Air Silence
Let’s get started
C86-AW-(Be, Pe)
vax.co.uk
Let’s talk safety Let’s talk safety
Basic safety precautions
Please keep instructions for further
use and use only as instructed in
this guide. This vacuum cleaner is
intended for household use only and
NOT for commercial or industrial use
• Only use the vacuum cleaner indoors
on dry surfaces and keep the area
you’re cleaning well lit
• Keep ngers, hair and loose clothing
away from moving parts and
openings whilst using the
vacuum cleaner
• This appliance can be used by
Don’ts
8 Don’t use this vacuum cleaner if
it has been dropped, damaged or
left outdoors
8 Don’t run over the power cord or
use vacuum cleaner if the power
cord or plug is damaged. Please
contact our Customer Care Line on:
0844 4128 455 (Mon-Fri: 8.30am to
6.30pm, Sat: 9.00am to 5.00pm)
8 Don’t handle the plug or use the
vacuum cleaner with wet hands
8 Don’t pull or carry this vacuum
cleaner by the power cord. Don’t
use the power cord as a handle,
children aged from 8 years and
above and persons with reduced
physical, sensory or mental
capabilities or lack of experience and
knowledge if they have been given
supervision or instruction concerning
use of the appliance in a safe
way and understand the hazards
involved. Children shall not play with
the appliance. Cleaning and user
maintenance shall not be made by
children without supervision
• Only Vax recommended tools should
be used with this vacuum cleaner.
pull the power cord around corners,
sharp edges or close a door over the
power cord. Don’t unplug vacuum
cleaner by pulling on the power cord
8 Don’t vacuum up any ammable
or combustible materials (lighter
uid, petrol, kerosene etc.) or use
the vacuum cleaner in an area with
explosive vapours or liquid
8 Don’t vacuum up hot coals, cigarette
butts, matches or smoking hot burning
items or use in an area where there
may be harmful uids (chlorine, bleach,
and ammonia drain cleaner)
8 Don’t attempt to remove blockages
with sharp objects as this may cause
damage to your vacuum cleaner
8 Don’t vacuum up hard or sharp
objects such as glass, nails, screws
or coins etc
3 Turn o all controls on the vacuum
cleaner before disconnecting or
connecting the power cord
3 Always keep the power cord away
from the brushes whilst using your
vacuum cleaner. After use always
wrap the power cord around the
cord clips provided
3 Always make sure both the pre-
motor/post motor lters are in place
before use
3 Always make sure the brushbar is
set to hard oor when using your
vacuum on the stairs and take extra
care when positioning the vacuum
cleaner on the stairs
3 Always switch o the vacuum
cleaner before disconnecting or
connecting the hose and accessories
Don’ts
8 Don’t use the vacuum cleaner with
incorrect voltage as this may result
in damage or injury to the user.
The correct voltage is listed on the
ratings label.
Do’s
3 Keep all openings clear and free
from debris as this may aect the
airow/suction
3 Always replace the fuse in the plug
with a British 13amp fuse. Always
protect the power cable from heated
surfaces and open ames
3 Use only CE approved 13amp
extension cords, non-approved
extension cords may overheat.
Care should be taken to arrange
the extension cord as it could be
a trip hazard
3 Store the vacuum cleaner in a cool,
dry area. If lters have been cleaned
as per user the guide instructions
ensure they are thoroughly dry
before storing away.
Thank you for buying this Air Silence.
Contents
Air Silence
Taking care of your carpets and hard oors
The Air Silence is designed to make vacuuming carpets and hard oors regularly, as eective and
ecient as possible and this user guide will help you get the most out of your machine.
Maintaining your carpets and hard oors will ensure they keep their appearance for longer.
You’ve chosen the carpets and hard oor for your home for a reason and Vax will help you take
good care of them.
Taking care of your Air Silence
Also inside this guide are instructions on maintaining your new machine, so that it’s always ready
when you are to tackle your carpets and hard oors.
Let’s talk safety
Getting to know your machine
Getting started
Using your machine
Taking care of your machine
Let’s talk technical
Accessories
What to do if it goes wrong
Included with
your machine
Accessory hose
and handle
Telescopic
extension tube
Combination
oor head
3-in-1 tool
Tool connector
Post-motor lter
Pre-motor lter
Air Silence Pet
+
Taking care of you
We’re here if you need us. Instead of taking me back
to the shop, simply visit:
vax.co.uk/support or call:
(UK) 0844 412 8455 (ROI) 1-800 928 308
Monday-Friday 8.30am to 6.30pm, Saturday 9.00am to 5.00pm
Calls are charged at the UK local rate. Please make a note of the serial number and model number
of the product before calling.
