Page 1
LED TouchWash 24x8W RGBW IP65
User Manual
Page 2
2 / 9
Table of contents
1. Safety instructions ............................................................................................................................ 3
1.1. FOR SAFE AND EFFICIENT OPERATION ............................................................................ 3
2. Introduction ....................................................................................................................................... 4
2.1. Foreword .................................................................................................................................. 4
2.2. Description ............................................................................................................................... 4
3. Properties ......................................................................................................................................... 4
3.1. Fittings ..................................................................................................................................... 4
3.2. Specifications........................................................................................................................... 5
4. Menu................................................................................................................................................. 5
5. DMX Table ....................................................................................................................................... 8
5.1. DMX Mode 1 (1 Channel) ........................................................................................................ 8
5.2. DMX Mode 4 (4 Channel) ........................................................................................................ 8
5.3. DMX Mode 8 (8 Channel) ........................................................................................................ 8
Page 3
3 / 9
1. Safety instructions
• This device is suitable for indoor use only.
• All modifications to the device will void the warranty.
• Repairs are to carry out by skilled personnel only.
• Use only fuses of the same type and original parts as spare parts.
• Protect the unit from rain and humidity to avoid fire and electric shocks.
• Make sure to unplug the power supply before opening the housing.
1.1. FOR SAFE AND EFFICIENT OPERATION
Be careful with heat and extreme temperature
Avoid exposing it to direct rays of the sun or near a heating appliance.
Not put it in a temperature bellow 32°F /0°C, or exceeding 104°F /40°C.
Keep away from humidity, water and dust
Do not place the set in a location with high humidity or lots of dust.
Containers with water should not be placed on the set.
Keep away from sources of hum and noise
Such as transformer motor, tuner, TV set and amplifier.
To avoid placing on un-stable location
Select a level and stable location to avoid vibration.
Do not use chemicals or volatile liquids for cleaning
Use a clean dry cloth to wipe off the dust, or a wet soft cloth for stubborn dirt.
If out of work, contact sales agency immediately
Any troubles arose, remove the power plug soon, and contact with an engineer for repairing,
do not open the cabinet by yourself, it might result a danger of electric shock.
Take care with the power cable
Never pull the power cable to remove the plug from the receptacle, be sure
to hold the plug. When not using the device for an extended period of time, be sure to
disconnect the plug from the receptacle
.
Page 4
4 / 9
Important: Damages caused by the disregard of this user manual are not subject to
warranty. The dealer will not accept liability for any resulting defects or
problems. Make sure the electrical connection is carried out by qualified
personnel. All electrical and mechanical connections have to be carried out
according to the European safety standards.
2. Introduction
2.1. Foreword
Thank you, for buying the LED TouchWash. Every TouchWash has been thoroughly tested and
shipped in perfect condition. Please check carefully the packaging for damage. If the packaging is
damaged, check also the device for damage to make sure that it works accurate.
2.2. Description
The LED TouchWash is a LED color changer with 24 powerful RGBW full color LEDs. You can
use the device in “Stand alone”-mode or in “Master-Slave”-mode. The configuration you can make
easy on the operating panel.
3. Properties
3.1. Fittings
• DMX-512
• Waterproof housing (IP65)
• 10 preset programs
• Flicker-free dimming 0-100%
• Integrated valve allow humidity to escape
• 3 DMX modes (1, 4 and 8 channels)
Page 5
5 / 9
3.2. Specifications
• 24x 8W RGBW LED
• 30mm lenses with 25°
• 90° pivot vertically
• Waterproof (IP65)
• DMX control
• Switching power supply (100-240V, 50/60Hz)
• 230W input
4. Menu
The TouchWash has an Menu which is easy to operate. It follows a description about the function of
menu. Please read this chapter carefully.
Menu
Addr
1
DMX address adjust: 1…512
512
Chnd
1 Ch
3DMX modes: 1 Ch … 8 Ch 4 Ch
8 Ch
Auto
Au 0 SP1
Aut0…Aut9: 10 automatic programs with speed
adjust
… …
Au 9 SP9
Colo
1
51 preprogrammed color blends …
51
Stat
red
Setup dimmer for every color and speed adjust flash
blue
green
white
Stro
Slav
Sla Master/Slave mode
Info
ux software version
PASd
On/Off Activates password protection
Push the MENU-button, to get to the menu. Push the UP/DOWN-button until you reach the point of the
menu which function you want to set. Push the ENTER-button. Change the setting with the
UP/DOWN-button and confirm your setting with the ENTER-button.
