VANCO 280726 User Manual

HOME

THEATER

HDMI® HDBaseT

Extender

Vanco Part Number:

280726

Technical Support

www.vanco1.com • [e-mail] • 800-626-6445

DEAR CUSTOMER

Thank you for purchasing this product.
For optimum performance and safety, please
read these instructions carefully before
connecting, operating or adjusting this product.
Please keep this manual for future reference.

This product is 100% inspected and tested in the United States
to verify HDMI performance parameters.

WARNING

1. Do not expose this unit to water, moisture,
or excessive humidity.

2. Do not install or place this unit in a built-in
cabinet, or other conned space without
adequate ventilation.

3. To prevent risk of electrical shock or re
hazard, due to overheating, do not obstruct
unit’s ventilation openings.

4. Do not install near any source of heat,
including other units that may produce heat.

5. Do not place unit near ames.

6. Only clean unit with a dry cloth.

7. Unplug unit during lightening storms, or
when not used for an extended period
of time. A surge protector is strongly
recommended.

8. Protect the power cord from being walked
on or pinched, particularly at the plugs.

9. Use unit only with accessories specied by
the manufacturer.

10. Refer all servicing to qualied personnel.

CAUTION

HDMI is a very complex technology requiring continuous authentication of the signal and the same
video resolution and audio settings on all electronic equipment in the system. When there are multiple
sources and displays, the video resolution and audio setting on all connected units must be adjusted
to correspond with that of the display having the lowest video and audio capability.

Please note that in an indoor environment, the radio frequency signal bounces off the walls, oors
and ceiling and may be diminished in strength when passing through interior walls. Also, in congested
areas it is also possible to get interference from other signals operating in the 5 GHz band.
Sometimes, the transmitter or receiver units may need to be moved slightly to optimize performance
if the current location is in an area where reected radio signals may be cancelling each other out.

2

www.vanco1.com

FEATURES

Vanco’s HDBaseT Extender consists of a transmitter and a receiver, which can support up to a 100 meter
distance (328 ft) between the transmitter and the receiver by utilizing a single Cat 5e or Cat 6 UTP cable.
This extender includes an IR system which allows for IR control of the source from the display. The extender
supports HDMI 1080p and 3-D signals, 24 bit/36 bit deep color and various audio formats including Dolby.

The HD Base T technology utilized allows the HDMI audio and video signals to travel over a single Cat 5e or
Cat 6 UTP cable from the transmitter to the receiver. The UTP also transports the IR control commands from
the display to the source and a 100 Mb/s Ethernet signal.

This HDMI Extender offers a comprehensive solution for extending the reach in a digital entertainment
center, HDTV retail or show site installation, STB, DVD and projector delivery. It effectively addresses noise,
space and security concerns and facilitates data center control, information distribution, conference room
presentations and supports school and corporate training environments.

More information on HD Base T technology can be provided by the HD Base T Alliance at www.hdbaset.org.
This technology supports HD video, audio, Ethernet, power and a broad range of control capabilities.

HDMI® HDBaseT Extender

Part # 280726

• Features HDBaseT Technology, optimized for
whole-home or commercial distribution of
uncompressed high-denition signals at three
times the distance of HDMI cables without
degradation

• HDBaseT can connect uncompressed full
HD digital video, audio, 100BaseT Ethernet,
and various control signals through a single
100m/328ft CAT5e/6 cable with RJ45
connectors

• Transmission Range: Extends 1080p
resolutions up 328 ft over a single Cat 5e or
Cat 6 cable

• Reading and saving EDID function from displays

• HDBaseT Technology that supports 3D and 4K

x 2K

• Uncompressed video/audio up to 10.2 Gbps

• FullHD1080P/ 120Hz

• HDCP compliant

800-626-6445

• Supports Digital Audio Format, DTS-HD/Dolby­True HD/LPCM7.1/AC3/DTS/DSD

• Supports Standard IR, includes 1 IR TX and 1
IR RX

• Tested for Compatibility with all leading HD
Video brands

• Tested with 7.1 Home Theater Systems

• 2 5V DC Power Supplies

• Dimensions for TX and RX: 4.4” W x .9” H x

3” D

3