Valor LEGEND G3.5, 709FTZ, 709FTV, 709FTP, 709FTB Installation Instructions Manual

LEGEND G3.5

709 Floating Trim Kit

Use with Valor 700 Models only

Installation Instructions

!

WARNING

HOT GLASS WILL

CAUSE BURNS.

DO NOT TOUCH GLASS

UNTIL COOLED.

NEVER ALLOW CHILDREN

TO TOUCH GLASS.

INSTALLER

Leave this manual

with the appliance.

CONSUMER

Retain this manual

for future reference.

A barrier designed to reduce the risk of burns from the hot viewing
glass is provided with this appliance and shall be installed
for the protection of children and other at-risk individuals.

The 709 Floating trim is intended to be used on Valor heater model 700. Mounting of the 709 does not affect
clearances or other specifi cations listed in the heater installation manuals—see installation manual supplied with the
heater for more information.

Compatible with

• 710 Backing plate (37-3/4” w x 26-7/8” h)

• 714 Backing plate (42” w x 29” h)

700 engine

33-3/4” (857 mm)

coverage

Overall trim slightly larger

4003400-04
© Copyright Miles Industries Ltd., 2013

coverage

23-5/8” (682 mm)

Overview

Installation

TOP of door:
this space is
wider

TOP of door:
notch in the
rear ange

Left door panel

BOTTOM of door:
this space is
narrower

Rear viewFront view

1. Identify the left and right panels using the image
below.

2. Identify the top and bottom of the left panel. The
notch in the rear fl ange of the panel is at the top.
The space between the rear fl ange and the edge of
the panel is wider at the top than at the bottom of
the panel as shown below.

6. Hook the barrier screen to the back of the front.
Orient the screen so its tabs are on the back.

Note: The barrier screen, when hooked to the
trim, protrudes slightly in front
of the trim.

Screen tabs at
the back

3. Insert the top pin of the left panel in the hole at
the top of the left shroud already installed on the
appliance.

4. Lift the panel as far as possible and insert the
bottom pin in the hole at the bottom of the shroud.
The panel should rotate freely.

5. Install the right panel the same way.

Rear View

7. Hook the front trim with the barrier screen to the
appliance’s shrouds.

2