Valor 1470RGL Installation Instructions Manual
H6 SERIES
1470RGL Refl ective Glass Liner Set
For use with Valor H6 models 1400 Fireplaces ONLY
Installation Instructions
Kit Content
• 4005376—LH glass panel
• 4004824—Top ceramic panel
• 4004982—Rear glass panel
• 4005375—RH glass panel
• 4004712AH—Rear spacer (2)
• 4004711AH—Side spacers (10)
Unpack all cartons carefully, with special care for the
glass panels.
To achieve the intended effect, the panels should be
installed so the smooth side is visible.
2
Note: This kit must be installed or serviced
by a qualifi ed installer, service agency or
gas supplier. These instructions are to be
used in conjunction with the main installation
instructions for the above listed models.
WARNING: If these instructions are not
followed exactly, a fi re or explosion may
result causing property damage, personal
injury or loss of life.
Top panel
2
LH glass panel
4005377-01
© 2015, Miles Industries Ltd. All rights reserved.
Rear glass panel
2 3
Side
spacers
22
Rear
spacer
33
22
RH glass panel
2 22 2
1
Installation of glass panels
1. Inside the fi rebox, on the top of each side, release
the screw of the side panel anchors if necessary so
they can rotate freely (one per side).
2. Fit two rear spacers on the top edge of the rear
glass panel orienting the spacer as shown.
3. Fit two side spacers at the bottom of the rear
panel orienting the clip on the front of the panel as
shown.
5. Fit one spacer on the angled part of the left hand
side panel towards the rear and one spacer at the
top on the square part of the panel.
6. Fit two spacers at the bottom
of the left hand side panel
orienting the clip on the front
of the panel as shown.
Left side glass panel
smooth side
visible
Rear glass panel
smooth side visible
4. Place the rear glass panel, smooth side visible, up
against the rear of the fi rebox.
Front view
shows clips
Rear view of
spacers
7. Rotate the left anchor up and out of the way and
slide the side panel against the fi rebox left side.
Rotate the anchor back down to hold the panel.
8. Tighten the side panel anchor.
2
Loading...