C86-VC-B
Performance is everything.
User Guide
C87-T2 Series and C86-VC-B
Contents
Contents
Machine Overview
General Safety Information
Getting Started
Maintenance
Looking After Your Machine — Filters
Looking After Your Machine — Removing Blockages
FAQs
Other Information
Guarantee
1
2
3
4
5
6
7
8
9
10
1
1 Hose connector
2 Dirt container
3 Cyclone separator and shroud
4 Dirt container lid
5 Carry handle
6 On/o button
7 Variable power dial
8 Cord rewind button
9 Wheel
10 Pre-motor lter
(some models only)
11 Post motor lter HEPA H12
12 Dusting brush
13 Crevice tool
14 Upholstery tool
15 Hose and handle
16 TurboTool (some models only)
17 Extension tube and tool caddy
18 Stretch hose (some
models only)
19 Combination oor head
(some models only)
20 Turbobrush
(some models only)
21 Hard oor tool
(some models only)
Machine Overview
2
3
1
5
6
9
10
11
12
15
17
4
8
7
11
16
19
13
14
NOTE: Some parts may vary according to model. Please check inside ap of box for more details.
20
21
18
2vax.co.ukvax.co.uk
General Safety Information
This vacuum cleaner is intended for household use only and NOT for commercial or industrial use.
Please keep instructions for further use.
When using the vacuum cleaner basic safety precautions should always be observed, including the following:
1. Do not leave the vacuum cleaner unattended when plugged in. Unplug the appliance from the socket when
not in use.
2. Only use the vacuum cleaner indoors on dry surfaces.
3. Turn o the on/o switch on the vacuum cleaner controls before disconnecting or connecting from the
mains supply.
4. Always unplug the vacuum cleaner before connecting or disconnecting the vacuum hose and accessories.
5. Children should be supervised to ensure that they do not play with the appliance.
6. This appliance is not intended for use by children under eight years of age and persons with reduced physical,
sensory or mental capabilities or lack of experience and knowledge, unless they have been given supervision
or instruction concerning use of the appliance in a safe way and understands the hazards involved.
7. Cleaning and maintenance shall not be made by children without supervision.
8. The appliance should only be used as described in the quick start guide or in the full online user guide.
9. Only Vax recommended attachments should be used with this appliance.
10. Do not use this vacuum cleaner if it has been dropped, damaged, left outdoors or dropped into water. Do not
use this vacuum cleaner with a damaged cord or plug. If the supply cord is damaged return the vacuum cleaner
to a Vax authorised Service Agent or a suitably qualied person for examination, repair or adjustment.
11. Do not pull or carry this appliance by the cord. Do not use the cord as a handle, close a door on the cord or pull
the cord around sharp edges or corners. Do not run the vacuum cleaner over the cord. Keep the cord away from
heated surfaces.
12. Do not handle the plug or the vacuum cleaner with wet hands.
13. Keep hair, loose clothing, ngers and all parts of the body away from openings and moving parts.
14. Do not pick up any hot coals, cigarette butts, matches or any hot, smoking or burning objects.
15. Do not vacuum up hard or sharp objects such as glass, nails, screws, coins, etc. without ALL of the lters in place.
16. Do not vacuum up harmful or toxic material (chlorine, bleach, ammonia, drain cleaner etc.)
17. Do not vacuum up hard or sharp objects such as glass, nails, screws, coins etc.
18. Store the vacuum cleaner in a cool, dry area.
19. Use only CE approved 13 amp extension cords. Non-approved cords may overheat. Care should be taken
to arrange the cord so that the cord cannot be tripped over.
20. Do not put any objects into openings. Do not use with any openings blocked and do not restrict airow.
Keep all openings free of dust, lint, hair or anything that might reduce airow.
21. Do not use without all of the lters in place.
22. Take extra care when vacuuming on the stairs.
23. Please ensure that the brushbar is turned o when you are vacuuming on the stairs.
24. Keep vacuuming area well lit.
3
Getting Started
NOTE: The condition of the lters aects the performance of your machine. Please
check and wash lters periodically (depending on the level of use). For full cleaning
instructions, see pages 5 and 6.
NOTE: Do not use the vacuum cleaner without all of the lters in place.
Assembling your vacuum cleaner
NOTE: The Turbobrush, hard oor tool, crevice tool, upholstery tool and dusting brush can all be attached directly to the telescopic
tube or hose handle. The TurboTool should rst be attached to the supplied connector before tting onto the hose handle.
Operating the appliance and accessories
1
2
NOTE: Fully unwind the power cord. A yellow mark on the cord indicates the recommended cord length. Do not exceed
the cord length beyond the yellow mark.
4vax.co.uk
Maintenance
24hr
Packing away and storage
NOTE: For convenience there is a parking slot located at the rear of the vacuum cleaner where the oor head and tubes
can be attached for storage and carrying.
Emptying and cleaning the dirt container
Cleaning the pre-motor lter
5
tap
o
40 C max
Looking after your machine – Filters
Cleaning the shroud
p
a
t
NOTE: The shroud is accessed by removing the dirt container lid and is located underneath the pre-motor lter.
24hr
Cleaning the post-motor lter
p
a
t
6vax.co.uk
Looking after your machine –
Tabs
Removing Blockages
WARNING: To reduce the risk of electric shock, the power cord must be disconnected before performing
maintenance/troubleshooting checks. Turn the vacuum cleaner o and unplug from the electrical socket.
