Valor H3 Series, 1040BPB Installation Manual

INSTALLATION MANUAL

H3 Series

1040BPB Four-sided Backing Plate Kit

CSA approved for use with Valor H3 1000 Heater Models
in New Construction/Zero Clearance applications

INSTALLER: Leave this manual with the appliance.
CONSUMER: Retain this manual for future reference.

The 1040BPB backing plate is intended to be used on Valor heaters models H3 1000 in new construction
applications/zero clearance. Refer to installation manual supplied with appliance for clearances to combustible
and other specifi cations when using the 1040BPB “New Construction” Backing Plate.

The 1040BPB needs to be fi tted with with a Four-Sided Front 1041FSV or 1041FSCB to complete the installation.

Note: When mounting over top of the wall finish, this trim allows for non-combustible material up to
maximum 3/4” (19 mm) thickness installed over top of the required 1/2” (13 mm) cement board. Otherwise,
run non-combustible finish to outer edge of backing plate.

Left hand door

Left hand door

H3 1000

Backing plate

Backing plate

assembly

assembly

30-9/16” [776 mm]

30-13/16” [783 mm]

from bottom of plate

from bottom of appliance

40” [1016 mm]

Backing plate 1/4” [7 mm] below bottom of appliance

4007391-01

© Copyright Miles Industries Ltd., 2019

Removable

Removeable
bottom plate

bottom plate

Overview

Right hand

Right hand

door

door

1

Installation

1. On completion of appliance installation and wall
fi nish application, insert the backing plate assembly
into the liner box, and attach it using 4 screws into
the left and right sides.

2. Slide the removable bottom plate into the clips in
the side panels.

Note that the fi xing points are slotted, allowing for
variable depth of wall fi nish.

3. Install the left hand side door.

a. Insert the left hand door tabs straight into

the top and bottom slots behind the front
panel of the plate.

b. Slide the door down to secure it.

a

b

2

4. Repeat with right hand door.