Alternatively, you can write to us at:
Vax Ltd., Kingswood Road, Hampton Lovett, Droitwich, Worcestershire, WR9 0QH, UK
Let us know what you think @VaxUK
Getting in touch
TurboTool
Initial Setup for normal operation
1. Use the base accessories.
– Shortest hose
– Extension tube set to shortest practicable length.
2. Clean lters installed.
3. Dust receptacle empty.
4. All Bleeds must be closed.
5. Variable Power set to Maximum.
6. Floor heads/tools set to Carpet Mode for carpet cleaning.
7. Mechanical Agitation turned ON for carpet cleaning.
8. Floor heads/tools set to Hard Floor Mode for hard oor cleaning.
9. Mechanical Agitation turned OFF for hard oor cleaning.
Getting to know your machine
Getting started
Pre-motor lter (hidden)
Separator and shroud
Hose entry point
Power on/o button
Floor head parking slot
Dirt container
release button
Dirt container
Carry handle
Cord rewind button
PLEASE READ ‘LET’S TALK SAFETY’ AT THE BEGINNING BEFORE USE
Assembling your machine
Press both buttons at the
end of hose and insert into
hose entry point.
Insert hose grip into
telescopic extension tube.
Press button on telescopic
extension tube and adjust
to required length.
Insert the other end of the
telescopic tube into the
oor head.
Carrying your machine
Always use the carry handle to lift and carry your vacuum cleaner. Do not use the dirt container release handle.
The dirt container should be locked into place before lifting the vacuum cleaner by the carry handle.
Post-motor lter (hidden)
Technical Specication
Name Air Silence
Voltage 220-240V~50Hz
Wattage 800W
Cord length 6-6.5m
Weight 5.5kg
Subject to technical change without notice.
Post-motor lter cover
and release button
Accessories & Consumables
Filter kit (Type 111)*
1-1-134395-00
TurboTool (Type 5)*
1-1-134418-00
Tool connector (Type 1)*
1-1-133838-00
*To purchase consumables and accessories, please visit vax.co.uk
Combination oor tool (Type 6)*
1-1-134330-00
3-in-1 Tool (Type 1)
1-1-129167-00
Before you begin cleaning
• Always switch o and unplug the vacuum cleaner before connecting or disconnecting the hose/attachments, or removing
and emptying the dirt container.
• The vacuum cleaner is equipped with a thermal cut-out. If for any reason the vacuum cleaner does overheat the thermostat
will automatically turn the vacuum cleaner o. If this happens, switch the vacuum cleaner o and unplug from electrical
socket. Remove and empty the dirt container also check the vacuum cleaner for blockages. Allow the vacuum cleaner to
cool for approximately 1 hour (if you have cleaned the lters please wait 24 hours for the lters to fully dry before putting
back into the vacuum).
• Filters require cleaning at least every 3 months.
• If the vacuum cleaner is blocked, switch o and unplug before removing the blockage.
• When using the accessories always make sure the brushbar is switched to the o position.
IMPORTANT: The base of the vacuum cleaner should always be positioned at on the oor when starting and in use.
The dirt container should be locked into place before lifting the vacuum cleaner by the carry handle.
Using your machine
Taking care of your machine
How to use
Unwind the power cord.
Do not pull further than
the yellow marker.
Raise brushes for carpets. Lower brushes for
Plug into mains and press
the on/o button to switch
the machine on.
hard oors.
Using accessories
For use on carpets click
rocker switch forward.
For use on hard oors
click rocker switch back.
Slide vent cover on hose
grip open to reduce
suction if required.
Emptying and cleaning the dirt container
Lift dirt container release
handle. The dirt bin lid
will ‘pop up’. Remove dirt
container.
Hold dirt container over a bin
and press dirt release clip on
the bottom of the dirt container,
allowing dirt and debris to fall out.
Cleaning the shroud
Twist separator anti-clockwise, pull to remove.
Tap the shroud over a bin
to remove dirt and debris.
Choose an accessory and
push onto the telescopic
extension tube or hose.
The tool connector must be tted on the hose
when using the TurboTool (some models only).
WARNING
When unwinding the power
cord always pull out to the
yellow marker but no further
TIP
Don’t over ll the dirt
container to avoid blocking
the air ow through the
vacuum cleaner
Taking care of your machine
!
40˚C
MAX
Let’s talk technical
Cleaning the pre-motor lter
40˚C
MAX
Lift dirt container release
handle. The dirt bin lid will
‘pop up’.
