OPERATION MANUAL
GV34
GV34 Remote Control
used on Valor heaters 738, 739-72 and RF24B
Connect Remote Control Receiver
1. Connect the wiring harness to the receiver box,
by pushing the wire connector on to the receiver
circuit board. The plug will only go on one way so
please ensure that the wires are pointing up and
the slot in the board is in line with the tab on the
wiring harness plug.
2. Connect the wires as shown. Please note that the
“L” connectors are diff erent sizes; the smaller one
fi ts to the lower connection and the larger one the
top connection on the top left hand side of the
valve. The other two wire connectors can be fi tted
to either terminal located to the left of the fl ame
control button.
3. Remove the remote control receiver lid.
4. Fit four AA 1.5 V alkaline batteries. Refi t the lid.
5. Place the remote control receiver on the base of
the fi replace beside the valve.
6. Fit the 9 V alkaline battery to the handset
transmitter.
Remote control operating instructions are on
following pages of this manual and are supplied
with the remote control kit.
CAUTION
DO NOT PUT BATTERIES IN THE REMOTE
CONTROL RECEIVER until the wires
are connected to the burner control
unit as short-circuit could result in the
destruction of the electrical components.
CAUTION
DO NOT USE a screwdriver or other metallic object to
remove the batteries from the receiver or the handset!
This could cause a short circuit to the receiver.
September 2018
Push-on Connector
Push-on
Connector
GV34 ValveReceiver
1
Remote Control Operation
Your fi replace remote control helps you get the comfort, convenience and
aesthetics you want from your gas fi replace. The remote controls your fi replace
in diff erent ways.
IMPORTANT: BEFORE YOU BEGIN, please note that on this system, the
settings of time, temperature and automatic ON/OFF can only be programmed
when the function display is fl ashing. Be patient when programming as it can
take a few seconds to set.
Setting the time
The fi rst thing to do is to set the time.
1. With your thumb, hold down both the AUTO and TIMER buttons until F fl ashes.
Let go.
2. Note the digital clock on the bottom right hand corner. The ▲ button sets the
hour; the ▼ button sets the minutes. Set the time.
Note: You must start setting the time while the F is fl ashing. If it stops fl ashing,
go back to 1.
3. The display shows °C/24-hour or °F/12-hour. To change the temperature/hour
display, press on the AUTO button while the display fl ashes.
4. Let go and wait until the fl ashing stops. The remote shows the time you set. It
also shows the current temperature.
Setting the temperature
Use this setting when you come in and want to enjoy a specifi c temperature.
1. Push the AUTO button until a number and F fl ash. Let go.
2. While it is still fl ashing, push the ▲ and ▼ buttons to the temperature you want.
Let go.
Your fi replace will reach that temperature and the remote will check the temperature
every fi ve minutes, adjusting the amount of fuel needed to give you a steady, even heat.
Setting the fl ame
Use this setting when you want a particular fl ame level. For instance, you want to
watch fl ames burn at their highest level and you don’t mind if the room is too hot.
1. To raise the fl ame, press and hold the ▲ button until the flame gets to the
desired level. Let go.
2. To lower the fl ame, press and hold the ▼ button until the fl ame gets to the
desired level. Let go.
The fl ame level will remain just as you set it.
2
Loading...