Valor 1335MTP, 1335MTB Installation Instructions Manual

VOGUE

1335 Three-Sided Trim Kit

for use with the Valor 1300 Vogue  replace only

Installation Instructions

39-3/4” (1010 mm)

Important information

The Three-Sided Trim kit 1335 is intended to be

installed on the Valor Vogue 1300  replaces  tted

with a hearth.

See the details about framing and hearth
requirements in the 1300 Vogue’s installation
manual.

1335
Three-Sided
Trim Kit

25” (554 mm)

Overview

Three-Sided Frame

1300 Vogue with

wall  nish around
perimeter

4001688-03

© Copyright Miles Industries Ltd. 2009. All rights reserved.

Overlay

Kit Content

Access Doors

Window
Skirt

1

Installation

1. Fit the three-sided trim to the replace and x it to
replace with 4 screws provided.

2. Install the overlay, rst sliding it in the clips under
the rebox, and then xing it to the appliance’s
opening anges through the three-sided frame
with two screws.

4. Sort the left hand side and the right hand side

access doors—the tab to open the door should be

at the bottom.

Take one door and insert the top hinge pin in the
holed bracket located inside the top front of the
outer appliance’s liner.
Slide the door up as much as possible and t the
lower hinge pin in the bottom hole.

5. Repeat with the other door.

The doors should be maintained closed by a magnet
on each side of the window frame.

3. Hook the window skirt to the edge of the window
frame.

2

Section View