User’s manual
Giga Bar II
2 / 9
Table of content
1.
Safety instructions ........................................................................................................................... 3
2. Unpacking: ....................................................................................................................................... 4
3. Introduction: ..................................................................................................................................... 4
3.1. Features ................................................................................................................................... 4
4. System Menu ................................................................................................................................... 5
4.1. DMX control mode ................................................................................................................... 6
4.1.1. DMX Channel and function .............................................................................................. 7
4.1.2. DMX Values and functions .............................................................................................. 7
5.
Technical data .................................................................................................................................. 8
3 / 9
1. Safety instructions
FOR SAFE AND EFFICIENT OPERATION
Be careful with heat and extreme temperatureAvoid exposing it
to direct rays of the sun or near a heating appliance.
Not put it in a temperature bellow 41°F /5°C, or exceeding 95°F /35°C.
Keep away from humidity, water and dust
Do not place the set in a location with high humidity or lots of dust.
Containers with water should not be placed on the set.
Keep away from sources of hum and noise
Such as transformer motor, tuner, TV set and amplifier.
To avoid placing on un-stable location
Select a level and stable location to avoid vibration.
Do not use chemicals or volatile liquids for cleaning
Use a clean dry cloth to wipe off the dust, or a wet soft cloth for stubborn dirt.
If out of work, contact sales agency immediately
Any troubles arose, remove the power plug soon, and contact with an engineer for repairing,
do not open the cabinet by yourself, it might result a
danger of electric shock.
Take care with the power cable
Never pull the power cable to remove the plug from the receptacle, be sure
to hold the plug. When not using the player for an extended period of time
be sure to disconnect the plug from the receptacle
.
4 / 9
2. Unpacking:
Thank you for purchasing the Gigabar. Every Gigabar has been thoroughly tested and has been
shipped in perfect operating condition. Carefully check the shipping carton for damage that may have
occurred during shipping. If the carton appears to be damaged, carefully inspect your fixture for any
damage and be sure all equipment necessary to operate the unit has arrived intact. In the event
damage has been found or parts are missing, please contact your dealer for further instructions.
Please do not return this unit to your dealer without contacting him first.
3. Introduction:
The Gigabar is a three channel or five channel or eight channel or fourteeen channel or twenty –four
or twenty-six channel. The fixture can operate in three different operating modes; DMX contorl, soundactive, or in a Master/Slave configuration. The Giga Bar comes with several built in programs that can
be used, while operating as a dimmer unit or when used in multiples linked in a master/slave
configuration. For best results use fog or special effects smoke to enhance the beams projections.
Warning! To prevent or reduce the risk of electrical hock or fire, do not expose this unit to rain or
moisture.
Warning! This may cause severe eye damage. Avoid looking directly into the light source at all times!
3.1. Features
• RGB Color Mixing
• Color Strobe Effect
• Color Mix Effect
• LED Chases (Adjustable Speeds)
• Electronic Dimming 0-100%
• Built in Microphone
• DMX-512 protocol
• Seven DMX Modes (See pages 8-9)
• 3 Operating Modes - Sound Active, Show Mode, or DMX Control
• DMX-512 Protocol Compatible (Uses three , five ,eight , fourteen , twenty-four or twenty-six DMX
Channels)
• 3 Operating Modes - Master/Slave; dmx-control; Sound Active
• Digital Display for Address and Function Setting
5 / 9
4. System Menu
On-Board System Menu. The Giga Bar comes with an easy to navigate system menu. This next
section will detail the functions of each command in the system menu. Please read the next section
thoroughly!
To access the main menu press the ESC button. Tap the UP or DOWN buttons until you reach
function you wish to change. When you reach the function you wish to change press the ENTER
button. When a function is selected use the UP or Down buttons to change the function settings. Once
your changes are made press the ENTER button,
Addr - DMX Address Setting via control
board and moter setting
1. Tap the ESC button and UP button or
DOWN button until “Addr” is displayed, press
ENTER.
2. “Axxx” will now be displayed, “x” represents
the displayed address. Press the UP or
DOWN buttons to find your desired address.
Auto - This menu will let you select your
desired auto mode
1. Tap the ESC button and UP button or
DOWN button until “Auto” is displayed, press
ENTER.
2. “Autx” will now be displayed, You can
confirm three modes by UP or DOWN for auto
mode.
Chnd - This menu will let you select your
desired DMX Channel mode.
1. Tap the ESC button and UP button or
DOWN button until “Chnd” is displayed, press
ENTER.
2. “X Ch” will now be displayed, “X” represents
the displayed DMX channel mode. Press the
UP or DOWN buttons to find your desired
Channel mode.
6 / 9
Colo - This menu will let you select your desired sound mode
1. Tap the ESC button and UP button or DOWN button until “CoLo” is displayed, press ENTER.
2.Either “CoL X”, “X” representing a number between 1-9 or “AtF ” will be displayed. Press the UP or
DOWN buttons to select either a static color or “AtF ” mode. If you select a static color press ENTER
and it will be confirmed
. “AtF ” Make your own color by mixing and adjusting the red, blue and green manually. Select
“AtF”, press ENTER,,”red ” ”Gree ”or”blue” will be displayed. red is first, press ENTER ,then you can
adjust it between 1-255, press ESC ,you can select other color by UP or DOWN and then press
ENTER to adjust it..
soun - This menu will let you select your desired sound mode
1. Tap the MENU button until “Soun” is displayed, press ENTER.
2. “Soux” will now be displayed, You can confirm three modes by UP or DOWN for sound mode.
SLav- This menu will let you select your desired Master/slave mode
1.Tap the MENU button until “SLav” is displayed, press ENTER.
2. “Sla ” will now be displayed,Slave mode is confirmed. It will be slaved by auto mode sound mode
and chase mode
VER - This will display the software version
1. Tap the MENU button until “VER” is displayed. Press the ENTER button and the software vesion
will be displayed.
2. Press the MENU button to leave this function.
4.1. DMX control mode
This function will allow you to control each individual fixtures traits with a standard DMX-512 controller
Universal DMX Control: This function allows you to use a universal DMX-512 controller to control head
movement, A DMX controller allows you to create unique programs tailored to your individual needs.
1. The Giga Bar uses six DMX channel modes . See next page for detailed description of the DMX
traits.
2. This will allow you to create your own programs.
3. Follow the instruction on page 16 to set the DMX address.
7 / 9
4.1.1. DMX Channel and function
4.1.2. DMX Values and functions
8 / 9
Note:when the function is strobing, the LED will be dimmered by channel 3-26 for channel mode.
5. Technical data
Voltage: 100V~120V/60Hz or 220V~240V/50Hz
LEDs : 216 x 10mm LEDs (72 Red, 72 Green, & 72 Blue)
Power Consumption: 20W
Fuse : 1Amp
Weight: 4.3Kgs.
Dimensions : 965 x 64 x 153mm
Colors : RGB Color Mixing
DMX Channels : 3, 5, 8, 14, 24, & 26 DMX Channel Modes
9 / 9
Importeur:
B & K Braun GmbH
Industriestraße 1
D-76307 Karlsbad
www.bkbraun.com
info@bkbraun.com
Loading...