
Navigator can also be upgraded to a full professional
system by adding a GT sled in place of the FlowPod or
GlideCam® handheld units.
NAVIGATOR
Stabilizing Arm/Vest Manual
Thank you for purchasing the Navigator. Please read the
instruction manual thoroughly before operating it for the first
time.
The Navigator was designed to transform your FlowPod or
Glidecam® 2000/4000 handheld stabilizer into a fully
supported system.
Although it is fairly easy to set up the Navigator, you must
know how to use the handheld stabilizer before you get
started, so read the instructions for the handheld unit first, if
necessary. Operating the full system smoothly will require
practice.
Included with your Navigator are the Arm, Vest, and
Glidecam® adapter post with screw and washer for
attaching the post to the arm or for directly attaching the
FlowPod to the arm.

Page 2
The Vest
The purpose of the vest is to comfortably distribute the
weight of the camera and stabilizing system on your body.
To achieve optimal results, you should adjust the vest so
that it fits snugly.
Adjust the vertical fit by
adjusting the straps, pulling
the chrome release pin and
sliding the chest plate up or
down until you find the right
position.
Adjust the tightness of the
vest around your waist/hips
using the Velcro strap,
drawing it around evenly on
both sides of the lower vest
pad.
Adjust the tightness around your torso by positioning the
Velcro straps across the back of the vest and securing the
buckles to the chest plate. Make the vest as tight as
possible to maximize operational quality and comfort. Once
you’ve adjusted the vest, remove it for easy re-suiting by
unclipping the buckles & strap on one side only.
Page 7
Operation Notes
Generally speaking, you have to keep in mind that the
stabilizer will not work like a magic wand and instantly
transform your shots into brilliant footage. Operator skill is
critical, and it takes many hours of practice to master this
device, but the reward for all the practice will be substantial.
Here are a few simple quick-start guidelines:
-Controlling the orientation of the sled is essential, so
grasp the sled at the optimal control point - on the
knurled grip just below the gimbal.
-Hold the grip lightly with only your fingertips – do not
grab it like a handlebar. A soft touch is essential.
-Practice good posture and hold the sled fairly close
to your body to minimize the leverage on your back.
-The way you walk will affect the quality of
stabilization, so you’lll need to develop a light-footed
rhythmic pattern, and you may find that a sideways
step works better.
-Practice before attempting to acquire usable
footage.
-Seriously: practice, practice, practice.