VariZoom VZROCKDVX User Manual
VZ-ROCK-DVX Instructions
Thanks for buying the VZ-ROCK-DVX, our new zoom control for the Panasonic DV ProLine
series camcorders. The ROCK-DVX will provide remote control of variable-speed zoom and
record start/stop. We think you will enjoy this product, but before using it please read the
instructions thoroughly.
NOTE: THIS IS NOT A “LANC” CONTROL DEVICE. DO NOT PLUG THE VZ-ROCK DVX
INTO ANY CAMCORDER OTHER THAN PANASONIC DV PROLINE UNITS. THIS
CONTROLLER SHOULD ONLY BE PLUGGED INTO THE JACK LABELED “REMOTE”
ON THESE PANASONIC CAMCORDERS.
1. First, loosen the brass clamp nuts and
fix the controller to your tripod handle,
jib, or shoulder support (or use it handheld).
2. Using the controller is as simple as
turning on your camcorder and
plugging the unit into the jack labeled
“Remote”.
3. To zoom in (telephoto) press the zoom rocker right, and to zoom out (wide)
press the rocker left. The farther you press the rocker, the faster the lens will
zoom (within the normal operating limits of the lens assembly). The zoom
characteristics of the ROCK-DVX are determined by the camera (e.g., the
slowest zoom speed attainable with the DVX100A/B takes 30 seconds from
end-to-end, while it takes 100 seconds on the DVC30).
4. You can also start and stop recording by pressing the “R” button.
Troubleshooting: 1) Zoom Creeping (unwanted zooming): Recalibrating the zoom center is easy. With the
controller connected to your camera, loosen the brass set screw on the underside of the rocker with a 5/64” hex
key (alan wrench), holding the rocker firmly in place. On the backside of the rocker is a hole with a slotted shaft,
and this is where you adjust the zoom center with a flat screwdriver. Turn it slightly left and right and you’ll see
the camera zoom in and out – find the centermost point between the zoom in/out start positions, then tighten the
brass set screw (don’t overcrank it).
Warranty Warning! Do not open your control device, as this may void your warranty and possibly damage the
controller. If you need service, contact VariZoom for a Return Merchandise Authorization (RMA #). All controls
have a 2-year parts and labor warranty. Please save your receipt and send us your comments and suggestions.
Thanks!
-- please keep this document for your records & reference -512-219-7722
Visit us on the web at www.varizoom.com
Loading...