VariZoom VZPGL User Manual
VZ-PG-L – Pistol-Grip LANC
Camera Control Operating Manual
Thank you for purchasing the VariZoom VZ-PG-L remote variable-speed zoom and
focus controller for LANC-enabled camcorders. We think you’re going to like it a lot.
Here are some important guidelines for safe and effective operation…
Connection: Insert the VZ-PG-L cable plug into your camera’s LANC
jack only. Do not plug into any port not clearly labeled specified as the LANC
CAUTION! Do NOT plug control into ANY OTHER JACK or DAMAGE
may result to your camera and control! DO NOT PLUG IN TO ANY
PANASONIC CAMERA!!!
Power: The VZ-PG-L does not require batteries or external power. Just
plug the cable into the camera’s LANC jack, and it’s ready to use.
Tripod / Jib Mount: Your VZ-PG-L comes with a heavy-duty
clamping system to attach firmly to your tripod pan handle, shoulder support or
camera crane/jib. Extension LANC cables are available from VariZoom.
Recording: Press the red button next to the rocker to activate the
record/pause function. The red LED will light up when camera is recording and
may also blink to give to indicate low battery power and end-of-tape.
Zoom: Press the rocker on the right side for zoom in (Telephoto). Press
the rocker on the left side for zoom out (Wide). Zoom speeds are dependent
upon the position of the speed control knob.
Variable Zoom and Speed Settings: Turn the speed control knob all the
way clockwise until it stops. This is your slowest speed setting. By pressing on
either the right or left side of the rocker, the lens will zoom either in or out.
While pressing the rocker down, roll the knob with your index finger counterclockwise to variably speed up and clockwise to variably decrease speed (see
picture at right).
Manual Focus: To utilize the VZ-PG-L’s focus feature, put your camera
in manual focus mode (consult camcorder instructions). The two buttons are
located above the zoom rocker switch on the VZ-PG-L and will control manual
focus functions on all compatible cameras. One button pushes the focal plane
farther away and the other brings the focal plane closer to the camera.
Canon XL1/XL2/GL1/GL2 users note: the manual focus buttons are disabled
while shooting in Green Box (full auto) mode, even if the lens switch is set to
manual.
ON/OFF: The recessed red button on the control will power up camcorders
that have gone into auto standby mode. If the camera should go into standby
mode, pressing this button will bring it back to full operating mode.
If you wish to intentionally put the camera into standby mode, press the button
and hold it in for 2 seconds (press it again to power it up).
Warranty Warning! Do not open your control device – this may void your warranty and possibly damage the control. If you
need service, contact Varizoom for a Return Merchandise Authorization number (RMA #). Our controls have a 2-year parts and labor
warranty. Please save your receipt and send us your comments and suggestions. Thanks!
-- please keep this document for your records & reference --
www.varizoom.com
Loading...