VAUXHALL Combo Quick Reference Guide

Vehicl e fe a t u r es
Combo
Quick Reference Guide
Refer to Owner’s Manual for detailed information. Note: some items described may be optional 3.
Instruments and controls
Releasing steering column lock:
Turn the key to position 1 and move the steering wheel slightly. Positions: 0 = Ignition off 1 = Steering released, ignition off 2 = Ignition on, diesel engine: preheating 3 = Start
Manual transmission:
Reverse gear: with vehicle stationary, pull up ring 3 seconds after de-clutching and engage gear.
If the gear does not engage, set the lever in neutral, release the clutch pedal and depress again; then repeat gear selection.
To unlock and open rear doors:
Turn key to vertical position - or - press button q on remote control, pull handle and open rear door. To open left rear door, pivot handle on the inside.
Starting the engine:
Manual transmission in neutral, depress clutch, apply foot brake, (Easytronic in N), do not accelerate, turn key to 3. (With diesel engines only: turn key to 2, wait for preheating indicator ! to go out, turn key to 3).
Easytronic transmission:
Current gear is displayed in the transmission display.
The engine can only be started with the lever in position N and with the foot brake depressed. The display shows N. If the foot brake is not depressed, N flashes in the display and the engine will not start.
Tyre pressures (psi)*, Combo Engine Tyres Front Rear
Z 13 DTJ All tyres 35 35 Z 14 XEP All tyres 35 35 Z 17 DTH All tyres 35 35 Y 13 DT All tyres 35 35
With load of up to 2 persons and 100 kg load
*
Tyre pressures (psi)**, Combo
Z 13 DTJ All tyres 35 51 Z 14 XEP All tyres 35 51 Z 17 DTH All tyres 35 51 Y 13 DT All tyres 35 51
With full load
**
Light switches:
8 Parking lights 9 Dipped or main beam > Front fog lights 3 r Fog tail light 0 Courtesy light k Instrument illumination ? Headlight range adjustment 3
Headlight range adjustment 3:
Reduces dazzle for oncoming traffic.
Combo Crew van:
0 = Front seats occupied 1 = All seats occupied 2 = All seats and load 3 = Driver’s seat and load
Combo:
0 = Seats occupied 1 = Seats and half load 2 = Seats and full load 3 = Driver’s seat and full load
Manual mode:
+ = Shift to higher gear
- = Shift to lower gear Starting-off aid
For starting-off on slippery surfaces: Press button T - indicator illuminates, vehicle pulls away in 2nd gear. Press button again to switch off.
Transmission fault
Indicator A illuminates.
Tyre pressures (psi)*, Combo Crew van Engine Tyres Front Rear
Z 13 DTJ All tyres 35 35 Z 14 XEP All tyres 35 35 Z 17 DTH All tyres 35 35 Y 13 DT All tyres 35 35
*
With load of up to 2 persons and 100 kg lo ad
Tyre pressures (psi)**, Combo Crew van
Z 13 DTJ All tyres 35 51 Z 14 XEP All tyres 35 51 Z 17 DTH All tyres 35 51 Y 13 DT All tyres 35 51
With full load
**
All temporary space saver spares = 61 psi
1. Side ai r v en ts
2. Front passenger’s airbag 3
3. Infotainment system 3
4. Hazard warning lights,
5. Display 3 for time, date, outside temperature, Infotainment system 3.
6. Centre air vents
7. Turn signals, headlight flash, dipped beam, main beam
8. Horn
Vehicle security
Unlocking:
Press button q on remote control - or ­turn key in driver’s door lock towards front of vehicle, turn key back to the vertical position and remove; to unlock from inside, pull up lock button on driver’s door. Key design may vary.
9. Steering wheel remote control 3
10. Instruments
11. Windscreen wiper and wash system,
rear window wash system 3
12. L igh t switch
13. Headlight range adjustment 3, fog tail light, front fog lights 3, instrument illumination
14. Bonnet release lever
15. Starter switch with steering column lock
16. Steering wheel adjustment 3
Locking:
Press button p on remote control - or ­turn key in driver’s door lock towards rear of vehicle, turn key back to the vertical position and remove; to lock from inside, press lock button on driver’s door. Press button p twice within 10 seconds to switch on mechanical anti-theft locking.
