VASTEX C-100 Assembly, Operating, And Maintenance Instructions

YearofManufacture:

Assembly, Operating, and Maintenance Instructions

20____

C-100 Screen Coater

Doc.#01‐18‐005b

OriginalInstrucons

Shownwithoponalstand

Pg #

 Screen Coater Assembly 2-3

 Stand Assembly (optional) 4-5

 Safety, Operation, and Maintenance 6

 Warranty 7

Electrical Drawing #:

Serial Number:

(Please log your machine's serial number and date of purchase for future reference.)

VTX

Rev:______

Date:____/____/______

Vastex International, Inc.

7 Emery Street
Bethlehem, PA 18015 USA

Phone# [phone] Fax# [phone]

ite www.vastex.com

Web S

Authorized Representative in Europe:
Certification Experts BV
Nieuwstad 100 1381 CE Weesp,
The Netherlands
Tel : + 31 (0) 294 – 48 33 55
Fax : + 31 (0) 294 – 41 46 87

Vastex E-mail assistance

Purchasing & Product Info:

[e-mail]

Electrical Support:

[e-mail]

Tech Support, Mechanical Setup, and Operation:

[e-mail]

Screen Printing Issues & Support:
[e-mail]

Assembly

2

Tools Needed: (1) Philips Head Screwdriver, (1) Flat Blade Screwdriver, (1) 7/16 wrench

1) Remove all parts from the box they were shipped in.

For Wall Mount Units:

2) Attach the Mount Plate to a wall in your shop. Use 3
screws with wall anchors. (Hardware Supplied)

For Stand Mounted Units:

3) Attach Stand Mount brackets to the Mount

plate using the supplied 1/4-20 x 3/4” long bolt
and serrated hex bolt. Tighten with a 7/16”
open end wrench. The Clamping bracket is
installed to each Stand Mount with a 1/4-20 x
1/2” long bolt and serrated hex nut. Leave
these bolts loose for now.

3a

2

Mount Plate

1/4-20x1/2” Bolt

3b

Stand Mount

Spine

Assembly

4) Hang the Spine assembly onto the Mount
Plate. The Spine hooks onto the Mount plate
as shown to the right.

1/4-20x3/4” Bolt

4a

Clamping
Bracket

Serrated
Hex Nuts

4b

Assembly Cont’d

3

5) Slide the Lower Screen Holder Assembly onto the Spine
Assembly from the bottom as shown on the right. Next
attach Extension Springs onto the Lower Screen Holder
Assembly and Spring Mount as shown. To decrease
amount of pressure on screen, use the lower spring
mount locations.

6) Install Upper Screen holder at desired position as shown
below. The Spine is marked to indicate which notch is
used for each size screen.

6a

6b

6c

5a

5b

6d

36” Tall Screen Location

Upper Screen Holder

Spine

7) To install a screen onto the C-100, install the Upper
Screen Holder at the appropriate position (See Step 6).
Then push down on the Lower Screen holder with the bot­tom of the screen, pivot the screen in and guide it into the
Upper Screen Holder.

7a

31” Tall Screen Location

28” Tall Screen Location

23”/24” Tall Screen
Location

7b