www.cvc.de
Thanks for purchasing a Solo Slider Dolly from VariZoom. This lightweight track dolly is very
easy to set up and use, but because it is rolling camera support, you must exercise caution
when operating the Solo Slider Dolly. Without proper setup and operation, damage to the
equipment and/or injury to the user and people around the equipment may occur.
1) Never set up the dolly track on ground that is not flat and level.
2) Always make sure the tripod feet are securely mounted within the dolly foot locks.
3) Do not walk on the track, keep the track clear of obstructions, and take care not to
run the dolly off the end of the track
4) If a jib is mounted to the Solo Slider Dolly, take extra precautions to ensure that the
system does not strike any people or objects in the vicinity.
If you have any questions or concerns about using and operating your Solo Slider Dolly,
please contact info@varizoom.com or call 512-219-7722.
Included items:
10 pcs Track
10 pcs Underpad
2 pcs crossmembers
Folding Dolly
3 pcs claw-foot adapters
Extra set of rubber wheel
liners
Shoulder strap
Hex key
Case
http://www.youtube.com/watch?v=M6dRv1vBr7g#t=52
Watch the Video Here:
Step 1 – Setting up the Track
www.cvc.de
1) Start by connecting the first 2 track pieces with one of the crossmembers.
2) Now add the underpads below the 2 track pieces. Continue adding track pieces and
underpads until you have the desired length.
3) Connect the final 2 track pieces with the second crossmember.
Step 2 – Setting up the Dolly
Unfold the dolly and lock it in place using the
knob at the center where the legs come
together.
Depending on the tripod, you may have to
adjust the position of the foot locks by
loosening the slide lock knobs.
Now you can place the dolly onto the track. If
the width of the track seems slightly off, you can
adjust the position of the clamps on the ends of
the crossmembers using the supplied hex key.
The clamps can move in or out slightly, thereby
adjusting the width of the track.
Loading...