IMPORTANT: The exhaust lter is designed to oer long life with no maintenance. The lter should be checked
periodically and when heavily discoloured it should be replaced. Please do not wash, scrub or brush the lter as this will
damage the delicate lter media.
Pull tab on pre-motor lter
to remove.
Tap the lter over a bin
to remove any dirt and
debris.
Rinse the lter under water
(40°C Max). Leave to dry
for 24 hours before placing
back in the machine.
Post-motor lter maintenance
!
24hr
IMPORTANT: Remove accessory from hose or telescopic extension tube before performing maintenance or trouble
shooting checks
Removing blockages from the TurboTool (some models only)
Slide the locking ring to
remove.
Lift and separate the
housing.
Using a pair of scissors,
cut any hair or debris free
from around the brushes.
Line up the tabs on front of
housing and push together
to ret. Slide locking ring
into groove to secure.
Removing blockages from the hose
Tabs
Press down the release
button on the post-motor
lter cover, pull to remove.
Storing your machine
Press cord rewind button to
retract cord.
Press down tab at the top
of the lter and pull to
remove.
Place oor head into parking slot
on the back of vacuum cleaner
for storage and carrying.
Check the post-motor
lter for discolouration.
Clean the pre-motor
lter every time the dirt
container is emptied and
replace the post-motor
lter every 12 months
TIP
Remove the hose from the vacuum cleaner and
telescopic extension tube. Remove any blockage
by inserting a wire coat hanger into the hose.
TIP
To test for a blockage in
the hose, drop a small
ball of paper into the
hose. The paper will drop
through if the hose is clear
Accessories
Don’t forget your accessories!
Order at: www.vax.co.uk/spares-and-solutions
Pro cleaning kit
1-1-133326-00
All our best tools all in one kit that makes cleaning
your home quicker, easier and with even better
results. We’ve taken care of cleaning all of the hard
to reach areas such as on top of cupboards and in
between blinds to the dust that collates behind and
within the radiator.
TurboTool (Type 5)
1-1-134418-00
Use the TurboTool for vacuuming your stairs,
upholstery and car interiors. It’s great for picking
up stubborn pet hair.
Notes
Fur ‘n’ Flu Tool
1-1-131392-00
Specically designed to remove extra stubborn
pet hair from upholstery, furniture and carpets.
What to do if it goes wrong Getting in touch
There is an
accessory missing
Why does my vacuum
cleaner have no power?
SolutionProblem
• Check the ‘This pack contains’ panel on the box to make sure the part is
included with your machine.
• The plug may not be fully pushed into the electrical socket.
• Check the fuse in the plug if this needs replacing, always replace with a British
13amp fuse.
• The motor thermostat may have tripped. If this has happened, unplug the vacuum
cleaner. Remove and empty the dirt container and check the hose for blockages.
Clean the lters and allow the vacuum cleaner to cool for approximately 1 hour
(if you have washed the lters you will need to wait 24 hours for the lters to
fully dry before putting them back into the vacuum cleaner).
• The dirt container may not be correctly tted, remove the dirt container from
the vacuum cleaner and check it’s assembled correctly, ret ensuring it’s locked
Why won’t the vacuum
cleaner pick up?
into place.
• The lter may be clogged, clean the lter. Go to ‘Taking care of your machine’.
• The dirt container may be blocked, empty the dirt container. Go to ‘Taking care
of your machine’.
• There may be a blockage in the hose/tube. Disconnect from the vacuum cleaner
and carefully remove any blockages. Go to ‘Let’s talk technical’.
• The lters may be clogged, clean the lter. Go to ‘Taking care of your machine’.
Why is dust escaping
from the vacuum?
WARNING: To reduce the risk of personal injury, unplug the vacuum before performing maintenance/troubleshooting
checks.
* Calls are charged at the UK local rate. Please make a note of the serial number and model number of the vacuum cleaner before calling.
@VaxUK
Vax Ltd., Kingswood Road, Hampton Lovett, Droitwich, Worcestershire, WR9 0QH, UK
email: info@vax.co.uk website: vax.co.uk
Version 1.0
EEC Statement of Compliance: Manufacturer/EEC importer: Vax Limited, hereby on our own responsibility,
declare that the C86-AW-(Be, Pe) is manufactured in compliance with the following Directives:
Safety: 2006/95/EC Low Voltage Directive. EMC: 2004/108/EC Electromagnetic Compatibility Directive.
Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist.
Check with your Local Authority or retailer for recycling advice.
© 2014 All rights reserved. VAX®, VAX Lozenge are trade marks or registered trade marks of Techtronic Floor Care Technology Ltd.
Loading...