2 IN 1 Air Purier
& HUMIDIFIER
LET’S GET STARTED
ACKRV101
LET'S TALK SAFETY Basic Safety Precautions
This appliance is intended for household use only and NOT for commercial or industrial use.
• Only use the appliance indoors and keep away from wet areas.
• Keep ngers, hair and loose clothing away from moving parts and openings whilst using the appliance.
• This appliance can be operated by children aged from 8 years and above and persons with reduced physical,
sensory or mental capabilities or lack of experience and knowledge, if they have been given supervision or
instruction concerning use of the appliance in a safe way and understand the hazards involved. Children shall
not play with the appliance.
• Cleaning and user maintenance shall not be made by children without supervision.
• Always position the appliance on a at, stable, solid surface and never over stretch the power cord.
• Always remove the water tank and drain the appliance before carrying or transporting.
• Position the appliance where dirty air is not drawn across your body or head while sitting or sleeping.
• This appliance produces mist. Keep away from valuables and other electronics.
✘ Don’t
• Leave water stored in the water tank between uses.
• Place the appliance near sources of heat, such as stove tops, ovens, radiators, open res, candles or computers.
• Move or tilt the appliance when in use. Leaking from the water reservoir may occur.
• Use the appliance if the power cord or plug is damaged. Please contact our Customer Service Line
on: 0330 026 8455 (Mon-Fri 08:30-18:30 Sat 09:00-17:00).
• Use the appliance if it has been dropped, damaged or left outdoors.
• Run the power cord under rugs, runners or carpets as it can be a trip hazard.
• Pull, carry or trap the power cord under doors or sharp edges.
• Handle the plug or appliance with wet hands.
• Unplug the appliance by pulling on the power cord.
• Use the appliance in an area with toxic/explosive vapours/liquids, oxygen water tanks or near to ammable,
combustible materials (lighter uid, petrol, kerosene, chlorine, bleach and ammonia drain cleaner etc).
• Use the appliance with incorrect voltage as this may result in damage or injury to the user. The correct voltage
is listed on the ratings label.
• Use without all lters in place.
• Add fragrance or scented oils to the water tank.
✔ Do
• Always use clean fresh water in the water tank.
• Change the water daily and drain the appliance after every use.
• Inspect the appliance regularly and remove any dust/dirt build up as this may aect the airow.
• Keep all openings/grills clear and free from obstruction and sources of heat, and open ames (including
candles). Don’t attempt to remove blockages with sharp objects as this may cause damage to the appliance.
• Turn o all controls on the appliance before disconnecting or connecting the power cord.
• Always replace the fuse in the plug with a 5amp fuse. Always protect the power cable from heat.
• Use only CE approved 5amp extension cords, non-approved extension cords may overheat.
• Take care to arrange the extension cord as it can be a trip hazard.
• Always switch o and unplug the appliance before performing maintenance or troubleshooting checks.
Please keep instructions for further use.
Contents
Lets talk safety
Getting to know your machine
Getting started
Using your machine
Taking care of your machine
What to do if it goes wrong
Getting in touch
4
2-3
5
6-7
8-9
10-13
14
15
Getting to know your machine
Air outlet grill
Control panel
Filter cover
(lters hidden)
Humidication outlet
Side air inlet grill
(both sides
of machine)
Remote control
and storage
Carry handle
Water tank release clip
Water tank
Power outlet
Drainage cap
Main lter
Odour lter
Remote control
5
Getting started
BEFORE YOU BEGIN
IMPORTANT: Remove all packaging covering the appliance. Make sure the lters are in place and correctly tted before switching on.
Stand the machine on a hard at surface away from sources of heat. Never block the air grills: keep them free from any obstruction.
Stand the appliance on a hard at
surface. Make sure the air grills
are free from any obstructions.
6
Remove the remote control
stored on board at the back
of the machine.
Press the water tank release
button and pull water tank
to remove.
Twist the water tank cap
anti-clockwise to remove.
Fill the water tank with water
to the max ll line. To prevent
build up of limescale especially
in hard water areas, ltered
water is recommended.
Do not add any fragrances or
scented oils to the water tank.
Replace the water tank cap
twist clockwise to tighten.
Turn the water tank so the cap
is at the bottom. Line up the
water tank with the machine
inserting the bottom of the water
tank into the machine rst.
Push back until water tank
cover clicks into place.
Check the supplied lters
are properly in place and
all plastic is removed before
switching the machine on.
7
Using your machine
IMPORTANT: The control panel is touch sensitive, lightly press the controls. The remote control has the same operating functions as the control panel.
When the machine is activated the digital humidity reading of the room and the spinning image of the fan will constantly be displayed. Humidication starts
after the initial water cycle. Mist may not be visible in all conditions or if the water tank is empty.
Remote control
8
Power On/O
Fan speed
Timer setting
Sleep mode
Humidier control
Using the control panel
The buttons will illuminate
brightly when pressed. The
illumination will then dim
D
Sleep
E
Humidity
C
Timer
F
Reset Filter
B
Speed
A
On/O
A
On/O
Press the ‘On/O’ button once to switch the machine on. The air purier
will activate (the speed button on the control panel will also illuminate).
B
Speed
The fan will activate on a medium speed when the machine is switched on.
Press the ‘speed’ button to select the desired fan speed – Low, Med,
High & Turbo. On the digital display panel a fan image will interpret the
fan speed as the speed selected increases or decreases.
C
Timer
The timer can be set between 1-8 hours. The number of hours selected
will show on the display panel underneath the image of a clock face.
Press the ‘timer’ button to select the number of timed hours required.
