
Ruby Air – True Wireless
Earbuds (BTi41)
Thank you for purchasing the Valore Ruby Air – True Wireless Earbuds (BTi41).
• Touch control for easier music/call switch
• Store wireless earbuds in a protective case while it recharges
• Charging case can be charged using Micro USB cable or wireless charger
• Enjoy HD stereo music and clear calls with high sensitivity microphone without worrying
about tangled cables
Important: Please read the user manual thoroughly before using your wireless earbuds.
Specifications: Package Contents:
• Wireless range: 10M
• Earbuds battery type: Built-in 45mAh lithium battery
• Charging case battery type: Built-in 500mAh lithium
battery (Charge earbuds
up to 5 times)
• Earbuds charging time: Approximately 1 hour
• Charging case charging time: Approximately 3.5 hours
• Playback time: Up to 4 hours
• Standby time: Up to 100 hours
• Support: HSP/SFP/A2DP/AVRCP
• Power input: DC5V/1A
UNDERSTANDING THE PRODUCT
• True wireless earbuds x 1 pair
• Charging case x 1
• Micro USB charging cable
(300mm) x 1
• Silicone ear tips x 3 pairs
• Rubber cover for earbuds x 2 pairs

START USING THE WIRELESS EARBUDS
1) Charging
* When battery is low, earbuds will emit
a low battery tone while the red indicator
flashes quickly.
a) Put the earbuds into the charging case. When charging the indicator is red. When fully
charged, it will be off. The green light of the charging case will be on when charging, off when
fully charged.
b) Plug micro USB cable to the charging case to charge. When charging, the white indicator
on top will flash once every 2 seconds. Indicator will stay light up when fully charged.
Charging case can also be charged using a wireless charging pad.
2) Pairing both wireless earbuds (switched off)
Earbuds will connect to each other automatically. Otherwise, click the touch surface for 3
seconds to switch on manually. The master earbud’s indicator will flicker red and blue.
Step 1: Activate Bluetooth function on your mobile device to begin pairing with earbuds.
Step 2: Remove earbuds from charging dock and wait for “left/right channel” voice prompt.
Step 3: Connect to the earbuds by selecting ‘Valore BTi41 under the device list.
Step 4: Once connected, there will be a pairing voice prompt.
Power on: Remove earbuds from charging case, it will turn on automatically. Otherwise, click the touch surface
for 3 seconds to switch on manually.
Power off: Put earbuds back into charging case to power off automatically. Otherwise, click the touch surface
for 5 seconds to switch off manually.
If the pairing is not successful, please turn off wireless earbuds first, and then re-pair again. After pairing is
successful, paired devices will remember each other. Unless pairing information is deleted because of new
pairing, no need to pair when using the next time.
If you want to pair the wireless earbuds with other devices, please turn off Bluetooth function of existing source
device, and pair the wireless earbuds with the new device according to steps 1-4 mentioned above.