vaperiza LF700, LF1500 Product User Manual

Page 1
LF700
LF1500
PRODUCT USER MANUAL
TECHNICAL SECIFICATIONS
LF700
Smoke
Output
7000cu.ft
per minute
Warm Up
Time
4.5
Minutes
Tank
Capacity
0.5
Liters
Power
Consumption
900
Watt
Power Supply
110V
240V
Unit
Dimensions
LF1500
12000cu.ft per minute
4.5
Minutes
2.5
Liters
1500
Watt 110V 240V
Page 2
CAUTION!
Keep this device away from rain and moisture Unplug Mains lead before opening the housing Make sure of the voltage on your end in suitable for the unit
For your own safety, please read this user manual carefull
y before you initially start
Any person involved with the installation, operation and maintenance of this device
has to - Be qualified
- Follow the instructions in this manual
1. INTRODUCTION
Thank you for having chosen the AVE Vaperiza range. You will see you have
acquired a powerful and versatile device. Unpack your item. Before you initial
start-
up, please make sure that there is no damage caused by transportation.
Should there be any,
please consult your dealer and do not attempt to use the
device.
2. SAFTEY INSTRUCTIONS
If the device has been exposed to drastic temperature fluctuation (e.g. after
transportation), do not switch it on immediately. The arising condensation
water might damag
e your device. Leave device switched off until it has
reached room temperature. Always plug in the power plug last. Make sure
that the power-
switch is set to the OFF position before you connect the
device to the mains. Never let the power-cord come into co
ntact with other
cables. Handle the power-
cord and all connections with the mains with
particular caution. Make sure that the available voltage is not higher then
stated on the rear panel. Make sure that the power-
cord is never crimped or
damaged by sharp edges. Check the device and the power-
cord from time to
time. CAUTION! Before filling the machine disconnect from mains. Never drink
fluid or use it on the inside or outside of a human body. If fluid gets in contact
with skin or eyes, rinse thoroughly with
water. If it is necessary call a doctor
immediately DANGER OF EXPLOSION! Never add flammable liquids of any
kind to the fog liquid. Keep minimum distance of 50cm to nozzle. Always
disconnect from mains, when the device is not in use or before cleaning it.
Only handle the power-
cord by the plug. Never pull out the plug By tugging
the power-
cord. Keep away children and amateurs. Never leave this device
running unattended
3. STARTING OPERATION
Place the machi
ne on a level surface and remove the cap of the flu
fill with high quality fog liquid
the fluid tank.
Loose the nut on top cover to open the top cover, fill the ice
container with some ice cubes
Firmly insert the remote control plug into the socket on the rear of the
m
achine. Ensure the power switch located a
plug the power cord into a 3
-
the machine's rated voltage. Tum on the power switch
remote control will be "on". Al
minutes. When the warm-
up is complete the red lamp will be "off", that
means the ice low fog machine is ready to emit low fog.
To emit low fog, press the rem
length of ti
me. The machinemay need to reheat after an extended discharge
of fog. Note: The red lamp on the remote control willcycle on and off as the
machine reheats to its operating temperature. When not use the machine
please tum off the power switch, unplug the po
thenopen the top cover to clear the surplus ice cubes from the ice container
and drain the water which the ice cubes dissolved
CLEANING THE MACHINE
Cleaning your machine regularly will help reduce costly parts replacement and repai
charges. After every 40 hours of contin
for a long time it is recommended to run a cleaning solution composed of distilled
water through the system to prevent the accumulation of particles.
PROCEDURE:
While unit i
s unplugged, clean with mild soap and water. Allow sock to dry completely
before reattaching to unit. Empty all fog fluid from the machine and replace with
distilled water in the tank. Plug unit in and allow machine to run as usual. Run unit in a
well-
ventilated area until tank is empty. Replace clean sock. Cleaning is now complete
Unplug and store it in dry place. Remember
years of reliable use. The body of the unit may be cleaned with a dry cloth. Store dr
PLEASE NOTE:
All information is subject to change without prior notice.
PRODUCT USER MANUAL
id tank to
, when the tank is full, replace the cap back onto
, then cover the top cover and tighten the nut.
t rear of the machine is "OFF"
prong, grounded electrical outlet consistent with
, the red lamp on the
low the machine to warm-up about 4 - 5
wer cord from the main,
r
.
, a well maintained machine should provide
y.
Loading...