VASTEX V-1000, V-2000 Installation And Operating Insctructions

Cap Printing Attachment

1

V-1000 & V-2000 Printers

Installation and Operating Instructions

Doc # 01-08-041

Installation:

Cap Screen

1. Remove existing pallet assembly from the rotor
arm.

2. V-1000, attach the hat pallet assembly to the pallet
arm with the four 3/8 pallet leveling bolts, washers,

Pallet Arm

and nuts as shown (locking knob facing up and to
the left). Slide assembly onto the rotor arm.
V-2000, install the hat pallet assembly directly to
the top of the rotor arm.

3. Insert the screen side clamp assembly and screen
into the screen holder.

Rotor Arm

4. Setting Off Contact
V-1000, raise or lower the hat pallet assembly
by adjusting the nuts on 3/8 leveling bolts or
through the screen clamp assembly.

Hat Pallet Assembly

Spring loaded tensioner

V-2000, Loosen slightly the main head bolts and
adjust with the left and right pitch knobs. Retighten

Cap Printing Attachment on V-1000

main head bolts after adjusting.

Operating:

1. Hook the back of the hat over the spring loaded ten­sioner and pull the hat up over the pallet. If addi­tional spring pressure is needed move spring mount
brackets to the lower set of holes in the vertical
support.

Cap Screen

2. Lower the side clamp assembly with cap screen
over the hat. Slide side clamp assembly and
screen to position artwork over cap.

Rotor Arm

3. Set desired off contact and test print.

Note: Do not over tighten the bolt in the plastic hat pal­let. Additional hat pallet shapes are shown on page 2

Screen Side Clamp Assembly

Nut
Washer
Washer
Nut
Nut
Bolt

Screen Side
Clamp Assembly

Vastex E-mail assistance

Purchasing & Product Info:

[e-mail]

Electrical Support:

[e-mail]

Tech Support, Mechanical Setup, and Operation

[e-mail]

Screen Printing Issues & Support:

[e-mail]

Hat Pallet Assembly

Cap Printing Attachment on V-2000

Spring loaded tensioner

2