Page 6
6 / 9
Addr – Setting for the start of the DMX address
1. Push the Enter MENU-Button, then the UP/DOWN-button until you can read “Addr” in the
display. Confirm with ENTER.
2. The display shows “Axxx”. “x” is the current address. Set with the UP/DOWN-buttons the
right address and confirm with ENTER.
Chnd – Setting of the DMX mode
1. Push the Enter MENU-Button, then the UP/DOWN-button until you can read “Chnd” in the
display. Confirm with ENTER.
2. The display shows “x Ch”. “x” is the current mode. Set with the UP/DOWN-buttons the
right mode and confirm with ENTER.
Auto – Setting of automatic mode
1. Push the Enter MENU-Button, then the UP/DOWN-button until you can read “Auto” in the
display. Confirm with ENTER.
2. The display shows “Autx”. “x” is the current mode. Set with the UP/DOWN-buttons the
right mode and confirm with ENTER.
3. The display shows “SPx”. With point of menu you can set the speed of the program. Set
the speed with the UP/DOWN-buttons confirm with ENTER.
Colo – Preprogrammed color blends
1. Push the Enter MENU-Button, then the UP/DOWN-button until you can read “Colo” in the
display. Confirm with ENTER.
2. The display shows “Coxx”. “x” is one of 51 preprogrammed color blends. Set with the
UP/DOWN-buttons the right color blend and confirm with ENTER.
Stat – Manual setting colors/flash
1. Push the Enter MENU-Button, then the UP/DOWN-button until you can read “Stat” in the
display. Confirm with ENTER.
2. You can choose between 5 options. Choose the option you want and confirm with ENTER.
Set the right value and confirm with ENTER.
1) Red 000-255
2) Green 000-255
3) Blue 000-255
4) White 000-255
5) Strob 00-30
Page 7
7 / 9
Slav – Setting of Master/Slave-mode
1. Push the Enter MENU-Button, then the UP/DOWN-button until you can read “SLav” in the
display. Confirm with ENTER.
2. The display shows “Sla”, now the device is controlled by the master device.
Info – Shows the current software version
1. Push the Enter MENU-Button, then the UP/DOWN-button until you can read “Info” in the
display. Confirm with ENTER.
2. The display shoes the current software version.
Pasd – aktivate or deaktivate the display buttons
1. Tap the MENU button until“Pasd” is displayed. Press the ENTER button to choose ON or
OFF
2. Deaktivate the display buttons.
Tap any button til is displayed.
Now tap „MENU“, „UP“, „DOWN“ ,“ENTER“ to get into the main menu.
Page 8
8 / 9
5. DMX Table
5.1. DMX Mode 1 (1 Channel)
DMX Value Function
Channel
0
Off
1 1-4
Color 1
5-9
Color 2
10-14
Color 3
…
…
240-244
Color 48
245-249
Color 49
250-254
Color 50
255
Color 51
5.2. DMX Mode 4 (4 Channel)
DMX Value Function
Channel
1 0-255 Dimmer red LEDs
2 0-255 Dimmer green LEDs
3 0-255 Dimmer blue LEDS
4 0-255 Dimmer white LEDs
5.3. DMX Mode 8 (8 Channel)
DMX Value Function
Channel
1 0-255 Dimmer
2 0-255 Dimmer red LEDS
3 0-255 Dimmer green LEDs
4 0-255 Dimmer blue LEDs
5 0-255 Dimmer white LEDS
6 0-255 speed adjust flash
7
0
Off
1-27
Auto 0
28-55
Auto 1
56-83
Auto 2
84-111
Auto 3
112-139
Auto 4
140-167
Auto 5
168-195
Auto 6
196-223
Auto 7
224-251
Auto 8
252-255
Auto 9
8
0-255 speed adjust slow-fast
Page 9
9 / 9
Importer:
B & K Braun GmbH
Industriestraße 2
D-76307 Karlsbad
www.bkbraun.com
info@bkbraun.com
Loading...