Once the timer cycle has complete, the machine will run at a medium speed.
If the timer is not set the machine will constantly operate at a medium speed.
If the timer is set in standby mode, the appliance will turn on at a medium
speed once the timer cycle has completed.
D
Sleep
Press the ‘sleep’ button, the fan speed will select Low and the LCD on the
machine will auto dim.
E
Humidity
Press the ‘Humidity’ button to activate the humidier
and continue pressing to select the required humidity target. The target
required will show on the display panel alongside the current RH%
(Relative Humidity). Mist and vapour will disperse through the small
grill behind the control panel. The humidier will be switching on/o
automatically every time the target RH% is below or equal to the current
RH% until the tank runs empty or the humidier function is switched o.
F
Reset lter
After replacing lters, insert a small blunt instrument such as a pen
nib into the reset insert and hold down for a few seconds to reset the
lter life calculator. A beep sound will be heard to conrm the lter
reset has been set.
9
Taking care of your machine
EMPTY WATER TANK
When the water tank is empty or runs dry in the humidication mode,
the digital display will ash an empty water tank symbol. The water empty
water tank symbol ashes even if the humidity is not on. Rell tank as specied
in the 'Getting started' section of this guide.
EMPTYING THE WATER TANK AND DRAINING THE MACHINE
Turn o and unplug the unit.
Press the water tank release
button and pull to remove.
10
Twist the water tank cap
anti-clockwise and remove.
Empty over a sink and rinse tank.
Stand the machine over
a sink or bath and pull
to remove the drainage cap.
Do not leave water stored
in the water tank between
uses. The water tank
should be emptied after
each use and re-lled with
fresh water before use.
CAUTION
Tilt the machine allowing
the excess water to drain.
Using a dry cloth wipe the
reservoir underneath where
the water tank would sit.
Make sure the water tank lid is
tightly tted and turn the water
tank so the cap is at the bottom.
Line up the water tank with the
machine inserting the bottom of
the water tank into the machine
rst. Push back until water tank
cover clicks into place.
Push the drainage cap back
into place, making sure
it is correctly tted.
11
Taking care of your machine
REPLACING THE FILTERS
The lter life bars on the display panel will decrease gradually throughout
the use of the machine. When the lters need replacing the life bars will ash
and the display panel will turn red.
Turn o and unplug the unit.
Pull either side of the front
cover to remove.
12
Pull to remove the
lters from machine.
Remove all packaging from new
lters. Line up odour lter,
(the odour lter is reversible
and can be tted either side)
press onto the hook and eye
tabs to attach to main lter.
The lters should be
replaced every 3-6 months
dependent on use.
CAUTION
Line up and ret the new
lters into the machine.
Line up tabs on the bottom
of the lter, cover with the tabs
on the machine. In a hinge like
manner push the cover until
it clicks into place.
Plug the appliance into a power
source and press the on button.
Insert a small blunt instrument
such as pen nib into the reset
insert and hold down for a few
seconds to reset the lter life
calculator. A beep sound will be
heard to conrm the lter reset
has been set and the LCD screen
will turn blue again.
13
What to do if it goes wrong
SolutionProblem
• The plug may not be fully pushed into the electrical socket.
Why does my
air purier have
no power?
Why is water
leaking from
my machine?
Why is the digital
display on the
control panel red?
14
• Check the fuse in the plug. If this needs replacing, always replace with a 5amp British fuse.
• The front cover may not be secure. Check the front cover is securely tted.
Go to ‘Taking care of your machine’.
• The lter may not be tted correctly. Check the lter. Go to ‘Taking Care of your machine’.
• Timer may have nished. Re-set the timer. Go to ‘Using your machine’.
• The machine may not have been positioned correctly. Place the machine on a at, stable, solid surface.
• The water tank cap may not have been tightened. Go to ‘Getting started’.
• The machine may have been moved or tilted with water in the water tank. Remove water tank, drain
machine and wipe dry reservoir. Go to ‘Taking Care of your machine’.
• The drainage cap may not be correctly tted. Go to ‘Taking Care of your machine’.
• The water tank may be empty. Go to ‘Taking Care of your machine’.
• The lters may need replacing. Go to ‘Taking Care of your machine’.
We're here if you need us
Online: vax.co.uk/support
Call: (UK) 0844 412 8455 (ROI) 1-800 928 308
Monday-Friday 8:30am to 6:30pm, Saturday 9:00am to 5:00pm*
Alternatively, you can write to us at:
Vax Ltd., Kingswood Road, Hampton Lovett, Droitwich, WR9 0QH, UK
Getting in touch…
It's quick and easy to register for your FREE guarantee
Online at: vax.co.uk/guarantees
Please retain your original receipt for proof of purchase.
* Calls are charged at the UK local rate. Please make a note of the serial number and model number of the air purier before calling.
†
Registration required. Terms and conditions apply.
†
15
GET IN TOUCH
0330 026 8455 VaxVacu umsinfo@vax.co.uk vax.co.uk @Vax UK
EEC Statement of Compliance: Manufacturer/EEC importer: Vax Limited, hereby on our own responsibility, declare that the ACKRV101 manufactured in compliance with the
following Directives: Safety: 2006/95/EC Low Voltage Directive. EMC: 2004/108/EC Electromagnetic Compatibility Directive.
Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist. Check with your Local Authority or retailer for recycling advice.
© 2015 Vax Limited. All rights reserved. The VAX trade mark and Vax lozenge is the property of Techtronic Floor Care Technology Ltd and is registered in the EU and may be
pending or registered in other countries.
Loading...