Page 1
Operating instructions for: VIPER
Chair height: To raise the chair, lift body weight off of the chair while lifting the lever under the right
side of the sea. To lower the chair, sit in seat while raising the same lever until desired
heath is reached then let go.
Recline angle: To recline the chair, push the lever under the left side of the seat forward to unlock the
chair while leaning backwards. At desired position, push the lever forward until the chair
clicks into the locked position.
Note: when unlocking the chair in a reclined position, the chair will not automatically
spring forward. As a safety measure, the user must lean back to unlock the backrest and
then it will follow the user forward.
Recline tension: The tension of the spring which regulates the recline motion may be adjusted for differ-
ent body weights. To adjust the tension, turn the hand-knob under the front of the chair
clockwise to increase tension or counterclockwise to decrease tension.
Armrest height: To adjust the height of the armrests, push the lever located at the bottom rear of the
armrest outward to unlock the armrest. Raise or lower the armrests to the desired position and then push the le
ver back in until it clicks into locked position.
Lumbar: Reach behind the backrest with both hands to slide the lumbar pad up and down to
desired position.
Headrest (optional): To adjust the height of the headrest, push in the pushbutton located on the right side of
the headrest and move the headrest up or down to desired height. To adjust the angle of
ed position.
1186
Facsimile 800-
20-3844
2
300 Myrtle Av
Web Site www
enue, Boont
.dauphin.
c
the headr
on, NJ 0
om
My Valo www
est, piv
7005
ot the fr
Telephone 800-631-
.m
yv
alo
ame t
om
c
.
o desir
Loading...