17. Accelerator pedal
18. Brake ped al
19. Clutch pedal 3
20. Seat heating 3
21. Accessory socket or
cigarette lighter 3
22. Ashtray 3
23. Air conditioning system 3, heated rear window 3, air recirculation system 3
24. Heating and ventilation system
25. Glove compartment
Electronic immobiliser
z Deactivated when key is in ignition. z Activated when key is removed.
Engine cannot be started in any other way so keep spare key in a safe place!
June 2007 TS 1650-A-08
Vehicle features
Vehicl e fe a t u r es
Seat position adjustment:
Pull handle, slide seat, release handle and allow seat to audibly latch into position.
Folding down front passenger’s seat backrest 3
Push passenger seat head restraint down or remove. Fold front passenger seat forward by raising release lever.
Fitting the seat belt:
Draw smoothly from inertia reel, guide over shoulder and engage in buckle.
The belt must not be twisted at any point. The lap belt must fit snugly across the body. The seat backrest must not be tilted too far back (recommended maximum tilting angle approx. 25 degrees).
To release belt, press red button on belt buckle.
:
Backrest adjustment:
Turn handwheel to adjust backrest to a suitable position. Do not lean on backrest whilst adjusting it.
Adjusting head restraint height 3:
Tilt forwards to release, hold firmly and adjust height, then release.
Important:
10 inches (25 cm) from steering wheel to permit safe airbag deployment.
Electrically operated door windows 3:
Two rocker switches in the driver’s door handle for the driver and front passenger’s side door windows.
Additional switch in the front passenger’s door handle.
To operate window in stages, tap appropriate switch. For automatic opening or closing, keep switch pressed slightly longer. To stop window movement, tap switch again.
Do not sit nearer than
Adjust seat height:
Pull lever at side and remove weight from seat to raise it or press down on seat with body weight to lower it.
Adjusting steering wheel position 3:
Swivel lever down, adjust height, swivel lever up, engage into position.
Adjust steering wheel only when vehicle is stationary and steering column lock is released.
Electrically adjustable exterior mirrors 3:
Four-way switch in driver’s door handle.
Toggle switch to left or right: four-way switch moves appropriate mirror.
Switching on dipped or main beam:
Main beam = Push stalk forwards Dipped beam = Push forwards again.
Headlight flash:
Pull stalk towards steering wheel.
Windscreen wiper:
Move stalk up
§ = Off $ = Adjustable timed interval wipe % = Slow & = Fast
Setting wiper interval to a value between 2 and 15 seconds:
z Set stalk to timed interval wipe $ z Set stalk to § z Wai t for d esi r ed int erva l z Set stalk to timed interval wipe $
The interval remains stored until next change or until ignition is switched off. Switching ignition off and moving stalk to $ sets interval to 7 seconds.
Engine oil:
Check every 600 miles and prior to long journeys.
Important:
to maintain the correct level of an appropriate quality oil in the engine.
It is the owner’s responsibility
Operating turn signal lights:
Stalk in rest position Right turn = Upwards Left turn = Downwards
When the steering wheel is turned back, the stalk automatically returns to its original position. This will not happen when making a minor steering manoeuvre such as changing lanes. When lane changing, move stalk to resistance point. When released, stalk will spring back.
Operating windscreen wash system:
Pull stalk towards steering wheel. Wash fluid is sprayed onto the windscreen; at the same time the wiper is operated for several cycles.
Refuelling:
Use unleaded fuel for petrol engines. Fuel tank capacity = 52 litres.
Hazard warning lights:
On = Press ¨ Off = Press ¨ again
To aid location of the pushbutton, the red surface is illuminated when the ignition is switched on. When the button is pressed, its control indicator flashes in time with the hazard warning lights.
Rear window wiper and wash system 3
Wiper on = Push stalk forwards Wiper off = Pull stalk towards
Wash = Push stalk forwards
The rear window wiper operates in timed interval mode.
The wiper will swipe for a few strokes when washing.
Warning:
In freezing conditions, wiper blades can freeze to windscreen. Release blades from the ice before operating windscreen wiper to prevent wiper motor damage.
steering wheel
and hold
:
Loading...