
Executive Task Chair
2 People
Recommended
Holds up to
275 lb (124.7 kg)
Patent and trademark informaon: vari.com/patents
©2022 Varidesk, LLC All rights reserved.

Chair Assembly
1
2
Align the back of the chair with the steel plate aached to the seat. Using the washers
and hex screws provided, fasten the plate to the back of the chair with the Allen key.
Remove the air piston and base from the packaging. Insert the piston into the base with
the large end down, as shown.

3
With assistance, ip the chair assembly onto the base assembly, lining up the hole with
the top of the piston. Using even pressure, press rmly on the seat cushion a few
mes to ensure the seat is fully engaged with the piston.
NOTE: Once assembled, do not aempt to disassemble the chair, as doing so may
damage the product.

4
Align the holes on the headrest with the holes on the back of the chair. Use the
provided Allen Key and Screws to secure the headrest. Once fastened, align and rmly
push the cover piece into place.

Chair Adjustments
To adjust the headrest’s height, gently
pull up to raise and push down to
lowe r.
To adjust the seat height, engage the
back lever under the right side of the
seat, and adjust the seat height to the
desired seng.
To allow the chair backrest to recline,
slide the back lever under the right side
of the seat out. To prevent the backrest
from reclining, push the lever in.
To adjust how easily the chair back reclines,
turn the knob under the front of the seat
clockwise to increase tension and counterclockwise to decrease tension.

To angle the armrests or slide
armrests from front to back,
push armrests accordingly.
To adjust the posion of the seat cushion,
engage the front lever under the right side
of the seat, then slide the seat forward or
backward into the desired posion.
To adjust the arm height, press
the buon under the armrest
and pull up or push down on the
armrest.

WARNING: To prevent injuries and product failure, do not use this chair for standing,
climbing, or leaning. Do not use if the chair is damaged or incorrectly assembled.
(800) 207-2587