IMPORTANT: If the air inlet, hose or telescopic tube is blocked, switch o the vacuum cleaner and remove
the blockage(s) before re-starting the vacuum cleaner.
Clearing blockages
Hose blockages Accessory blockages
The exible hose may be disconnected
from the vacuum cleaner. Carefully remove
any blockages found and reconnect the
hose securely.
Removing blockages from the TurboTool (Some models only)
Remove accessory from the hose/telescopic
tube. Carefully remove the blockage and return
to the cleaner.
1
Locking ring
Turn the TurboTool over and
slide o the locking ring.
2
Detach lower housing and
remove blockage.
3
Removing blockages from the Turbobrush (some models only)
Lay the Turbobrush on a at surface and turn over to expose
the brushbar. Using a pair of scissors, cut through any
threads or hairs caught by the brushbar that have wrapped
around the guides.
To re-assemble the
TurboTool, ensure that
the tabs are engaged
and pivot the lower
housing closed.
Slip the locking ring
over the neck of the
TurboTool and into
the groove to nish.
7
FAQs
WARNING: To reduce the risk of personal injury, unplug the vacuum cleaner before performing maintenance
/troubleshooting checks.
Is there an accessory missing?
• Check the ‘Parts Overview’ page in this guide to make sure the part is denitely included in your unit.
• If it is missing, we’re here to help. Simply call us on 0844 412 8455
Why won’t the vacuum cleaner pick up?
• The dirt container may be incorrectly installed; remove the dirt container from the unit by pressing the dirt container release
catch and then re-attaching it to the unit, ensuring it is locked rmly back into place.
• The lter may be clogged; refer to ‘Maintenance: Looking after your machine – lters’ on pages 5 and 6.
• The dirt container may be blocked; refer to ‘Maintenance: Emptying and cleaning the dirt container’ on page 5.
• There may be a blockage in the hose/tube; disconnect from the vacuum cleaner. Carefully remove any blockages found
and reconnect securely.
Why is dust escaping from the vacuum?
• The lter may be clogged; refer to ‘Maintenance: Cleaning the lters’ on pages 5 and 6.
• The dirt container may be blocked; refer to ‘Maintenance: Emptying and cleaning the dirt container’ on page 5.
• The dirt container may be incorrectly installed; remove the dirt container from the unit by pressing the dirt container
release catch and then re-attaching it to the unit, ensuring it is locked rmly back into place.
What do I do if the unit/an accessory becomes damaged or broken?
• We’re here to help. Simply call 0844 412 8455 or visit vax.co.uk
Why won’t the accessories pick up properly?
• Hose blockages: remove the hose from the unit. Carefully remove any blockages found and reconnect hose securely.
• Accessory blockages: remove accessory from handle/tube. Carefully remove blockage and re-attach to the vacuum cleaner.
• The accessory may be faulty. Simply call us on 0844 412 8455 for assistance.
Why will the vacuum cleaner not run?
• It may not be plugged into the electrical outlet correctly; ensure that the plug is pushed in securely.
• The electrical outlet may not be working properly; check the fuse or breaker, or consult an electrician.
• The motor thermostat may have tripped; switch o and unplug the vacuum cleaner, and leave for one hour before switching
the cleaner back on.
8vax.co.uk
Other Information
Machine Overview
UK Service & Help
Any queries or concerns about using your Vax, simply visit; vax.co.uk/support – vaxireland.ie or call the
Vax Careline. Calls are charged at the UK local rate. Please make a note of the serial number and model
number of the vacuum cleaner before calling.
Vax Careline:
(UK) 0844 412 8455
(ROI) 1-800 928 308
Monday-Friday 8.30am to 6.30pm
Saturday-Sunday 9.00am to 5.00pm
Consumables
To purchase spares and accessories, please visit vax.co.uk
C88-T2 series and C86-VC-B pre-motor lter: 1-1-130851-00
C88-T2 series and C86-VC-B post-motor lter: 1-1-130854-00
Guarantee will only be valid with the use of genuine Vax spares and accessories.
Technical Specication
Voltage: 220-240V ~50Hz
Wattage: 2000 - 2200W(depending on model)
Capacity: 3L
Filters: Pre-motor lter
HEPA H12 post-motor lter/HEPA H12 antibacterial post-motor lter (depending on model)
Cord length: 7m (approx)
Weight: 5.4kg (approx)
Subject to technical change without notice.
EEC Statement of Compliance
Manufacturer/EEC importer: Vax Limited, hereby on our own responsibility,
declare that the C88-T2 series and C86-VC-B are manufactured in compliance with the following Directives:
Safety: 2006/95/EC Low Voltage Directive
EMC: 2004/108/EC Electromagnetic Compatibility Directive
Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist.
Check with your Local Authority or retailer for recycling advice.
9
Guarantee Guarantee
It’s quick and easy to register for your
FREE 2 year guarantee
online at: vax.co.uk/guarantees
Please retain your original receipt for proof of purchase.
UK based customer care centre — Open 7 days a week
Monday-Friday 8:30 - 18:30
Saturday 9:00 - 17:00
we’re here if you need us
Instead of taking me back to the shop, simply visit:
vax.co.uk/support or call (UK) 0844 412 8455 (ROI) 1-800 928 308
Let us know what you think @VaxUK
Designed in the UK
10vax.co.uk
COMMERCIAL
Vax Ltd., Kingswood Road, Hampton Lovett, Droitwich, Worcestershire, WR9 0QH, UK
Performance is everything.
email: info@vax.co.uk website: vax.co.uk
vax.co.uk
Loading...