Valor 1149 Edgemont Double Doors Installation Manual

INSTALLATION MANUAL

H5 Series

1149 Edgemont Double Doors

Use with Valor 1100 & 1150 Models only

!

A barrier designed to reduce the risk of burns from the hot
viewing glass is provided with this appliance and shall be
installed for the protection of children and other at-risk
individuals.

The 1149 Edgemont Double Doors are intended to be
used on Valor heaters models 1100 & 1150. Mounting
of the 1149 does not aff ect framing clearances or other
specifi cations listed in the heater installation manuals—
see installation manual supplied with the heater for
more information.

DANGER

HOT GLASS WILL

CAUSE BURNS.

DO NOT TOUCH GLASS

UNTIL COOLED.

NEVER ALLOW CHILDREN

TO TOUCH GLASS.

Note: Mounting of this trim allows for non-combustible
material up to 3/4” (19 mm) thick installed over top of
the required 1/2” (13 mm) cement board. For thicker
fi nishes, refer to appliance manual.

INSTALLER

Leave this manual
with the appliance.

CONSUMER

Retain this manual
for future reference.

41-7/8” (1063 mm)

33-5/8” (855 mm)

Base of appliance fl ush with hearth surface

4004403-06

© Copyright Miles Industries Ltd., 2018

2-3/8” (61 mm)
from convection
bae to top of
backing plate

34-1/4” (870 mm)

27-3/4” (706 mm)

1100 or 1150 engine

1149 Edgemont
Double Doors

Overview

Installation

1. On completion of fi replace installation, install the
“V” shaped convection baffl e to the top of the
appliance as shown (3 screws).

2. Install the door catch bracket to the bottom of
the backing plate (2 screws). You can add some
washers (supplied) to shim the door catch if it is too
low and the door is too easy to open.

4. Slide the removable panel in the clip on the hori­zontal supports on each side and push it in until
fl ush with the backing plate.

3. Carefully position and secure backing plate with 4
low profi le screws to 4 fi rebox mounting brackets.
Before tightening, push the plate against the wall
fi nish then tighten.

5. Adjust the position of the convection brackets on
each side of the window. Release the nut, pull the
bracket as forward as possible and tighten the nut.

2