Valor 1435 Installation Instructions Manual

H6 SERIES

1435 Three-sided Trim Kit

Use with Valor 1400 Models only

Installation Instructions

!

A barrier designed to reduce the risk of burns from the hot
viewing glass is provided with this appliance and shall be
installed for the protection of children and other at-risk
individuals.

The 1435 trim is intended to be used on Valor heaters
models 1400. Mounting of the 1435 does not affect
clearances or other specifi cations listed in the heater
installation manuals—see installation manual supplied
with the heater for more information.

DANGER

HOT GLASS WILL

CAUSE BURNS.

DO NOT TOUCH GLASS

UNTIL COOLED.

NEVER ALLOW CHILDREN

TO TOUCH GLASS.

Note: Mounting of this trim allows for non-combustible
material up to 3/4” (19 mm) thick installed over top of
the required 1/2” (13 mm) cement board. For thicker
fi nishes, refer to appliance manual.

46-1/4” (1175 mm)

INSTALLER

Leave this manual

with the appliance.

CONSUMER

Retain this manual

for future reference.

1400 engine

4005086-02

© Copyright Miles Industries Ltd., 2016

Linerbox bracket

36-3/4” (933.3 mm)

Overview

LH door

RH door

Removable panel

Trim assembly

Barrier screen

Installation

1. On completion of fi replace installation, screw the
linerbox bracket to top face of fi rebox with 4 screws.

2. Carefully position and secure steel front panel with
4 low profi le screws to 4 fi rebox mounting brackets.
Before tightening, hold panel up against wall fi nish
then tighten.

3. Slide the removable panel in the clip on the
horizontal supports on each side and push it in until
fl ush with the front trim.

4. Identify left hand door from right using diagram
below.

RH door has a
slot in upper
locator tab

LH Door RH Door

nger grip inboard,
with locator on left

nger grip inboard,
with locator on right

5. Position LH door to left side of front panel, identify
door slots top and bottom just behind front panel
and slide door locator in position.

2

6. Repeat for other door.