch on the Combination Floor Head to lower the brushes.

19 Telescopic extension tube

The telescopic tube can be lengthened or shorted by pushing the button in and sliding the tube apart or together as required. The small tools can be stored on the telescopic tube.

20 TurboTool™ connector

IMPORTANT: The connector must be added to the hose handle before the TurboTool™ may be

attached.

21 HEPA pre-motor filter 22 Pre-motor filter mesh shroud

23 Foam post-motor filter and anti-bacterial filter

(model C91-P2-P only)

IMPORTANT: The condition of the filters affects

the performance of your vacuum cleaner. Please check and wash filters periodically (depending on level of use). For full cleaning instructions see page 4-5.

IMPORTANT: Do not use the vacuum cleaner

without all the filters in place.

To replace or purchase parts for your vacuum

cleaner, please visit our website:

vax.co.uk

parts overview

If your Vacuum Cleaner or Accessories are Damaged/Faulty

Please Call our Vax Careline on: 0870 606 1248

Vax C91-P2 Series User Guide v3.qxd:C91-P2 Series User Guide 27/4/09 14:10 Page 3

ax Careline 0870 606 1248

2. Assembling your vacuum cleaner

CLICK!

3. Choose the attachments for the job:

4. Operating the appliance

WARNING: Always switch off and unplug the vacuum cleaner from the electrical outlet before assembling, opening or emptying the dirt container, or before connecting/ disconnecting the attachments.

NOTE: Fully unwind the power cord. A yellow mark on the power cord indicates the recommended cord length. Do not exceed the cord length beyond the red mark.

5. Packing away and storage

IMPORTANT: Always unplug the vacuum from the electrical outlet and rewind the power cord as directed before storing.

NOTE: When rewinding the power cord, guide the cord with one hand, This will prevent the cord from whipping which could cause damage or injury.

NOTE: For convenience there is a parking slot located at the rear of the vacuum cleaner where the floor tool and hose can be parked for carrying and storage.

assembly / attachments / operation / storage

Vax C91-P2 Series User Guide v3.qxd:C91-P2 Series User Guide 27/4/09 14:10 Page 4

vax.co.uk

6. Dirt Container: Maintenance

IMPORTANT : Always switch off and unplug the vacuum cleaner from the electrical outlet before removing the Dirt Container.

Emptying the Dirt Container

Cleaning the dirt bin

7. The Filters: Maintenance

IMPORTANT: Your vax vacuum cleaner is fitted with high performance filters it is essential that these are well maintained and cleaned according to the following instructions.

IMPORTANT : Do NOT use the vacuum without ALL of the

filters in place.

Cleaning the HEPA Pre- Motor Filter

TAP

dirt container / filters

TAP

Vaxrecommends that the pre- and post-motor filter should be checkedand cleaned periodically depending on the frequency of use and the volume of dirt being picked up on each occasion.

NOTE : Both Pre- and Post-Motor Filters can be rinsed in warm water (max 40°C). Allow to air dry for 24 hours before replacing. Do NOTuse any detergents or boiling waterto wash the filters.

+ 8 hidden pages